輸送管壓力 的英文怎麼說

中文拼音 [shūsòngguǎnyālì]
輸送管壓力 英文
line pressure
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 送 : 動詞1 （運送; 傳送） deliver; carry 2 （贈送） give as a present; give 3 （伴送; 送別） see sb of...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 輸送管 : carrier pipe/conveying pipe
  • 輸送 : deliver; supply; carry; transport; convey; feed; transmit; transfer; transportation; delivery
  1. Then, the change of the pressure of the concrete in the pipage is studied. lastly, the pressure losing and the error of the routine measure are discussed. chapter three discusses the fussy self - study issues based on the concrete technology the first section expounds the basic fuzzy self - study theory

    首先介紹泵送混凝土的流動特徵，接著研究泵送混凝土在輸送管中泵送壓力的變化，並分析影響泵送壓力損失的因素，從而討論常規計量方法的缺陷第三章主要是針對前章理論模型應用模糊自學習技術。
  2. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  3. Attestation car of gmp : the special wall face with the ground material, in addition to the dust equipments, in addition to the wet equipments, constant temperature equipments, the pure water decontamination system, purify the air condition, cleanness to deliver the machine, cleanness to deliver the window, breeze to pour the room and transport with connect the appropriation tube piece with to pump the valve, stainless steel ware, professional clothing and product, the air compressor, calculator related system and software, the factory motive equipments and attestation of gmp of other products and equipments

    Gmp認證車間特別墻面與地面材料除塵設備除濕設備恆溫設備純水凈化系統凈化空調潔凈傳遞器潔凈傳遞窗風淋室輸送與連接專用管件與泵閥不銹鋼製品專業服裝與製品空氣壓縮機計算機相關系統與軟體工廠動力設備及gmp認證的其它產品與設備。
  4. This paper describes characteristics of pipe belt conveyors, analyzes the vertical force and sag resistance exerted on the idlers, and derives the related theoretical formulas

    摘要通過分析圓管帶式輸送機的特性，論述了其托輥法向力和壓陷阻力的分析方法，經過詳細的理論推導，得出了理論計算公式。
  5. The system is based on the inner pid regulate function of frequency converter to regulate the living water stress with low constant stress, and the stress signal is sensed by the stress translator as feedback signal and the construction is sent by the computer as the given signal. the water stress is regulated to high constant stress when the fire happens

    本論文基於變頻器內置pid調節系統，以管網的壓力變送器壓力信號作為反饋信號，由上位機發出的當前狀態作為給定輸出，調節生活供水壓力使其保持低恆壓狀態；當火災發生時，調節系統管網壓力為高恆壓狀態。
  6. Steel gas pipelines for permissible working pressures up to 16 bar ; pipes and fittings

    允許工作壓力16巴以下的氣體輸送用鋼管道.管道和配件
  7. The conveying parameters were relatively optimized by adjusting the throat area of adjustable laval nozzle and pressure parameters, so that the foodstuff particle breaking rate during pneumatic conveying was decreased at certain extent

    通過調節可調式拉法管的喉徑以及各壓力參數實現了輸送參數的相對最優，在一定程度上減輕了糧食顆粒在輸送過程中的破碎率。
  8. The paper introduces experience of selecting hydraulic calculation formula and illustrates calculation of critical velocity of flow ( or critical pipe diameter ) and friction loss of pressure pipe in tailings transport and how to select the formula with examples

    介紹工程實踐中，選用水力計算公式的體會，對尾礦輸送中臨界流速（或臨界管徑）和壓力管道摩阻損失的計算以及如何選用公式分別作了舉例說明。
  9. The small blood vessels in the tissues of the legs and feet reduce the pressure of the blood returning in the veins

    腿部和腳部的眾多小血管會減少血液輸送回靜脈時所帶的壓力。
  10. The static and dynamical parameterized finite element model of the whole frame of the pipe belt conveyor and the fluid dynamic parameterized finite element model of the structural section are established by the software ansys of the finite element analysis. and then the static wind load of the whole frame of the pipe belt conveyor is calculated through the average wind pressure theory and computer simulation technology

    利用有限元分析軟體ansys建立圓管帶式輸送機整體機架結構的靜、動力參數化有限元模型及結構斷面的流體動力學參數化有限元模型，並通過平均風壓理論及計算機模擬技術計算出作用於機架結構的靜風荷載。
  11. Firstly, working theory and structure of concrete pump are lucubrated. and the flowing state of the concrete in duct is analyzed by virtue of the rheology theory. secondly, the flowing model of concrete in duct is established, with that, the pressure loss of concrete flowing in duct is analyzed, too

    論文首先對混凝土泵的工作原理和結構進行了綜合分析；基於流變學原理，深入分析了泵送混凝土在輸送管中的流動狀態，建立了混凝土在管道中的流動模型，分析了混凝土在管道中流動的壓力損失；基於運動學和動力學基本原理，對混凝土s管閥的運動學和動力學進行了分析。
  12. The pressure loss in the pipe of pneumatic conveying of waste plastics is one of the important parameters

    摘要在廢塑料氣力輸送過程中，管道壓力損失是重要參數之一。
  13. Then, the flow speed is in line with flow rate and kept on without being affected by subsequent pipes, thus distributing uniformly the pulverized coal injected

    結果表明，在現有高爐噴煤系統的各輸送支管前安裝一組具有相同幾何尺寸的「喉形噴管」並滿足適當壓力條件時，兩相流將在各噴管內發生壅塞流動。
  14. This paper selects the pulsating wind power density spectrum of davenport and simulates the wind speed time series and the wind load time by matlab. considering the vertical and horizontal correlation of the pulsating wind, the study make use of the time domain analysis of buffeting to carry out the transient dynamic analysis of the whole frame structure which is loaded by the random pulsating wind load. finally, in terms of the whole frame of the pipe belt conveyor, the evaluation for

    選取davenport脈動風功率譜，利用matlab模擬脈動風的風速時程曲線和風荷載時程曲線，並考慮脈動風的空間豎向和側向相關性，利用抖振時域法對整體機架結構進行隨機脈動風壓作用下的瞬態動力學分析，最後再對圓管帶式輸送機整體機架結構對環境風荷載的適應性做出評價。
  15. Aluminium alloy delivery coupling type c ; nominal pressure 16 ; used for fire hoses c 42

    輸送管路的c型鋁合聯接器.公稱壓力16 .用於c42消防
  16. The conclusions are drawn as following : 1. regularity of fabrication in aluminum matrix composite ring - shaped performs with large dimensions and effects of parameters were investigated, based on the novel crucible movable spray deposition technology and equipment. the optimal parameters are that the diameter of the delivery tube is 3. 8mm, spray gas pressure is 0. 8mpa, spray height is 200mm, and transferring pressure of sic is 0. 5mpa

    通過系統的實驗研究得到如下結論: 1 .基於新型的移動坩堝自動化控制噴射沉積環坯制備技術及裝置，研究了大尺寸鋁基復合材料環坯的制備規律，討論了噴射沉積工藝參數對沉積坯形成過程的影響，得到了最佳工藝參數:導流管直徑d = 3 . 8mm ，霧化氣體壓力p = 0 . 8mpa ，噴射高度h = 200mm ， sic顆粒輸送壓力p送= 0 . 5mpa 。
  17. The quantitative relational expression is obtained about the coefficient of additional pressure loss and the froude number by experiment, and the relation is made clear between the average speed of waste plastics particles and the pressure loss of per unit length

    由實驗得出廢塑料輸送管內氣力輸送附加壓力損失系數與弗勞德準數的定量關系式，廢塑料顆粒平均速度與單位管長壓力損失的關系。
  18. The method of visual testing of the steel tube ends is an unresolved problem in petrol industry, chemical industry, pressure vessel industry and oil and gas transporting project. i discuss the visual method and system of the steel tube ends based on the magnetic flux leakage theory, design a visual testing system of steel tube ends that makes the undetected areas testing of the steel tube ends possible

    鋼管端頭可視化檢測一直是石油行業、化工行業、壓力容器行業和油氣高壓遠距離輸送工程著力解決的課題，本文根據漏磁檢測方法對「鋼管端頭可視化檢測方法與系統」做了探討，設計了一個基於漏磁檢測原理的鋼管端頭可視化檢測系統，從而使鋼管端頭的無盲區檢測成為可能。
  19. Captured carbon dioxide can be transported by pipeline up to several hundred kilometers to suitable geologic storage sites and subsequent subterranean storage with the pressure produced during capture

    收集到的二氧化碳，可以經由輸送管運至數百公裡外的地質封存處，並藉由捕集過程所產生的壓力，封存於地底之下。
  20. Plastics pipes for the conveyance of fluids under pressure - miner ' s rule - calculation method for cumulative damage

    流體輸送用壓力塑料管. miner規則.累積損壞的計算方法
分享友人
分享到 Line

分享到臉書