轉熔點 的英文怎麼說

中文拼音 [zhuǎnróngdiǎn]
轉熔點 英文
peritectic point
  • 轉 : 轉構詞成分。
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  1. The results show that there is anomalistic crystal whose size reaches nanometer grade in fine pvc ; the crystal structure is damaged by jet - milling, which induces the melting point of nanocrystal pvc decreases from 210 to 128. the nanocrystal pvc induces the decrease of plasicizing time and equilibrium torque and the increase of maximal torque, which show that the nanocrystal pvc have self - plasticization in pvc composites

    通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距的降低、最大轉距升高，具有自增塑作用。
  2. When several compounds are formed, there is the possibility of more than one peritectic point.

    當生成數種化合物時，就可能有一個以上的轉熔點。
  3. 5, both melting point ( tm ) and isotropization temperature ( tj ) of all the three series compounds change regularly with the carbon numbers of the end alkoxy group increased. there is a gradual increase in smectic phase length and in the smectic - nemetic transition temperature. at the same time there is a gradual decrease in nemetic phase length

    五，三個類型化合物16ia至16id 、 16ila至16lid 、 17ia至17id 、 17ila至17lid 、 18ia至18id和18ila至18lid的熔點和液晶態的清亮點均化合物分子中末端烷氧基增大逐漸降低；近晶相的溫度范圍和近晶相一向列相轉變溫度逐漸增大，而向列相的溫度范圍遞減。
  4. He moves aspark to fuel, and it ignites, and by the force generated in combustion it cooks the food, melts or softens the iron, converts into beer or sugar the malt or cane - juice, which he has previously moved to the spot

    人將火花移向燃料，燃料就點著了，靠燃燒中所產生的力烹調食品，熔化或軟化鐵，把麥芽或甘蔗汁轉化為啤酒或糖，而這些東西都是他事先移到此處的。
  5. The crystallization and melting behavior of mellocene - catalized branched and linear polyethylenes of low molecular weight was studied. it was found that the crystalline lattice of branched polyethylene is larger than that of linear polyethylene because of the existence of branched chains. the melting behavior of branched polyethylene is similar to that of linear polyethylene since the branched chains can not enter the lattice. however, the crystalline behavior of low molecular weight branched polyethylene is the same as that of high molecular weight linear polyethylene, but different with that of low molecular weigh linear polyethylene. kinetics theory analysis evidenced that the transition temperature of growth regime of the branched polyethylene is about 20 lower than that of linear polyethylene with the same molecular weight. it may be attributed to the existence of short branched chains

    研究了金屬茂催化的低分子量支化聚乙烯和線性聚乙烯的結晶及熔融行為，發現支化聚乙烯的結構與線性聚乙烯相同為正交結構，但晶格略有膨脹.支鏈的存在對熔融行為影響不大，兩種聚乙烯的熔點均隨結晶溫度的升高而非線性增加，表現出低分子量樣品的共同特徵.但支鏈的存在對結晶行為卻有很大的影響，主要是由於支鏈的存在降低了晶體的結晶速率從而影響結晶過程，使得低分子量的支化聚乙烯的結晶行為與高分子量線性聚乙烯的結晶行為相似而與低分子量的線性聚乙烯不同.動力學分析表明，低分子量的支化聚乙烯的結晶生長方式的轉變溫度比同等分子量的線性聚乙烯降低了約20
  6. Rapid repairing mass for converter ismade of electro baked magnesite and high - quality synthetic sandand manufactured by adding high fluidity recarburizer ( beveloped by ourselves ) as addition agent withspecial technique. lt has the characteristics of well fluidity, well rapid fluidityand rpid sintering etc. it is applied to hot patching of large area before or after the converter as rapping hole patching and other parts for converter

    轉爐快速補爐料是以電熔鎂砂和優質合成砂為主要原料，配以自行研製的高流動性的增碳劑為添加劑，以特殊工藝生產製成，具有流動性好、快速燒結等特點，適合於轉爐的前後大面的熱修補及出鋼口等部位的修補
  7. Friction stir welding ( fsw ) is a solid - phase welding operated under the melting point of workpiece materials ; it ' s a technology which uses an anti - friction tool to join the sheet or shaped materials in rotary circs, and can be used in the welding of aluminum, magnesium and copper and has good welding quality

    摘要摩擦攪拌焊（ fsw ）是在低於工件材料熔點情況下操作的固相焊接，是在旋轉情況下通過一種耐磨工具將板材或型材材料連接的工藝，可用於鋁、鎂、銅等的焊接，焊接質量優良。
  8. The physics model was established to deduce the relationship of different classifying gear speeds and melting point on the base of the broken theory and the broken process of pvc. it explained that the melting point of nanocrystalline pvc was low. therefore the effect of nanocrystal was proved in theory

    最後通過引入破碎理論針對pvc的破碎過程，建立物理模型推導出分級輪旋轉速度與晶體熔點的關系，解釋納米晶pvc熔點低的原因，從而從理論上探討了pvc的納米晶效應。
  9. For the crystalline polymer matrix, the ptc transition temperature is close to the melting point, while for the amorphous polymer matrix, the ptc transition temperature is close to the glass transition temperature

    Ptc轉變溫度與體積膨脹的轉變溫度非常一致，對于結晶聚合物基體體系， ptc轉變溫度在基體的熔點附近，而對于非晶聚合物基體體系， ptc轉變溫度在基體的玻璃化轉變溫度附近。
  10. As each human begins to embody all elements including air, water, fire and earth along with the inverse elements of ether, vapor, smoke and lava, humanity will begin to thaw out as there will be enough fire to allow for an internal shift within each.

    當每個人融合入所有的元素包括氣，水，火和土，連同逆元素如以太，蒸汽，煙和熔巖時，人類將開始解凍，因為這將使每個人的內部被充分點燃（擁有足夠的能量）而允許一個內在轉換的發生。
  11. Glass transition temperatures decreased with the length of soft units increasing, however, the effects of soft units were random

    隨柔性間隔基k度的增加，玻璃化轉變溫度卜降，但柔性間隔基對熔點的影響是無規律的。
  12. The results showed that there was anomalistic crystal whose size reached nanometer grade in fine pvc ; it ' s about 80nm. the crystal structure was damaged by jet - milling, which induced the melting point of nanocrystal pvc decreased from 210 " c to 128 擄 c. the nanocrystal pvc induced the decrease. of plasicizing time and equilibrium torque and the increase of maximal torque, which showed that the nanocrystal pvc had self - plasticization in pvc composites

    通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體，尺寸在80nm左右；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距降低、最大轉距升高，具有自增塑作用；納米晶pvc的加入使pvc的沖擊和拉伸強度都有大幅度上升。
  13. Additions of carbon for improved slag resistance. spinel formation improves hot strength, slag resistance and brick joint erosion. 3 repairing material for bof uses fused magnesia or sintered magnesia as the main raw material and after modifid pitch and special additives are added, it has the following characteristcs than other conventional converter pitch temperature, shorter sintering time, longer service life and less pollution. it is mainly used for repairing converter working face, also for tapping side, tapping hole and bottom

    3 ，轉爐大面補料是採用電熔鎂砂或燒結鎂砂為主要原料，通過加入改性瀝青和特種添加劑使它和傳統瀝青補爐料相比具有高溫附著性好燒結時間短流動性好使用壽命長污染小等特點，主要用於修補轉爐迎鋼面通常稱「大面」也可以用於修補出鋼側，出鋼口及爐底等部位。
  14. An equivalent flow length method was used to predict the filling pattern and transferred the tracing of melt front to computing weighted approximate shortest flow path on finite element mesh model

    該法將熔體前峰面的追蹤問題轉換為帶權曲面上任意兩點間近似最短路徑的求解。
  15. Ultrasonic plastic welding theory is generated by the generator 20khz or 15khz pressure, high - frequency signals, the system can be adopted for the high - frequency signals into mechanical vibrations, and in plastic products working, through working surface and internal friction among elements spread by the department of the interface temperature, when the temperature reached the melting point of her own, that the working interface rapid melting, and then fill in the gaps between the interfaces when shock stop working at a certain pressure and cooling will be a perfect welding

    的高壓高頻信號通過換能系統，把信號轉換為高頻機械振動，加於塑料製品工件上，通過工件表面及內在分子間的磨擦而使傳處到介面的溫度升高，當溫度達到此工件本身的熔點時，使工作介面迅速溶化，繼而填充于介面間的空隙，當震動停止，工件同時在一定的壓力下冷卻定形成完美的焊接.點擊數： 723錄入時間： 2006 - 5 - 14
  16. On the base of tg - dta, found the yb : kgw crystal has very good thermal stability under 1100, which has two obvious absorption peak at 1088 and 1025, contrast with the pure kgw crystal ( melting point at 1005, phase transition temperature from tetragonal system to monoclinic is 1075 ), we know the yb : kgw crystal ' s melting point is the absorption peak at 1088, phase transition peak from tetragonal system to monoclinic is the absorption peak at 1025

    利用tg - dta對所生長的yb ： kgw晶體測定說明，其在1100以下的熱穩定性是很好的。 yb ： kgw晶體在1088和1025有兩個明顯的吸收峰，判斷在1088處較寬的吸收峰是yb ： kgw晶體的熔點， 1025處的吸收峰是yb ： kgw晶體從四方晶系向單斜晶系的相轉變峰。
  17. Standard test method for measuring the viscosity of mold powders above their melting point using a rotational viscometer

    利用旋轉米度計測量模製粉末熔點以上粘度的標準試驗方法
分享友人
分享到 Line

分享到臉書