迭加電路 的英文怎麼說

中文拼音 [diějiādiànlù]
迭加電路 英文
superposed circuit
  • 迭 : Ⅰ動詞（輪流; 替換） alternate; change Ⅱ副詞1 （屢次） repeatedly; again and again 2 （及） in tim...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. In this dissertation, we firstly prove that any dirichlet problem is indeed equal to a voltages problem of networks. we give five solutions to dirichlet problem in two dimensions ; among these five solutions, we prove that the iteration solution and the solution of relaxations are exponential convergence, then we estimate their respective convergence rates ; secondly, we discuss random walks on general networks, prove that there is an one to one correspondence between networks and reversible ergodic markov chains ; thirdly, we give probabilistic interpretation of voltages for general networks : when a unit voltage is applied between a and b, making va = 1 and vb = 0, the voltage vx at any point x represents the probability that a walker starting from x will return to a before reaching b ; furthermore, we study the relationship between effective resistance and escape probability : starting at a, the probability that the walk reaches b before returning to a is the ratio of the effective conductance and the total conductance

    本文證明了任何邊值的dirichlet問題都可轉化為求解電路電壓的問題：給出了計算平面格點上dirichlet問題的5種方法：證明了迭代法和松馳法都是指數收斂的，並分別給出收斂速度的估計；討論了一般電路上的隨機徘徊，驗證了電路與可逆的遍歷markov鏈是一一對應的；給出了電路電壓的概率解釋：當把1伏電壓加於a ， b兩端，使得v _ a = 1 ， v _ b = 0時，則x點的電壓v _ x表示對應的markov鏈中，從x出發，到達b之前到達a的概率；進一步地，給出了逃離概率與有效電阻之間的關系：從a出發，在到達b之前到達a的概率為有效傳導率與通過a的總傳導率之比。
  2. By picking up actual load on road of car body, use the electro - hydraulic servo road simulating system and the remote parameter cantrol system to iterate, take the iterating control target as an accelerated speed signal of spindle nose, iterate separately the loading spectrums on different road surfaces and finally merge the iterated results to obtain the loading spectrums for tests in the test bench

    通過對轎車車身實際道路載荷的採集，採用電液伺服道路模擬系統和遠程參數控制系統進行迭代（迭代控制目標為軸頭加速度信號，對不同路面的載荷譜分別進行迭代，最後將迭代的結果合併） ，得到用於臺架試驗的加載譜。
  3. Through ( multi - level ) bordered block partition of the power system topology matrix, a bbdf coefficient matrix which is suitable for above decomposition is formed. when the equation is solved with parallel iterative method, convergence acceleration is achieved through damping newton method

    通過採用（多重）對角加邊的方法進行電力網路拓撲分割，以形成適合以上分解法求解的對角加邊形式的系數矩陣，并行求解后並對迭代過程進行阻尼牛頓法修正，以達到加速收斂的作用。
  4. By successful solution of non - linear magnetic fields and revision of the program, we can reach following conclusions : in the computation of nonlinear magnetic fields, if iteration method is used, under - relaxation is necessary when amending the permeability distribution in soft magnetic materials ; and when < wp = 5 > calculating the equivalent current density in permanent magnets, under - relaxation is not a necessity ; when searching for permeability values by interpolation method on the demagnetization curve of soft magnetic materials, if a fixed saturation point is set, around this point an abrupt change of permeability values will be obtained ; this sudden change may cause a little problem in the smoothness of magnetic field distribution ; because the magnetic circuits of microwave tubes are too complicated, in the author ' s view, to describe the working state of a magnet system, the working points of magnets can not do it properly but average energy production of magnets will serve ; as to indicate the quality of a magnet system design for microwave tubes, the efficiency of magnetic energy utilization will be a very good criterion

    由此得出結論，在非線性磁場計算中：採用迭代法的情況下，在各迭代循環之間進行磁導率修正時，一個欠鬆弛迭代過程是必需的；對永磁體中的等效電流修正時可以不作欠鬆弛迭代；在純鐵的磁化曲線上指定某一個固定的磁感應強度為磁飽和值，會使得插值求出的磁導率在該磁飽和值附近有一突變，這一突變對計算結果中磁場分佈變化的光滑性稍有影響。在微波管磁系統設計中，由於微波管磁路比較復雜，作者認為磁體的工作點並不能很好地反映磁體的工作狀態，而採用平均磁能積為衡量磁體工作狀態的標準更加符合微波管磁系統的實際情況；要表示磁系統設計好壞的程度，則用磁能利用的效率為標準更好。
  5. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
分享友人
分享到 Line

分享到臉書