輔潤滑油泵的英文怎麼說

中文拼音 [rùnyóubèng]
輔潤滑油泵英文
auxiliary lubricating oil pump

  • : Ⅰ動詞(輔助) assist; complement; help Ⅱ形容詞(輔助) subsidiary Ⅲ名詞1 (車輪外旁增縛夾轂的兩條...
  • : Ⅰ形容詞(細膩光滑; 滋潤) moist; smooth; sleek Ⅱ動詞1 (加油或水 使不幹枯) moisten; lubricate 2 ...
  • : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 名詞(吸入和排出流體的機械) pump
  • 潤滑油: lube; lubricating oil; lubricant oil; lubrication oil; lube oil
  • 潤滑: [機械工程] lubricating; lubrication; lubricate

※中文詞彙輔潤滑油泵在字典百科國語字典中的解釋。

  1. Petroleum, petrochemical and natural gas industries - lubrification, shaft - sealing and control - oil systems and auxiliaries - part 4 : self - acting gas seal support systems

    化學和天然氣工業.封控系統和助裝置.第4部分:自動氣封支撐系統
  2. Through the statistic analysis on the change of the melt gear pump working condition pre - and post - pet plant capacity increasing and concatenate direct spinning process, the reasons for the unsteady running were studied, the modification measures such as lubricating the oil groove with sliding bearing, mechanical sealing of the gear pump, decreasing the gear pump outlet pressure, changing the automatic speed increasing to hand speed increasing were put forward

    摘要通過對聚酯裝置增容和後接直紡長絲前後熔體齒輪工況變化的統計分析,研究其運行不穩定的原因,提出改造措施,包括動軸承槽,齒輪的機械密封,降低齒輪出口壓力,改自動提速為手動提速等等。
  3. The mainly works had been done as follows : 1. in order to keep commonality, the modules who have similar thermodynamic process had been classed. such as evaporating module ( including furnace, drum, system of boiler recycled water ), single - phase heat exchange module ( including superheater, reheater, ecomomizer ), lubricating oil system module ( can be used for any lubricating oil system of rotation mechanical impedance ), pump and fan module, ect

    本文所作的主要工作如下: 1 、為保證模塊的通用性,對鍋爐有相似熱力環節的模塊進行分類,建立模塊庫,便於模塊調用,如蒸發區模塊(包括爐膛、汽包和爐水循環系統) ,單相換熱模塊(包括過熱器,再熱器,省煤器等) ,系統模塊(可用於各種轉機軸承的動態特性的計算) ,與風機的動態計算模塊等。
  4. Firstly it spares a large amount of lubricants and reduces the expenses of 1, 000 yuan for a single pump per year. indiect economic loss of unplaned shutdown caused by nonclearence between bearings and the shafts are accoridingly reduced

    首先是節約了大量,單臺損耗每年可減少1000元左右,同時也減少了抱軸次數和影響整個裝置循環或非計劃停車所造成的間接經濟損失。
  5. Turbo - charger lubricating oil pump

    渦輪增壓器
分享友人