透射路程 的英文怎麼說

中文拼音 [tòushèlùchéng]
透射路程 英文
transmission path
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 路程 : distance travelled; journey
  1. In simulations, all important phenomena, such as non - neutral sheath widening near cathode, cathode electron emitting, current channel migrating to the load side of the plasma, ion accelerating toward cathode and magnetic insulation of cathode emitting electrons etc, have been observed and depict the internal physics of this device. also presented is the influence of cathode emitted electrons on phenomena in the conduction processes of pegs. the simulation results show, without cathode emitted electrons, rapid magnetic field penetration takes place only in region near the cathode, with cathode emitted electrons, magnetic field penetration takes place in all plasma region

    診斷發現了陰極表面非中性鞘層的形成、陰極電子發射、電流通道的漂移、等離子體離子加速以及陰極電子磁隔離等物理現象，揭示了這一斷路器件的物理機制；分析了陰極電子對peos導通過程中的物理現象的影響，模擬結果顯示：忽略陰極電子作用，磁場滲透現象主要出現在陰極表面區域，考慮陰極電子作用，磁場滲透現象出現在整個等離子體區域。
  2. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  3. In this thesis, modeling of the characteristic of the ir jamming is discussed. the attenuation characteristic of ir radiation through atmosphere is analyzed and the atmospheric permeance of ir radiation is given. the design ideas and implementation method to generate dynamic ir images with computer are addressed

    在論文中，討論了干擾彈的建模，分析了紅外輻射在大氣中的衰減，總結出大氣透射比的工程計算方法，論述了本文動態生成紅外圖像的設計思路和實現方法。
  4. By using x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ), differential scanning calorimeter ( dsc ) and optical microscopy, mechanical activation is investigated. and during the study, two new innovative processes or thoughts, " dual activation reactive milling " and " in situ synthesis in salt bath activated by ma " has been presented for the synthesis of nanometer - sized powder. the phase transformation and oxidation control of cu - cr system during ma is also investigated

    在採用x射線衍射分析（ xrd ） 、掃描及透射電子顯微鏡（ sem tem ） 、能譜分析（ eds ） 、熱分析（ dsc ） 、激光粒度測試等試驗手段對ma過程機械激活作用的研究中，發現並提出了「雙重激活反應研磨」和「機械激活鹽浴合成」兩種創新工藝思路；同時，對cu - cr難互溶體系在機械合金化過程中飽和固溶體、氧化物非晶的形成以及氧化現象的控制進行了探討分析。
分享友人
分享到 Line

分享到臉書