近似延遲 的英文怎麼說

中文拼音 [jìnyánchí]
近似延遲 英文
coarse delay
  • : Ⅰ形容詞1 (空間或時間距離短) near; close 2 (接近) approaching; approximately; close to 3 (親...
  • : Ⅰ形容詞1. (緩慢) slow; tardy; dilatory 2. (晚) late; delayed 3. (遲鈍) slow; obtuseⅡ名詞(姓氏) a surname
  • 近似 : approximate; similar; approach; approximation; roughness; propinquity
  1. In this article, an equivalent definition of reconstruct function is drew in the state space reconstruct by time delay chaotic time series, that lead the prediction more conveniently. then introduce a weighted distance to depict neighbour points of prediction which insured the similarity of the neighbour points

    本文在時間序列坐標后重構的相間中,作出重構函數的等價定義,提高了預測的可操作性;並在此基礎上,引入了加權距離來刻畫預測向量的鄰點,保證了鄰點的相性。
  2. For a class of special stochastic delay differential equations, i. e. the stochastic delay differential equation with small noise, the exacter order of convergence is obtained and it shows that the euler method nearly converges with the order 1

    針對一類特殊的方程即小噪聲隨機微分方程,給出其歐拉方法更精確的收斂階,表明歐拉方法是1階改斂的。
  3. By careful selection of the ratio between this resistor and the integrating resistor ( a few tens of ohms in the recommended circuit ), the comparator delay can be compensated and the maximum clock frequency extended by approximately a factor of 3. 3

    通過小心選擇這個電阻和積分電阻之間的比值(在推薦線路里,大約是數十歐姆) ,比較器的就可能被補償,最大的時鐘頻率可伸到3 . 3倍。
  4. According to the task and delay information of the floating - point unit, it was implemented with three - stage pipeline, including pre - normalization stage, calculation stage and post - normalization stage. approximately, the delay of each stage is equal with each other. also, floating - addition, floating - subtraction and floating - multiplication can been implemented by the floating - point unit

    根據浮點單元承擔的任務及信息,採用三級流線實現:前規格化級( pre - normalizationstage ) 、計算級( calculationstage ) 、后規格化級( post - normalizationstage ) ,每一級的工作量和相等。
  5. Some heuristics for the problems are present, and their performance guarantee is analyzed by the transform lemma. some present results are improved. in part three, the problem of scheduling n jobs on a single ' batching machine is addressed, and the jobs have release times and due dates

    第三部分研究了單臺批處理機器,工件的到達時間不同,以極小化最大時間為目標的分批排序問題1 | r _ j , b | lmax ,論文提出了一些演算法,給出該了問題相應的最差性能比界。
分享友人