透鏡光譜儀 的英文怎麼說

中文拼音 [tòujìngguāngpǔyí]
透鏡光譜儀 英文
lens spectrometer
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 譜 : Ⅰ名詞[書面語]1 （按類別或系統編成的書或冊子等） table; chart; register 2 （指導練習的格式或圖形）...
  • 儀 : 名詞1 （人的外表） appearance; bearing 2 （禮節; 儀式） ceremony; rite 3 （禮物）present; gift 4 ...
  • 透鏡 : [物理學] lens; optical lens
  1. The components, microstructure, luminousness, thickness and surface topography of the films were analysised via xrd, uv ? vis, xps, ellipsometric examination and stm. the photocatalytic properties of these fims are characterized by the decomposition rate of methylene blue or rhodamine b. the effect of sputtering power, temperature, o2 mass flow, bias, w - doping and sputtering time on photocatalytic properties are discussed

    採用x射線衍射儀、紫外-可見光分光光度計、 x光電子能譜儀、薄膜厚度測試儀及掃描探針顯微鏡等測試手段，研究分析了薄膜的組分、結構、透光率、膜厚和表面形貌等。
  2. The structure of wpu emulsion was analyzed and characterized by ft - ir, malvern particle size analyzer, gpc and tem

    通過傅立葉變換紅外光譜、粒徑分析儀、凝膠滲透色譜（ gpc ）和透射電鏡（ tem ）對乳液進行了結構分析與表徵。
  3. In this paper, the property difference of sio2 sols used for preparing thin films by esam method or sol - gel process has been discussed. three kinds of sio2 sols were prepared, catalyzed by hcl or nh3 h2o only, or hcl first and then nh3 h2o respectively ( please note : in following text, the sio2 sol catalyzed by hc1 first and then nh3 h2o and its correspondent films will be named sio2 sol 1 # and film 1 ; the sio2 sol catalyzed by nh3 h2o only and its correspondent films will be named sio2 sol 2 # and film 2 # ). through investigating the assembling properties of the sols, observing thin films " microscopic structure with tem and testing their transmissivity with 721 spectrophotometer, we find that the first kind of sol is not suitable for preparing esam films, but the last two, i. e. sol 1 # and sol 2 #, are good

    本文討論了esam法制備薄膜所用的溶膠與sol - gel法所用的溶膠在性能上的區別，在hc1或nh _ ? h _ 2o分別單獨催化和hc1 nh _ 3 ? h _ 2o分步催化三種催化條件下制備了sio _ 2溶膠（以下規定hc1 nh _ 3 ? h _ 2o分步催化的sio _ 2溶膠為1 ~ #溶膠，相應的薄膜為1 ~ #薄膜， nh _ 3 ? h _ 2o催化的sio _ 2溶膠為2 ~ #溶膠、相應的薄膜為2 ~ #薄膜） ，在通過組裝薄膜並用透射電鏡（ tem ）觀察薄膜微觀結構以及用721分光光度計測試樣品的光透射率，得出了后兩種催化方法所制備的溶膠適合於esam法鍍膜，而第一種溶膠不適于用此法鍍膜的結論，用傅立葉紅外光譜（ ft - ir ）研究了溶膠組成；用差熱失重分析儀（ dta - tg ）對膠體進行了熱分析。
  4. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  5. The infrared spectroscopy, transmission electron microscopy, light scattering and x - ray photoelectron spectroscopy are used to characterize the polymer structure and the morphology of the latex particles. the results demonstrate that composite latex with core / shell morphology is indeed successfully prepared

    利用紅外光譜、透射電鏡、激光粒度儀、表面能譜分析等手段對聚合產物的化學結構及乳膠粒粒子形態進行了表徵。
  6. According to the principle of correlation detection, an automatic measurement system for extinction ratio of polarizer consisted of monochromator and dsp lock - in amplifier and compurer is designed not only to eliminate the influence on measurement accuracy caused by drift of intensity of light source but also to obatain approximate extinction spectrum

    摘要基於相干檢測原理設計了一套由單色儀、數字鎖相放大器和計算機聯合使用的透射式偏光鏡消光比智能化測試實驗系統，採用雙頻雙光路分光單探測器接收鎖相放大器分離信號比對法進行源補償測量，克服了光源光強漂移所帶來的影響；實現了可見光區消光比的精確自動測量，而且可以測得近似的消光光譜。
  7. The surface restoration layer of a gear wheel, which had run in lubricating oil with pbc restoration agent was analyzed using tem, sem, xps, aes and raman ; and the mechanism of reducing friction of the restoration agent was studied

    以透射電鏡、 x射線光電子能譜儀、俄歇電子能譜儀和拉曼光譜儀分析了在添加摩聖修復劑的潤滑油中運行過的齒輪表層，對摩聖修復劑的減摩機理進行了分析。
  8. Carbon nanofibers, well - aligned carbon nanorods and alignend carbon nanotubes could be synthesized on the porous aao template with catalysts by chemical vapor deposition method. the morphology of co and fe - co alloys deposited in the template and the microstructure of the carbon nanostructures synthesized on the template were systematically investigated by means of sem, tem, eds and raman spectrum

    採用掃描電子顯微鏡（ sem ） 、透射電子顯微鏡（ tem ） 、能譜儀（ eds ）和喇曼光譜（ raman ）等對在多孔aao模板上電沉積得到的co和fe ? co合金催化劑的表面形貌以及在多孔aao模板上制備得到的碳納米結構進行了系統的觀察分析。
  9. Binary optic imaging spectrometer is a practical image spectrometer that can be built to operate at ultraviolet, visible or infrared wavelengths for applications in surveillance, remote sensing, medical imaging, law enforcement, environmental monitoring, and laser counter intelligence

    利用二元光學透鏡軸向色散的凝視成像光譜儀在理論上是可行的，它可設計為工作在紫外、可見、和紅外波段用於空間監視、遙感、醫學成像、環境監測等方面。
  10. The samples were characterized by x - ray diffraction ( xrd ), optical spectroscopy, transmission electron microscopy ( tem ) and scanning tunneling microscopy ( stm ). as a result, a self - assembled monolayer ( sam ) of msa on the surface of fee au particles was directly observed in atomic level

    在此基礎上，對金納米粒子和其自組織結晶體進行了一系列的x射線衍射儀（ xrd ） 、透射式電子顯微鏡（ tem ） 、光吸收譜和掃描隧道顯微鏡（ stm ）的檢測和分析。
  11. Optics and optical instruments. contact lenses. determination of the spectral and luminous transmittance

    光學和光學儀器.隱形眼鏡.光譜和光透射率測定
  12. Optics and optical instruments - contact lenses - determination of the spectral and luminous transmittance

    光學和光學儀器.接觸鏡片.光譜和光透射率的測定
  13. Optics and optical instruments - contact lenses - determination of the spectral and luminous transmittance iso 8599 : 1994 ; german version en iso 8599 : 1996

    光學和光學儀器.隱形眼鏡.光譜透射率和光透射率測定
分享友人
分享到 Line

分享到臉書