輸入幀狀態 的英文怎麼說

中文拼音 [shūzhèngzhuàngtài]
輸入幀狀態 英文
if in flame state
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • : Ⅰ動詞1 (進來或進去) enter 2 (參加) join; be admitted into; become a member of 3 (合乎) conf...
  • : 量詞(幅, 用於字畫)
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 名詞1. (形狀; 狀態) form; condition; appearance 2. [物理學] (物質結構的狀態或階段) state 3. [語言學] (一種語法范疇) voice
  • 輸入 : 1 (從外部送到內部) import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  • 狀態 : status; state; condition; state of affairs: (病的)危險狀態 critical condition; 戰爭狀態 state o...
  1. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影( dsa )成像系統的組成結構和數據流向進行了深研究和分析,並對系統中的數據流向進行了完整的歸納和總結,給出了x線數字成像系統中的高速大容量數據通道的設計方案;在對sdram的控制方式做了深探討后,給出了實現大容量多條sdram共同工作的解決方案,在此基礎上設計了大容量存板實現對圖象數據進行高速存儲;通過對pci總線介面的深研究,優化後端機設計和低層驅動程序開發,給出了完整的pci介面方案實現高速dma數據傳,完全可以滿足視頻傳要求;深研究了基於大規模可編程器件的數字系統設計方法,針對通用fifo使能信號漂移、出數據難于建立和保持等設計難點,提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案,從而實現利用fifo來協調系統各模塊之間的數據高速傳
  2. Embedded technologies, multi - way technologies and sampling technologies are used to reduce the sampling rate by software, so that the system can provide appropriate image format according to the condition of network and can eliminate aliasing noise. the system also uses motion detection to control the frame rate. therefore, the system can save transmission bandwidth effectively and design to provide multiple degrees qos according to the network condition

    本方案採用了嵌式技術和多路技術,並從采樣技術手,軟體調整采樣率,使得系統能夠根據網路提供適當格式的圖像,消除欠采樣噪聲,而且通過運動檢測來控制率,從而可以有效地節省傳帶寬,達到根據網路情況自適應地提供多種qos服務等級的目的。
  3. This paper analyzed p - persistent csma / cd protocol and proposed a new adaptive algorithm for the adjustment of the coefficient p by real - time channel traffic sensing based on the feedback control theory, i. e., changing the value of p dynamically through the analysis of networks " flow to control the behavior of the stations sending data frames in the same collision domain, to keep the media channel in an optimal state and to enhance the channel transmission efficiency

    該演算法基於對網路流量的分析,在osi物理層通過通道信息量的在線實時檢測,根據反饋控制的原理,在數據鏈路層動地調整控制參數p ,從而控制站點發送分組數據的行為,使通道處于最佳的傳,提高通道的效率。
分享友人