迭合時間 的英文怎麼說

中文拼音 [diěgěshíjiān]
迭合時間 英文
closed assembly time
  • 迭 : Ⅰ動詞（輪流; 替換） alternate; change Ⅱ副詞1 （屢次） repeatedly; again and again 2 （及） in tim...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. For the purpose of saving running time of iterations, this paper apply adaptive method to aitken extrapolation algorithm and eigenvalues - based algorithm respectively. experimental results elementarily show that these two new algorithms can speed up the performance of iterations

    本文將adaptive方法分別與基於特徵值直接求解演算法和aitkenextrapolation演算法相結合，實驗結果初步證明了這兩個新演算法能夠縮短迭代時間。
  2. By successful solution of non - linear magnetic fields and revision of the program, we can reach following conclusions : in the computation of nonlinear magnetic fields, if iteration method is used, under - relaxation is necessary when amending the permeability distribution in soft magnetic materials ; and when < wp = 5 > calculating the equivalent current density in permanent magnets, under - relaxation is not a necessity ; when searching for permeability values by interpolation method on the demagnetization curve of soft magnetic materials, if a fixed saturation point is set, around this point an abrupt change of permeability values will be obtained ; this sudden change may cause a little problem in the smoothness of magnetic field distribution ; because the magnetic circuits of microwave tubes are too complicated, in the author ' s view, to describe the working state of a magnet system, the working points of magnets can not do it properly but average energy production of magnets will serve ; as to indicate the quality of a magnet system design for microwave tubes, the efficiency of magnetic energy utilization will be a very good criterion

    由此得出結論，在非線性磁場計算中：採用迭代法的情況下，在各迭代循環之間進行磁導率修正時，一個欠鬆弛迭代過程是必需的；對永磁體中的等效電流修正時可以不作欠鬆弛迭代；在純鐵的磁化曲線上指定某一個固定的磁感應強度為磁飽和值，會使得插值求出的磁導率在該磁飽和值附近有一突變，這一突變對計算結果中磁場分佈變化的光滑性稍有影響。在微波管磁系統設計中，由於微波管磁路比較復雜，作者認為磁體的工作點並不能很好地反映磁體的工作狀態，而採用平均磁能積為衡量磁體工作狀態的標準更加符合微波管磁系統的實際情況；要表示磁系統設計好壞的程度，則用磁能利用的效率為標準更好。
  3. In some time - critical situation, continuous ssi is computation bottleneck of some solid modeling system. conventional approach for solving continuous ssi often uses intersection algorithm iteratively without taking the characteristic of the surface into account to simplify computation. the dissertation analyzes the intersect curve structure of continue surface, from the point of intersect curve ' s evolution, it describes the relationship between topology of offset surface intersect curve and topology transmit point ( ttp )

    等距曲面和運動曲面在cad cam領域中有著重要的應用，在一些時間敏感場合例如數控加工動態模擬，等距曲面和運動曲面等連續變化曲面求交運算已成為這些系統的計算瓶頸，連續變化曲面求交問題的通常解法是採用曲面求交演算法反復迭代計算交線，沒有考慮連續變化曲面交線之間的相似性進行求交簡化，效率上一直不能有很大的提高。
  4. Frequency response, quantization noise, reconstruction error and its sensitivity to mismatch among adcs are studied at length in prqmf banks adc system, and the theoretic results include : ( 1 ) the distortion / aliasing functions of hybrid filter banks adc system is similar with that of switch capacitor filter banks adc system ; ( 2 ) for wide or narrow band input signal, the effective resolution of the two adc systems is 0. 51og2m bits higher than their adc ; ( 3 ) reconstruction error ' s sensitivity to mismatch among adcs of the two adc systems is reduced effectively than time interleaved adc system

    2對prqmf濾波器組adc系統的頻響、量化噪聲特性、重建誤差特性以及重建誤差對adc間的失配敏感性進行了理論分析研究，所得到的理論結果為： （ 1 ）混合濾波器組adc系統與開關電容濾波器組adc系統的失真/混迭函數一致； （ 2 ）無論輸入寬帶還是窄帶信號，這兩種adc系統的有效解析度均比其adc提高了0 . 5log _ 2m比特； （ 3 ）這兩種adc系統的重建誤差對其adc間的失配敏感性均明顯低於時間交織adc系統。
  5. Secondly, to analyze seismic response of the concrete gravity dam, subspace iterative method was applied to compute free vibration period of the dam, time integration method was built up for the seismic time history analysis and formulation of coupled vibration of reservoir water and dam were also deduced

    其次，針對混凝土重力壩的地震響應分析問題，採用子空間迭代法計算了大壩的自振周期，建立了地震時程分析的逐步積分方法，並且推導了庫水和壩體耦合振動的理論公式。
  6. The authors established an initial velocity model based on the first break time of the actual data, then realized the forward calculation with the improved shortest path ray tracing algorithm, and applied the improved constrained damped simultaneous iterative reconstruction technique ( cdsirt ) to solve large - scale and sparse equations for inversing the near - surface velocity field

    根據實際地震數據的初至波時間建立初始速度模型；採用改進的最短路徑射線追蹤演算法進行正演；利用改進的約束帶阻尼聯合迭代重建技術（ cdsirt ）求解大型、稀疏的方程組來反演近地表的速度場。
  7. Using multi - way partial least squares ( mpls ) model integrated with iterative learning control, the final quality control for batch processes is presented

    摘要提出了多向偏最小二乘（ mpls ）模型和迭代學習控制相結合的方法，實現間歇過程終點時刻產品質量指標的控制。
  8. The solution formula of dwell time is deduced by using the pulse iteration method and the smoothing fourier transition method, and the formula can be simplified referring to workpiece shape. according to the anastomotic status of the tool and workpiece surface, we present the new model of the inherent relation among local pressure density, removal rate, convergence ratio and residual errors, and the corresponding formulas are given. the forming cause of the edge effect in the polishing process is analyzed, and the means which reduces the edge effect is put forward

    2 、針對計算機控制光學表面成形（ ccos ）的加工方式、誤差收斂特點，研製了去除函數呈高斯分佈的雙轉子結構研拋模；採用脈沖迭代法、平滑因子傅立葉變換法推導出駐留時間的演算法，求解過程中根據工件面形的特點作了各種形式的簡化；提出了工件表面和研拋模的吻合誤差與局部壓強、材料去除率、收斂比之間內在關系的數學模型，並推導出相應的計算公式；分析了邊緣效應產生的原因，在加工過程中採用相對壓力因子對去除函數進行修正，可以消除邊緣效應的影響。
  9. The control equation consist of completely coupled deformation equation, seepage equation, conduction and convection equation of heat, which describe the reservoir non - liner performance. 2, present the detailed strategy and methods to solve this mathematics model, the basic strategy as follows : regard the deformation equation ? seepage equation conduction and convection equation of heat as separate system, and solve the equation by coupling and iterative method ; disperse the control equation in the geometry field by the finite element method ( galerkin ), and in the time field by the finite difference method : programme the computer program on this task ; when the solving, take the combinative measures of the thick and thin mesh ; successfully carry out the numerical simulation in vast 3d heat extraction system of hdr

    2 、提出了高溫巖體地熱開發的固、流、熱多場耦合數學模型的數值解法，其基本的求解策略是：將固體變形，流體滲流與溫度場方程看成獨立的子系統，耦合迭代求解；利用有限元離散（ galerkin ）方法將控制方程在幾何域上離散，並用差分法得到時間域上的離散方程，並在此基礎上，編制了相應的計算機源程序；有限元求解中，為減小邊界效應的影響，在計算中採取粗細網格結合的方法，順利地實現了高溫巖體地熱開發三維巨系統的數值模擬。
  10. Nnd difference scheme divergences convection item and runge - kutta scheme iterates time item. the calculated outcome agrees well with the experiment data and analytic solution

    採用nnd差分格式離散對流項，時間迭代採用龍格庫塔法，計算結果與實驗值和解析解一致吻合。
  11. So the sta ( static timing analysis ) step and the iteration between synthesis and p & r ( place & route ) were integrated in the dsm design flow

    因此，需要在深亞微米設計流程中加入靜態時序分析環節，以及邏輯綜合和布局布線之間的迭代過程。
  12. In this thesis, the internal force and transfiguration of the double reticulated dome under different load combination are studied ; the linear and nonlinear analysis are separately performed ; compare the difference between space girder element and space truss element ; at last analyze the dynamical response under seismic action. the horizontal seismic response of double layer oblate lattice shell is analyzed by using step - by - step integration procedure. the effect of some parameters such as exterior load, different support conditions and damping ratio on the dynamic internal forces and dynamic properties is studied

    本文旨在研究雙層球狀網殼結構在各種載荷組合下的內力和變形，分別進行了線性和非線性靜力分析；進行了空間梁單元和空間桿單元兩種計算模型的比較；最後進行了在地震荷載作用下的動力反應分析，動力分析中用子空間迭代法得出了這類空間結構的動力特性，用時程法中的振型疊加法分析了結構在水平地震作用下的動態響應規律。
  13. The study state of art and development trend of structural damage identification research is simply summarized in this paper. hilbert - huang transform ( hht ) is applied to the damage identification and intrinsic frequency confirmation of time - variable structures. furthermore, a kind of inverse calculation is presented to calculate structural stiffness. this method can solve three main problems : the time that damage occurred, the location and the degree of damage

    本文簡要總結了結構損傷識別領域的研究現狀和趨勢，圍繞損傷引起固有頻率變化這個特徵，將希爾伯特?黃變換（ hht ）應用於時變結構的損傷識別和損傷前後固有頻率確定上，並結合牛頓迭代法，對結構剛度進行反演計算，從而解決結構損傷識別領域所關注的三個主要問題:損傷發生時間、損傷位置以及損傷的程度。
  14. The charictrization, construction and searching algorithm of m - ldpc codes were studied and analsised. base on m - ldpc codes, a new joint coded modulation scheme is proposed ( bp - mlc - id ), which differ form conventional mlc schems in that only one channel coder was used

    在上述基礎上，把多級ldpc碼進一步應用於mimo空間，並與空時分組碼有機結合，提出一種新的基於迭代譯碼的時空并行獨立通道聯合編碼調制（ bp - stbc - id ） 。
  15. Based on analysis on the generation mechanisms of auto - correlation peaks, acm is combined with average technique in correlation domain. average technique not only smoothes noise correlation lines, but also makes all potential positions of generating auto - correlation peaks generate auto - correlation peaks of dsss / bpsk signal. the improved acm obtain lower snr limitation successfully

    在分析時域自相關法相關峰出現機理的基礎上，將該法與相關域迭加平均技術結合，既平滑了噪聲又使各延遲時間為擴頻碼整數倍周期處均出現相關峰，實現了更低信噪比下的碼周期估計。
分享友人
分享到 Line

分享到臉書