透磁合性 的英文怎麼說

中文拼音 [tòucígěxìng]
透磁合性 英文
permally
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  1. Studies on the electromagnetic wave transmission performance of concrete combined with znow crystal fibril

    與硅酸鹽水泥復合材料的電磁波透射特性研究
  2. The composition of sample was identified by means of x - ray diffractometer ( xrd ). magnetic properties were measured by vibrating sample magnetometer ( vsm ). the combustion behavior and crystallization process of the gel were studied by means of differential thermal analysis - thermogravimetric analysis ( dta - tg )

    利用x射線衍射儀（ xrd ）確定樣品物相，振動樣品磁強計（ vsm ）進行磁性測量，綜合熱分析儀研究凝膠的燃燒和析晶過程，掃描電子顯微鏡（ sem ）和透射電子顯微鏡（ tem ）觀察粉末的形貌與粒度。
  3. The paper mainly focused on the beam transport part of asipp key laboratory of ion beam bioengineering and it ' s component elements, for example, van de graff accelerator, bending magnet, magnetic quadruple lenses, beam shutter, collimator and so on. the laboratory has performed the milestone achievement that is beam passed the hole of lo ^ m diameter in experiments. many experimental results are discussed by theories according to experiments

    本文重點討論了中科院離子束生物工程學重點實驗室單粒子束裝置的束流傳輸部分，對主要部件進行了詳細的討論，如：靜電加速器、偏轉磁鐵、磁四極透鏡、束線開關、瞄準器等，實驗中已取得束流穿過10 m小孔的標志性成果，並運用相關理論結合具體實驗分析了實驗結果。
  4. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  5. The permeation rate of n2, o2, co2, the thermal infrared emissivity and radar absorption of composite film were measured

    在性能研究方面，測試了復合膜對n2 、 o2 、 co2的氣體滲透速率的影響以及復合膜的熱紅外輻射和電磁波吸收性能。
  6. Nano - composite nd2fe14b / - fe magnetic material has been prepared by mechanical milling nd2fe14b alloy under ar2 and subsequent crystallization at different temperature. effect of ball milling ( attritor mechanical milling and planetary mechanical milling ) and crystallization technique on structure and magnetic of nanocomposite nd2fe14b alloy has been analyzed by xrd, sem, tem and ppms

    通過x射線衍射（ xrd ） 、掃描電子顯微鏡（ sem ） 、透射電子顯微鏡（ tem ）和物理性能測試系統（ ppms ）著重研究了不同球磨工藝（攪拌式球磨與行星式球磨）及晶化處理工藝參數對納米復相nd2fe14b合金組織結構和磁體性能的影響。
  7. The high - performance heat - reflective coated glass is also called sunlight control coated glass it is made by coating a number of metal or metal compaound films onto the high - quality float glass or other base glass with the vacuum magnetic control sputtering method, which can effectively control the reflection, transmission and absorption of solar energy, that is to say, this glass allows sufficient natural light to come in for daylighting, and can also reflect major part of sunlight irradiation to reduce the collection of indoor heat and lower down the expenses for ventilation and air conditioning ; furthermore, the transmission, reflection ratio and reflection color are ready for the selection by the users

    高性能熱所射鍍膜玻璃也稱為陽光控制鍍膜玻璃，是在優質浮法玻璃或其他基片上用真空磁控濺射的方法鍍多層金屬或金屬化合物薄膜而成，可有效控制玻璃對太陽能的反射、透過和吸收，也就是說允許足夠的自然光進入室內用於採光，還能把大部分太陽光輻射熱反射掉，減少室內熱量的積聚，降低通風及空調的費用，而且可以根據客戶的需求，靈活選擇透過率，反射率及反射顏色。
  8. The first section includes the theoretical and numerical analysis for diffractive optics elements and the second one gives the results of the fabrication experiments of diffractive optics elements. in the first section, we analyzed the antireflection of the diffraction optics elements. binary optics processing methods may be applied to a glass or silicon substrate to generate an array of small columns in order to enhance transmission

    在理論分析的部分，本論文完成的主要工作是用耦合波理論分析了在玻璃或硅基底上製作具有亞波長結構的圓柱形網格陣列以實現對入射光的增透作用，為此而編寫的程序實際上也可以用來分析計算單位周期內具有任意麵形的網格光柵的電磁場衍射特性。
分享友人
分享到 Line

分享到臉書