轉向縱拉桿 的英文怎麼說
中文拼音 [zhuǎnxiàngzōnglāgǎn]
轉向縱拉桿
英文
steering drag link- 轉 : 轉構詞成分。
- 縱 : Ⅰ動詞1 （釋放; 放走） release; set free; let go 2 （放任; 不約束） indulge; give oneself up to; l...
- 拉 : 拉構詞成分。
- 桿 : 桿名詞（桿子） pole; staff
- 轉向 : 轉向turn; turn round [around]; swing; sway; change direction; change one's political position
- 拉桿 : bar; straining beam; drawbar; dog iron; stake pole; queen bolt; tie rod; pull rod; drag link; ten...
-
The mechanism consists of a steering gear box, pitman arm, drag kink, tie rods, steering arms, and steering knuckles, the latter supporting the front wheels
該機構由轉向器，轉向垂臂，縱拉桿，轉向橫拉桿，梯形臂和轉向節構成，轉向節支承著前輪。Firstly, for the system of moulding board and support frame in construction the side pressure and screws are analyzed. the material and structure form of support frame are discussed. the design of support frame uses the method of limited state, and also it analyses the integer stability, part stability, and single stability, and then proposes the load analysis of multi - level support frame
首先，針對轉換層梁模體系及支撐架施工，重點分析了轉換層結構現澆混凝土對模板側壓力值及模板對拉螺桿的計算；討論了轉換層支撐體系的形式及構造，詳細論述了基於極限狀態設計的支撐架計算方法，包括縱橫向水平桿的強度驗算、立桿的整體穩定性、局部穩定性、單肢桿件穩定性等驗算，並提出了多層支撐架的施工荷載計算方法。The kinematic performance of the macpherson suspension on a real vehicle is studied, and the changes of the front wheel alignment and the motion of the front wheel in the longitudinal and the transversal directions are figured. based on the requirements of general layout, a constrained optimization design model is set up with the steering cross rod ball joint position as the optimization variables ( design parameters ), and the sum of steering cross rod length interference while the left front wheel turning and bouncing as the objective function. and the optimization results are worked out by programming on computer
針對一種實際車型上的麥弗遜式懸架，計算分析了轉向輪跳動時前輪定位角和車輪橫向、縱向滑移量的變化情況，並根據實際車型上麥弗遜式懸架的空間布置要求，建立了以轉向橫拉桿斷開點空間位置坐標為優化變量，轉向橫拉桿斷開點空間布置坐標可變化范圍為約束條件，車輪轉向和跳動時轉向橫拉桿長度干涉量為目標函數的約束優化設計模型。
分享友人