輸運過程 的英文怎麼說

中文拼音 [shūyùnguòchéng]
輸運過程 英文
transport process
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • : Ⅰ動詞1 (物體位置不斷變化) move; revolve 2 (搬運; 運輸) carry; transport 3 (運用) use; wield...
  • : 過Ⅰ動詞[口語] (超越) go beyond the limit; undue; excessiveⅡ名詞(姓氏) a surname
  • : 名詞1 (規章; 法式) rule; regulation 2 (進度; 程序) order; procedure 3 (路途; 一段路) journe...
  • 輸運 : transport
  • 過程 : process; procedure; transversion; plication; course
  1. Abstract : in this paper, the significance of remote monitoring and fault diagnosis system for the pipe laying pump units in petroleum conveyance process is discussed. the communication principle and particular of remote monitoring and fault diagnosis system for pump units are analyzed. the hardware configuring and software algorithm of this system are constructed, and then, advantage and benefit out of this system are pointed out

    文摘:論述了原油輸運過程中的加壓泵機組遠監測及故障診斷系統的意義,分析了油泵機組遠監測及診斷系統的通信原理和特點,建立了實現該系統的硬體結構和軟體體系,最後說明了採用該系統的優勢。
  2. The transport of reb is also investigated by 2d3v particle simulation in the yz plane

    在搶平面上對電流輸運過程進行了zd3v粒子模擬。
  3. The transport of reb is examined by 2d3v particle simulation in the xy plane. the filamentation and coalescence of currents and related magnetic field pattern, caused by the two - dimensional electromagnetic - beam - plasma ( embp ) instability, are observed

    在xy平面上對電流輸運過程進行了2d3v粒子模擬,觀察到電流絲的形成、聚合和磁場產生。
  4. The way to get ko was given in this paper. by this way, the turbulence control equations were constructed from reynold equations with static pressure supposition and boussinesq ' s turbulence viscidity coefficient supposition and the salinity transportation equations, which are representative of the matter transportation equations, are given. the integrated deduction and corresponding boundary conditions are also given

    根據上述思想,從雷諾方出發,採用靜壓假定和包辛內斯克的紊動粘性系數假說,建立了新坐標系中的紊流控制方組,同時給出了對物質輸運過程具有代表性的鹽度、相應的邊界條件及完整的推導
  5. According to the demand of the concept design of china spallation neutron source ( csns ), the target station, i. e. the target, the reflector and the moderator have been simulated and optimized using monte carlo simulation software, nmtc / jam and mcnp4a, firstly. the neutron flux escaping from the target and the moderator and the heat deposition in the target, the reflector and the moderator are calculated. these results provided essential data as a basis of the spallation neutron source design

    本論文結合當前中國散裂中子源( chinaspallationneutronsource , csns )工概念設計的迫切需要,選擇國際上廣泛使用的基於蒙特?卡羅方法,用於模擬粒子輸運過程序mcnp4a和nmtc jam作為研究工具,首次對csns靶站進行了全面的模擬與優化,內容包括靶、反射體與慢化器系統的中子通量分佈以及熱量沉積,同時計算了靶的溫度場與應力場分佈。
  6. This course examines classical and quantum models of electrons and lattice vibrations in solids, emphasizing physical models for elastic properties, electronic transport, and heat capacity

    本課檢驗了固體中的電子以及晶格振動的經典和量子模型,重點強調于彈性性質,電子輸運過程和熱容的物理模型。
  7. In order to develop and utilize the ocean, its hydrodynaraic conditions have to be studied first. in estuary and coastal seas, tidal flow is a basic hydrodynamic factor, which affects other substance transport remarkably

    潮流,是海岸帶、海灣、海峽和潮汐河口地區的主要水動力學條件之一,是這些地區最基本的物質動,其他物質諸如泥沙、鹽分、各類污染物質及熱量的輸運過程,均伴隨著潮流而動。
  8. As the developing of modern industry in coastal zone, the coastal environment is deteriorated badly. in estuaries and coastal seas, the tidal flow is a basic hydrodynamic factor, which affects other substance movement remarkably, such as sand, salinity and so on

    在這些區域,潮流是主要水動力條件之一,是這些區域最基本的物質動,其他物質諸如泥沙、鹽分、各種污染物質及熱量的輸運過程均伴隨著潮流而動。
  9. It is found that the liquid kerosene of injection upstream cavity could finish the process of atomization and evaporation in short distance, and enter into cavity through convection. aft wall is the primarily area of flame holding in cavity, and the only area when near the lean blowout limit, flame in area of fore wall are spread from it. cavity shear layer in reaction flow angle greatly to the main flow direction, and couldn ’ t reattach to aft wall anymore, it appears great difference in characteristics of cavity flowfield between non - reaction and reaction state

    研究發現:凹腔上游噴注的液體燃料能夠迅速霧化、蒸發,並在較短距離內依靠對流輸運過程進入凹腔內部;凹腔後壁始終是凹腔火焰駐留的主要區域,在貧油極限時,也是唯一區域,並存在明顯的火焰由後壁向前壁的傳播;燃燒狀態下的凹腔剪切層以較大角度向下游主流發展,不再附著于凹腔後壁,與冷流中的凹腔流場特徵相差較大。
  10. The results of simulations are : i ) energies of the incident ions to the target are determined mainly by the voltage across the cathode sheath, with a majority of ions " energy vary around the sheath voltage ; ions nearly normally bombard the target ; ions mainly locate above the sputtering holes because of the influence of the magnetic field, and the incident ions mainly come from the region ; the ions undergo several collisions during transportation, but that do n ' t matter much

    主要模擬結果有: ? )入射離子到達靶面時的能量主要受到了射頻輝光放電中陰極殼層西北工業大學碩士學位論文李陽平電壓的影響,大部分離子的入射能量在陰極殼層電壓值附近,離子濺射時接近於垂直入射;射頻輝光放電受到陰極磁場的影響,等離子體中的離子主要集中在靶面濺射坑的上方,且入射離子主要來自這個區域;入射離子在輸運過程中和背景氣體分子有少量的碰撞,但影響不太大。
  11. Experiment results show that the diffusion equation can be used to describe the transportation process of near infrared photons accurately in scattering media. however, a relatively large error exists for the case of low scattering tissue, and as a result, this model can not be employed for the ot reconstruction in this case

    實驗結果表明,擴散方可以較為準確地描述光子在強散射介質中的輸運過程;但對弱散射介質擴散方模型卻存在較大的誤差,因而不適用於該種情況下的圖像重建。
  12. This paper deals with the monte carlo simulation of high - energy protons transport in silicon, in which the intra - nuclear cascade model is used to deal with proton nuclear reaction process. and the results of radiation effects of proton in silicon and p - seu ( proton induced single event upset ) cross section of some electronic devices are presented

    本文用蒙特卡羅方法對高能質子(最高能量在500mev以上)在硅材料中的輸運過程進行了模擬,作了用核內級聯模型計算質子核反應的嘗試,計算了質子對硅材料的輻射效應及其對硅器件的單粒子效應。
  13. A rectangular target with its aspect ratio 2. 5 : 1 gives the higher neutron flux than square target with the same area. for the same shape, the neutron flux increases then turn to decrease with decreasing the area of the target

    接下來根據已優化的靶的參數,利用低能粒子序mcnp4a進一步計算高能中子(快中子)進入慢化器后,在慢化器中的輸運過程
  14. Transport process and transport coefficients in gases

    氣體的輸運過程系數
  15. As to the simulation of the whole process of the generation and transportation of vapor phase film atoms, few attempts were made

    在薄膜技術中,計算機模擬已被用來研究薄膜的生長,但對成膜粒子的產生和輸運過程還很少進行綜合考慮和模擬。
  16. Numerical simulation of flow field on open and flat flow combustion

    平展流燃燒器內湍流輸運過程的數值模擬
  17. Almost all the augmentation techniques are used to vary the local behavior of heat transfer so as to improve the whole performance

    傳熱強化的途徑是依靠各種強化技術來改變熱量在空間內的輸運過程,通常是通設計熱的局部行為而實現整體性能的強化。
  18. We only need consider electron as carrier of electric charge in former electron transporting process, but in gmr effect, electron not only is the carrier of electric charge, but also has spin

    在以往的電子輸運過程中,人們僅需要考慮電子作為電荷的載體,但在巨磁電阻效應中,電子不僅是電荷的載體,而且具有自旋。
  19. The main purpose of this article - is to simulate the whole process of the generation and transportation of the vapor phase particles of the film in rf magnetron sputtering, which contains transportation of ions in rf glow discharge, sputtering of target and transportation of sputtered atoms, via models that are established on the basis of the physics of sheath theory for the rf magnetron glow discharge, sputtering theory and transportation theory

    本論文對射頻磁控濺射中入射離子的產生和、離子對靶材的濺射、濺射原子的輸運過程進行了綜合考慮,根據射頻輝光放電的陰極殼層理論、粒子的理論、離子對靶材的濺射理論建立模型,進行了計算機模擬。
  20. They thought it had some relation with coupling between layers at that time, but later people found the mechanism of gmr was different with anisotropic magnetoelectric resistance effect, it involved with spin dependent electron transporting process

    當時認為它與層間耦合有很大關系,后來人們發現產生巨磁電阻效應的機制不同於各向異性磁電阻效應,它涉及到與自旋相關的電子輸運過程
分享友人