輸出放大器 的英文怎麼說

中文拼音 [shūchūfàngdàqì]
輸出放大器 英文
out amplifier
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. Part of the output of an amplifier can be fed back to get rid of sound distortion.

    放大器部分輸出可以進行反饋以消除聲音的失真。
  2. A facsimile of the original amplifier outputs is then reconstructed inside the computer.

    一個放大器原來輸出的復製品就送到處理裝置中去。
  3. The system cybernation method is distributed control system. in this way, the audio process computer switch the signal between input and output channels. the main function of audio process computer is general broadcast, service broadcast and emergency broadcast. there is a special control computer. it " s main function is supervise - control the system status such as the amplifier and speaker circuit

    在控制上，採用了分散式控制方式，由語音計算機進行音源輸入和輸出的切換，執行業務性廣播、服務性廣播和火災事故緊急廣播；由控制計算機進行系統的監控，監視功率放大器和揚聲器迴路的工作狀態，並根據當前的設備狀態執行相應的控制任務。
  4. Again call the the ratio, namely the electric voltage of the enlarger s exportation signal with at the same time output s voice ratio for electric voltage, usually use the decibel number to mean. the equipments s letter the ratio is more our output of high enunciation is more little. by any large, letter the ratio is more big, and the elucidation is in the in the signal a the quantity for more smallly, voice returning putting is more high, otherwise contrary. letter the ratio should be generally not lower than 70 dbs, high the letter of the true box the ratio should attain 110 dbs are above

    又稱為訊噪比，即放大器的輸出信號的電壓與同時輸出的噪聲電壓的比，常常用分貝數表示。設備的信噪比越高表明它產生的雜音越少。一般來說，信噪比越大，說明混在信號里的噪聲越小，聲音回放的音質量越高，否則相反。
  5. If the node is at, or near to, ground then a grounded guard ring will be appropriate, if it is at some other potential it may be necessary to use a high input impedance buffer amplifier, with its input connected to the node, to force the guard ring to the node potential

    如果被保護的節點的電位是（或接近）零電位，採用地線保護環最為合適；如果節點電位是其他值，那麼可以用高輸入阻抗放大器組成緩沖器，輸入端連接該節點，輸出端連接保護環。
  6. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩器由寬帶放大器、可調衰減器和聲表面波質量傳感器件構成。延遲線振蕩器輸出信號經濾波后與109mhz的本機晶體振蕩器輸出信號相混頻，通過低通濾波取其差頻，並經整形後由數字信號處理電路處理。
  7. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整流管驅動電路主要面對多路輸出的主輸出電路，而應用磁放大器調節的輔助輸出電路同步整流管的驅動，現有的方法存在磁放大器調節與同步整流管驅動的失配，降低了開關電源的效率。
  8. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  9. The power ’ s quality is decided in the system performance, the amplifier has 4 groups ’ power sources, input 220v through the filter, the transformer transformation, the full - wave rectification, finally through manostat leveling off voltage, after the electric capacity filter outputs

    電源質量的好壞是決定系統性能的一個重要因素，放大器共4路電源，輸入220v通過型濾波，變壓器變壓，全波整流，最後通過三端穩壓器穩壓，電容濾波后輸出。
  10. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬帶放大器頻帶寬度的因素，通過分析mosfet的本徵參數、寄生參數對頻率特性的影響，提出了採用短溝器件、使mosfet工作在飽和區、抬高柵源電壓等提高mosfet特徵頻率的方法；分析了不同電路組態對放大器頻率特性的影響、節點電壓對電壓模電路、電流模電路頻率特性的不同影響，根據應用於雙極晶體管電路的跨導線性原理，提出了採用mosfet構成的電流模放大電路、電流傳輸電路、輸出電路以及由它們所組成的寬帶放大器，獲得了良好的頻率響應。
  11. This measurement amplifier with relay outputs works as a uniform voltage amplifier for strain gauge measuring bridges

    這款測量放大器帶有繼電輸出，它像恆定電壓放大器那樣工作，用於應變測量電橋。
  12. However, in the pulse application fields, the output pulse energy from single mode fiber lasers or amplifiers is limited by amplified spontaneous emission ( ase ), nonlinear effect and facet damage

    在脈沖激光應用領域中，這類小芯徑光纖放大器和激光器的輸出脈沖能量受限於自發輻射放大、非線性效應以及光纖的端面損傷。
  13. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  14. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  15. In the part of the transmitter, the pre - amplifier logarithmic amplifier, temperature complement circuit, anti - disturbing circuit, and v / i circuit, are discussed. the transmitter outputs 4 - 20ma. in the part of the displayer hardware design, the i / v convert circuit and the flame intensity signal processing circuit are introduced

    在探頭的設計中，詳細介紹了前置對數放大器電路設計，在對數放大器加入了溫度補償電路和抗干擾電路，以保證測量精度和較大的量程，最後信號經電壓電流的轉換，得到4 - 20ma的標準信號作為探頭的輸出信號，進行遠傳。
  16. Cathode follower amplifier

    陰極輸出放大器
  17. A high efficiency dual - band rf power amplifier has an output and / or input of a high frequency transistor well terminated at the second harmonic frequency for dual - band operation

    本發明乃一種高效率雙頻射頻功率放大器，提供高頻電晶體的輸出端與?或輸入端于雙頻操作中有良好的二階諧波終止。
  18. The fact that most of these topologies need laser - trimming technique to improve the match precision to reach high cmrr is found after investigating several instrumentation amplifier topologies. in this paper, a new style instrumentation amplifier topology with current processing mode based on ccii and impedance amplifier is designed and realized

    由於本論文所使用的國內工藝線沒有激光調阻技術，因此本文選擇了一種近年來新出現的一種新型儀表放大器電路結構，即使用第二代電流傳輸器（ ccii ）和跨阻放大器組成的電流模儀表放大器。
  19. 3. the output stage of transimpedance amplifier is realized with rail - to - rail topology to meet the requirement of output swing of the instrumentation amplifier

    3 .針對儀表放大器的輸出擺幅的要求，在跨阻放大器的輸出級採用rail - to - rail結構來實現。
  20. In this paper, a high accuracy ccii and transimpedance amplifier are designed firstly because they have the main influence on the current mode instrumentation amplifier

    針對讀出電路這一具體應用，本文先設計了電流模儀表放大器的兩個子電路:高精度的第二代電流傳輸器和跨阻放大器。
分享友人
分享到 Line

分享到臉書