輻射熱測量 的英文怎麼說

中文拼音 [fúshèrècèliáng]
輻射熱測量 英文
bolometric measurement
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 輻射 : radiation; exposure; radio; beaming
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Pyrometers, radiometers, bolometers are used for determining heat radiation and have applications for measuring the surface temperature of hot lavas.

    高溫計、輻射計、輻射熱測量儀用來測定熱輻射和熱巖熔的表面溫度。
  2. In this method of measuring temperature, when the measuring results of time - resolved spectrum have been completed, computing the fit spectrum of corresponding planck bold - radiation with least duple multiply theory, the temperature is measured

    溫度擬合方法的主要思想：獲得光譜的時間分辨測量結果后，用最小二乘法原理計算熱輻射譜（主要在可見光區）擬合得到相應普朗克黑體輻射加線，並解析其溫度。
  3. Tld practice for use of thermoluminescence - dosimetry systems for radiation processing

    輻射處理用熱致發光劑量測定
  4. Tld standard practice for use of thermoluminescence - dosimetry systems for radiation processing

    輻射加工用熱致發光劑量測定
  5. Test method for critical radiant flux of exposed attic floor insulation using a radiant heat energy source

    利用輻射熱能源測定暴露的頂樓地板絕緣臨界輻射通量的方法
  6. Measuring method for normal total emittance of infrared heater

    紅外輻射加熱器全法向發射率測量方法
  7. Measuring method for normal spectral emittance of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  8. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  9. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  10. Method for measurement of mass loss and ignitability for screening purposes using a conical radiant heater

    使用圓錐輻射加熱器測量屏蔽用質量損耗和可燃性的方法
  11. Measuring method for normal spectral emittence of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  12. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  13. In this paper a system has been developed for studying characteristics of " clouds and sky " on the images taken by a whole - sky camera at three different wave bands ( the visible, the infrared, long wave infrared ), then assessing the presence, distribution, shape, and radiance of clouds over the entire sky using automated cloud decision algorithms and related processing

    根據發展自動化雲觀測的目標，利用雲和晴空大氣在可見光近紅外、熱紅外多波段散射輻射和熱輻射的不同特徵，我們嘗試建立一個多波段（可見近、熱紅外）全天空成像輻射觀測系統，進行全天空分波段成像輻射的獲取，定量分析和特徵識別，獲得雲量、雲型、雲底高信息，實現對雲參數化信息的自動獲取。
  14. It is very difficult to analyze flame radiation in the cylinder of a diesel engine by theoretical method since flame radiation is a function of many parameters, such as the combustion process, the geometrical description of the chamber, the soot formation and oxidation processes, the soot radiant temperature and soot absorption coefficient. the radiant property of the flame in a cylinder is dependent on the combustion process. but the thermodynamic state of real engine cycles can be analyzed from the pressure - volume diagrams in the cylinder. thus a new thermodynamic computational model is set up for the flame radiation in the cylinder of a diesel engine based on the indirect relationship between the flame radiation and the pressure - volume diagram of the combustion process in this paper. the flame radiant heat flux in the cylinder of a di diesel engine is calculated with the variation of crank angle by this model. compared with measured values, the result of the computational values shows the model is available to represent the effects of flame radiation

    柴油機缸內的火焰輻射受諸多因素的影響，用理論分析法來確定它是相當困難的，由於柴油機缸內火焰輻射特性依賴于缸內的燃燒過程，而燃燒過程中的實際熱力狀態又可用示功圖來分析，因此藉助於火焰輻射與缸內熱力參數之間的這種間接關系，建立了一種計算柴油機缸內火焰輻射傳熱的新模型，利用該模型對一臺直噴柴油機缸內火焰輻射熱流量隨曲軸轉角的變化情況進行了計算，將計算結果與實測結果進行了比較，表明該模型能較好預測缸內火焰輻射傳熱量。
  15. Based on setting up the fire safety goals, performance criterion, fire scenario and uncertainty factor, this article simulated the occupants ’ evacuation time, smoke spread, radiation flow etc and determined fire detector and automatic extinguishing device by using the developed engineering method. and so these buildings ’ fire safety goals, which have the equivalent safety level with the existing national standard, can be achieved and those problems, which caused by some incompliment requirements or the existing codes not adapting to the practical need, can be solved

    針對這類建築存在的典型問題，通過設定消防安全目標、確定性能判據、建立火災場景，考慮不確定因素，運用已開發的工程學方法對人員安全疏散時間、煙氣蔓延、輻射熱通量等進行模擬計算，對火災探測和自動滅火設施進行分析選擇，認為大型書城建築採用至少與現行國家標準的規定等效的方法來實現建築物的消防安全目標，能夠解決現行標準與實際需要不相適應或某些不完善的規定所帶來的問題。
  16. Microbolometer, which is the key part of umbirfpa, is the unit absorbing the infrared radiation and changing it into heat quantity and electrical quantity

    微測輻射熱計是umbirfpa的核心部分，它是把紅外輻射轉換為溫度變化再轉換為電學量變化的象元單位。
  17. Bolometry of plasma

    等離子體輻射熱測量
  18. Verification regulation of thermoluminescence dosimetry assembly for personal monioring of x or radiation

    個人監測用x輻射熱釋光劑量測量裝置檢定規程
  19. Verification regulation thermoluminescence dosimetry assembly for environmental monitoring of x of radiation

    環境監測用輻射熱釋光劑量測量裝置檢定規程
  20. This paper has discussed the airborne monitoring of radioactive contamination formed during exploitation and utilization of iron ore and coal ore, analyzed the gamma radiant eminence map of china, and determined several relatively high radioactivity level regions, thus showing the effects of airborne radioactivity survey

    摘要通過對鐵、煤開發利用中形成的放射性熱點的成功航空檢測，以及對中國輻射照射量率圖的分析，確定了幾個放射性水平偏高區域，從而闡明了航空放射性測量在環境檢測中的作用。
分享友人
分享到 Line

分享到臉書