透壁分氣法 的英文怎麼說

中文拼音 [tòubìfēnqìfǎ]
透壁分氣法 英文
atmolysis
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 壁 : 名詞1 （墻） wall （of a house etc ） : 銅墻鐵壁 bastion of iron2 （作用像圍墻的部分） wall of st...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  2. The synthesis process of single - wall carbon nanotubes ( swnts ) by catalytically chemical vapor deposition ( ccvd ) was investigated and the product was characterized with transmission electron microscopy ( tem ), electron diffraction ( ed ), electron dispersive spectra ( eds ) and raman scattering spectra etc. pyrolysis of methane over solid catalysts prepared with impregnation, ion - adsorption precipitation, and sol - gel technique can all lead to the growth of swnts

    本文研究了單壁納米碳管的化學氣相沉積法（ cvd ）制備工藝，並運用透射電子顯微鏡（ tem ） 、 x - ray能譜（ eds ）與喇曼（ raman ）光譜等分析手段，對產物及催化劑進行了表徵。採用浸漬法、吸附沉澱法與溶膠凝膠法等制備了催化劑，併合成了單壁納米碳管。
  3. The synthesis process of swnts by catalytic chemical vapor deposition ( ccvd ) was investigated and the product was characterized by transmission electron microscopy ( tem ), thermo - gravimetric analysis ( tga ) and raman scattering spectra and so on in this thesis

    本文研究了單壁納米碳管的化學氣相沉積法制備工藝，並運用透射電子顯微鏡（ tem ） 、熱重分析（ tga ）與拉曼（ raman ）光譜等分析手段，對產物及催化劑進行了表徵。
  4. The field emission property of carbon nanotubes could be increased by substitution of nitrogen for some of carbon, however, however, that of bcn nanotubes was poor. 1. study of disordered multi - wall carbon nanotube carbon nanotubes with different diameter distributions have been produced by thermal decomposition of a ferrocene - xylene mixture under different temperatures and different catalysts in an ar ( or n2 ) / h2 atmosphere

    結合透射電鏡、掃描電鏡及拉曼光譜，系統地研究了以鈷二茂鐵為催化劑時不同溫度下、以及在860時，分別以鈷二茂鐵、鎳二茂鐵、鈷、鎳鈷不同催化劑、不同保護氣體對高溫熱解法制備的多壁碳納米管結構、產率等的影響，對產物的形態、結構進行分析。
分享友人
分享到 Line

分享到臉書