輸出角分佈 的英文怎麼說

中文拼音 [shūchūjiǎofēnbù]
輸出角分佈 英文
angular distribution of output
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. The equation of the radiation transfer between two surfaces indicates that there are three factors that have influence on radiation transfer : brdf, projected solid angle ( psa ), and incident radiation flux. thereafter, a new baffle system design idea is put forward

    本文首先介紹了光學系統雜光的抑制措施，從光輻射在兩個表面傳遞的基本能量傳輸方程出發，指出影響輻射能量傳輸的三個因子：雙向反射分佈系數brdf 、投影立體角psa和入射輻射通量。
  2. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  3. Using different combinations of the nucleon density distributions of the ground state of 6he and the second excited state of 6li with and without the halo, we have calculated the microscopic optical potentials of the input and output channels, and, with these potentials, calculated the angular distribution of the " h ( he, li ) n reaction populating the second excited states of 6li by using a dwba code

    我們用假定的~ 6he基態和~ 6li第二激發態有暈和無暈的各種核子密度分佈的組合分別計算了入射道和出射道的微觀光學勢並將其輸入通用的dwba核反應程序計算了~ 1h （ ~ 6he ， ~ 6li ） n反應布居~ 6li第二激發態的角分佈。
  4. After measured the laser energy distribution of kunming slr station, the parameters of this non - gassian and non - spherical symmetric laser beam were deduced according to correlation definition. applying its laws and deduced laser beam parameters, the change of laser beam dirvergence angle was studied in detail when adjusts transmission system focus. moreover, calculation based on these measured data indicates that the laser shaded by the second mirror of telescope is amazingly up to 39. 8 %, an optical element was designed for the settlement and it worked satisfactorily when put it into practice

    之後測量了雲南天文臺激光的橫向能量分佈，根據相關定義確定了這束非高斯非球面激光的參數，應用它的傳輸變換規律和測量參數研究了調焦中激光發散角的變化，並根據測量數據計算出激光發射時副鏡擋光比例達到驚人的39 . 8 ，研製出光劈解決這一問題，取得了很好的效果。
  5. Powerformer is a new high voltage generator ， which use xlpe cable as stator winding instead of rectangular conductor bars ， thereby it overcome the shortcomings which the shape of these conductors results in an uneven electric field distribution with high electric field strenghs at the corners especially and prevents the output voltage of the conventional generator from exceeding about 36kv powerformer offers a direct connection to the network without the need for a step - up transformer as a consequence, there are some merits in the total plant equipped with powerformer, such as high effiency, high availability, low maintaining cost and giving less environmental impact

    Powerformer是一種新型的高壓發電機，它採用電纜代替矩形導體作為定子繞組，從而克服了矩形導體電場分佈不均勻，特別是在矩形導體在導體拐角處電場過于集中而使常規發電機的輸出電壓等級不能高於36kv的缺點，使其能夠直接和輸配電網相聯，這樣就不需要升壓變壓器，同時也使裝配powerformer的電廠具有如下優點高效率、可利用率提高、維修費用降低和降低了對環境的負面影響。
  6. This system has some specialty like : 1. for gis technique, it can manage transmission network graphically, display resource distributing clearly ; 2. with the class - template and rule - base technique, it can adapt the now - using and the coming equipment ; 3. providing a variety of report forms, it can help administrator an maintenance person to control the whole transmission network status with different angle ; 4. with the ameliorated auto and half - auto path configuration arithmetic, it can improve the network under - control efficiency and intelligence

    該系統具有以下的特點： （ 1 ）基於gis技術，對光纜等傳輸網路資源進行圖形化管理，使資源分佈顯示一目了然； （ 2 ）採用類模板和規則庫技術，使系統能適應目前和未來可能出現的設備； （ 3 ）提供靈活多變的統計報表，使維護人員和管理人員能從多方位多角度地掌握傳輸網網路運行情況； （ 4 ）採用改進的全自動和半自動的光電路路由配置演算法，提高網路的調度效率和智能化程度。
  7. The angle spectrum of inputting optical signals is received by the input surface of arrayed waveguides. whereas the diffraction process of light beam outputed in slab waveguide is a process of " composing frequency and generating image ". the reason that fraunhofer diffractive pattern can be gained on outputting waveguide surface is that output ends of arrayed waveguide distribute on the arch structure which leads bent phase factor to offset the quadratic phase factor in fresnel diffraction

    輸入平板波導內光束的衍射過程是「分頻成譜」的過程，在陣列波導的輸入面接收到的是輸入光信息的角譜；而輸出平板波導內光束的衍射過程則是「合頻成像」的過程，正是由於陣列波導輸出口排列分佈在圓弧形結構上，其彎曲位相因子消去了菲涅耳衍射中的二次位相因子，從而在輸出波導面上能夠得到夫瑯和費衍射圖樣。
  8. 2 for the first time, the author brings forward the concept of " pyramid horn high order mode resonator " and pml - fdtd technique is used to analyze the electromagnetic field distribution in the pyramid horn. the results show that the pyramid horn sensor is much more sensitive than the open ended waveguide or transmission line sensors. the sensor we used is a kind of resonance sensor

    二、首次提出了「角錐喇叭高次模諧振腔」的概念，並且採用pml ? fdtd法分析了角錐喇叭場分佈狀態，從而，得出了角錐喇叭探頭比終端開口波導或傳輸線探頭靈敏得多的原因在於：我們採用的探頭是諧振式探頭，消聲瓦樣品的差別相當于對角錐諧振腔的微擾；採用波導或同軸線探頭，消聲瓦樣品的差別相當于對傳輸線終端負載有一點變化而已。
  9. On the basis of research results of the existing experts and scholars especially the theory put forward by professor xu zhenliang ( my tutor ) that predicts the velocity profiles and friction loss of settling slurry when it flows in horizontal pipe and upward - inclined - pipe, relations among the velocity of water, that of solid particles and that of settling slurry have been established by the analysis of momentum transmission process between water and solid. then the calculation formulae for fricton loss of downward inclined and vertical pipe are deprived

    本文在現有專家學者的研究成果特別是許振良教授（導師）提出的預測非均質流在水平管道及向上傾斜管道流動時的速度分佈及摩阻損失的理論的基礎上，從動量守恆的角度建立了清水速度、固體顆粒速度和漿體速度之間的關系，進而推導出了向下傾斜及垂直管道沉降性漿體輸送的摩阻損失的計算公式。
分享友人
分享到 Line

分享到臉書