轉移電流比 的英文怎麼說

中文拼音 [zhuǎnyídiànliúbǐ]
轉移電流比 英文
transfer current ratio
  • 轉 : 轉構詞成分。
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 轉移 : 1 （改換位置） shift; transfer; divert 2 （改變） change; transform 3 [醫學] （擴散） metastasis;...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  2. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  3. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  4. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  5. However, the refractive index will increase with the increase of the flow ratio of sifu / nhs, slightly increase with the increase of substrate temperate, and decrease with the increase of rf power. by measuring the passivation results of hydrogen plasma and sinx thin film, we found an evident improvement of minor carrier lifetime in polycrystalline silicon after hydrogen plasma treatment, although it has little to do with the annealing temperature and time. the hydrogen contained in sinx thin film can enhance the carrier mobility of monocrystalline silicon, but after annealing at high temperature the mobility turns down

    通過測試氫等離子體鈍化和氮化硅薄膜鈍化的效果，實驗還發現氫等離子體處理對多晶硅材料的少子壽命提高作用比較明顯，但是這種提高作用與處理溫度以浙江大學碩士學位論文王曉泉2003年5月及時間的關系不大；氨化硅薄膜中的氫對單晶硅的載流子遷移率提高有一定作用，但經過高溫處理后這種作用消失；氮化硅薄膜能提高單晶硅和多晶硅的少子壽命，具有表面鈍化和體鈍化的雙重作用；氫等離子體和氮化硅薄膜都能有效地提高單晶和多晶電池的短路電流密度，進而使電池效率有不同程度（絕對轉換效率0
  6. This thesis analyzes all kinds of throttle components, points out the advantage of adapting eev, and analyzes the start - up and the discharge characteristics of eev, and dynamic response of refrigeration systems when the opening degree of eev is changed, etc. eev is placed into a tumoff position while the unit starts up, and after being kept for a period of time it is placed into a bigger position, after some more time it is put into a basic control

    本文對比分析了冷藏箱製冷系統各種節流元件的特點，指出電子膨脹閥應用的優勢，同時分析了電子膨脹閥的啟動特性、流量特性以及系統在閥開度變化時的動態響應。電子膨脹閥在啟動時應先使電子膨脹閥處于關閉位置，延時一段時間后，再將閥開至一個較大的位置，再延時一段時間后轉移到基本的控制。
  7. A permanent magnet synchronous motor is selected so that the system could work excellently. multiform measures are taken to weakening the torque ripple, such as adopting stator - flume, choosing right ratio of magnet - width and slot - width, and programming properly. a permanent magnet synchronous motor cad software is worked out for predigesting the design of the motor

    力矩脈動是衡量交流伺服系統性能優劣的重要指標，為達到理想的控制效果，系統採用正弦波驅動的稀土永磁同步電動機作為執行元件，電機本體的設計綜合採用定子斜槽、將轉子永磁體連續移位、合理選擇永磁體寬度和齒槽寬度比等方法，基本消除了齒槽轉矩；對于紋波轉矩，系統採用軟體的方式加以削弱和補償。
  8. This paper analyses the type, function and characteristics of usual proportional control valves and raises a new modificative version in the light of their drawback. that is, basing on the principle of flow amplification and electrical feedback and throughout calculation and analysis on flow closed loop control and pressure flow combination., determination of the minimum controlled pressure difference as well as flow controlling range and structure of main valve and research of the dynamic and static characteristic, the paper puts forward control principle of " flow - load pressure change - displacement revision " and pressure / flow double closed loop, and further expounds that using a proportional controller and a electric mechanical transducer can separately serve the control function of pressure or flow as well as flow pressure combination

    本論文分析了目前常用比例閥的類型、功能、特性，並針對其不足提出新的改進方案，即：以流量放大，電反饋兩個原理為基礎，通過對流量閉環控制及壓力流量復合的計算分析、確定上最小控制壓差及流量控制范圍，確定主閥結構、功能特性研究等，提出了「流量? ?負載壓力變化? ?位移修正」的控制原理和壓力流量雙閉環控制原理，並進一步論述了利用一個比例控制器和一個「電?機械轉換器」就可完成獨立的壓力或流量控制功能以及流量壓力復合控制功能。
分享友人
分享到 Line

分享到臉書