轉子動力泵 的英文怎麼說

中文拼音 [zhuǎnzidònglìbèng]
轉子動力泵 英文
rotodynamic pump
  • 轉 : 轉構詞成分。
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 泵 : 名詞（吸入和排出流體的機械） pump
  1. Driveequipment use active magnet connected - implement to firsthand fix at the axletree of electrical engine, pumproom close completely, via magnetic force coincidence to drive impeller on rotor - assembled to circumgyrate indirectly

    驅動裝置採用主動磁鐵聯軸器直接裝在電機軸上，泵室完全封閉，通過磁力偶合間接驅動轉子組合上的葉輪旋轉。
  2. The magnetic suspension bearingless motors generate both electromagnetic torque and magnetic levitation forces for the rotor suspension by the motor itself. the bearingless motor is comparatively suited for using as artificial heart blood pump motor due to the advantages of without mechanical wear and noise, structure compact and contactless

    磁懸浮無軸承電機定、轉子既用於產生驅動力矩，同時又用於產生支撐轉子的磁懸浮力，具有無機械磨損、噪音小、可高轉速和體積小等特點，比較適用於人工心臟血泵電機。
  3. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。
  4. Using the perturbation transfer matrix method as well as the tested data in the laboratory, the 1st and 2nd order perturbed identification of dynamic parameters of the rotor of a boiler pump is made

    摘要利用攝動傳遞矩陣法，結合實驗室的試驗，對某電站鍋爐給水泵轉子的動力學參數進行了一階和二階攝動識別。
  5. The 1st and 2nd order perturbed identification results that represent the strengthened effects on bending rigidity of the rotor caused by the impellers and the sleeves on the shaft of the pump are given, and the modified dynamic models of the rotor are obtained

    給出了給水泵轉子上的熱裝葉輪、軸套對轉子剛度產生加強作用的一、二階攝動識別結果，得到了修正的給水泵轉子系統動力學計算模型。
  6. The influence of the eccentricity mass moment, position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3. to verify the exactness of fem and learn the principle of vibration of dredge pump further, the orbit of the rotor shaft of the pump in the dredger is measured, the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition

    模態分析確定了泥泵的振動特性（固有頻率和振型） ；諧響應分析確定了泥泵轉子軸在偏心力的作用下軸截面處的最大響應位移；研究了轉子軸的質心位置、軸承剛度和質量偏心矩對轉子軸振動特性的影響； 3 、採用軸心軌跡法，實船測量了泥泵軸工作時振動響應值。
  7. Based on the perturbation riccati transfer matrix method, the calculating program are developed. the program can be used to the perturbation analysis and the sensitivity analysis of the real and complex, the single and repeated eigenvalues and eigenvectors for lateral vibration of rod and beam structures, especially suitable to the perturbation analysis and the sensitivity analysis of eigenvalues and eigenvectors for rotordynamic systems ; 2. the perturbation riccati transfer matrix method was applied to identify the parameters of the rotor for a boiler supply pump, and the accurate dynamic model of the rotor was archived

    該程序可以對桿、梁結構橫向彎曲振動的實數、復數的孤立和重頻特徵值問題進行攝動分析和靈敏度分析，特別是適合於轉子動力學系統特徵值和特徵向量問題的攝動分析和靈敏度分析； 2 、用攝動riccati傳遞矩陣方法解決了某電站鍋爐給水泵轉子的參數識別及動力模型修改的問題，並給出了該種型號的給水泵轉子的更準確的力學模型，為進一步的轉子動力學分析與設計奠定了可靠基礎； 3 、給出了攝動理論在相關領域如隨機特徵值分析、隨機振動響應分析、可靠性分析、靈敏度分析、優化設計以及參數識別中的應用公式。
  8. In this paper, the author improved the design of v trough of port plate by studying the automobile power steering pump ( apsp ) produced home and abroad and analyzing the different reasons of their noise from the stator transition curve, which could reduce the noise of apsp effectively

    本文以國內和國外生產的汽車動力轉向泵為研究對象，從定子過渡曲線的角度分析了它們噪聲不同的原因，並對配流盤v形尖槽進行了優化設計，可以有效地降低汽車動力轉向泵的噪聲。
  9. According to the law of mass moment of inertia and of momentum moment, the conditions for the complete dynamic balance of rotor inertial forces and moment of inertia in the rotary piston vacuum pump are put forward, with the rotor movement in single cylinder analyzed as basis

    根據質量矩定理和動量矩定理對單缸滑閥真空泵的轉子運動狀況進行了分析，分別提出了轉子慣性力和慣性力矩完全動平衡的條件。
  10. The shape of the pick - up ' s inlet influence the internal pressure much. another part of this paper is numerical simulation of the flow in the rotating case

    集流管在轉子腔中是靜止的，其對轉子腔內流動的影響直接關繫到旋噴泵的水力性能。
  11. The apsp produced abroad is made by numerical controlled machine tool, which has noise level of 71db ( a ), the apsp produced in our country is made in the method of exploratory which has noise level of 73db ( a ) and 75db ( a ). in order to analyze the influence of stator curve to noise, the author used tri - coordinate measuring instrument to measured exactly the inside surface of stator and got the straddling point coordinate, and made curve fitting by using matlab as language and studied the fitting effect and then worked out the equation of stator transition curve in return seeking, then comparied this method with the standard style and made the conclusion : the equation of atator transiting curve of apsp made by numerical controlled machine tool is close to theorical 5 power curve standard style, but compared with it, the stator transiting curve of apsp produced in exploratory has a major error. combining the testing results of noise, one can know that the qualily of stator transition curve play an importance to t he noise of the pump

    國外生產的汽車動力轉向泵是用數控機床加工的，其噪聲值為71db （ a ） ，國內生產的汽車動力轉向泵是用靠模方法加工的，其噪聲值分別為73db （ a ）和75db （ a ） ，為了分析定子曲線對泵的噪聲的影響，本人用三坐標測量儀對定子內表面進行精密測量，獲得定子內表面的離散點坐標，以matlab語言為工具對離散點進行曲線擬合，觀察擬合效果，然後，用回歸方法求出了定子過渡曲線的方程，並把該方程與理論方程標準型進行了比較，得出如下結論：用數控機床生產的汽車動力轉向泵的定子過渡曲線方程非常接近理論5次曲線標準型，而用靠模方法加工的汽車動力轉向泵的定子過渡曲線與理論5次曲線標準型相比較，則存在著較大的誤差，結合噪聲測試結果可知，定子過渡曲線的優劣，對泵的噪聲大小有著重要的影響。
  12. Magnetic force pump magnet couplings " universal energy equation is educed by analyzing of demagnetization curve, ways of reverting force calculating are introduced according to the equation when inside magnet rotor have axial direction and radial displacement, circumferential moment of magnetic force has been given, magnetic force pump alnico ' s axial direction length, circumferential length, radial thickness amounts are summarized with the analyses of experiment results

    利用退磁曲線法，推導磁力泵聯軸器能量通用公式，導出內磁轉子在軸向偏移和徑向偏置下產生的回復力計算方法，周向傳動轉矩計算方法，結合試驗結果，總結推薦磁力泵磁鋼軸向長度、周向長度、徑向厚度、磁極數設計方法。
  13. The work in this thesis focuses mainly on the basic theory of bearingless motors, magnetic levitation forces and their decoupled control with electromagnetic torque as well as air gap dynamic detection. three parts are included

    圍繞磁懸浮無軸承血泵電機的基本原理、磁懸浮力產生及其與電磁轉矩的電磁解耦機理和轉子位置的動態檢測等方面，本文主要開展了如下的研究工作。
  14. Experimental results showed that the pump vibration can be reduced obviously by improving the rotor construction in accordance to the balance conditions

    按照慣性力平衡條件進行的實驗表明，轉子等運動部件在按此平衡條件作了部分改動后，泵的振動明顯降低。
分享友人
分享到 Line

分享到臉書