速度限制信號 的英文怎麼說

中文拼音 [sùdùxiànzhìxìnháo]
速度限制信號 英文
restricted speed signal
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  • 限制 : place [impose] restrictions on [to]; astrict; restrict; limit; confine; shut down on [upon]: 限制...
  1. Due to the hardware characteristic ' s limitation, such as the poor speed of a / d, d / a conversion and dsp process, the most part of sr system adopt middle course. that is to say, by using the special digital converter or running relevant arithmetic, it converts the radio signal to intermediate frequency signal and completes the base - band signal process that is n ' t the veriest sr and is named " software defined radio ( sdr ) "

    由於受到硬體性能如a d 、 d a及dsp晶元處理速度的限制，目前的軟體無線電系統多採用折中的實現方案，增加專用的數字變頻器或者運行數字變頻演算法，將射頻信號變頻到中頻，然後再進行基帶信號處理，這樣的軟體無線電系統又被稱之為「軟體定義無線電」 ，它並不是真正意義上的軟體無線電。
  2. Article 35 fire trucks and fire boats, when rushing for fire fighting and rescue work or relief and rescue task for other disaster and accidents, shall not be restricted by its driving speed, driving route, driving direction and traffic signals ; other vehicles, ships and pedestrians must make way and shall not conduct overtaking

    第三十五條消防車、消防艇前往執行火災撲救任務或者執行其他災害、事故的搶險救援任務時，不受行駛速度、行駛路線、行駛方向和指揮信號的限制，其他車輛、船舶以及行人必須讓行，不得穿插、超越。
  3. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  4. The principle of vibrator is to introduce scattered energy to underground in a comparatively long time, and collect the energy through correlation and compress it into a narrow pulse. the portable high - frequency vibrator system, developed by key lab of geo - exploration and instrumentation ( jilin univ ), ministry of education, generates chirp signal and accumulates energy through a long - time bestiring. according to the characteristics of vibrator, the seismic recorder that operates on - line with vibrator must have these functions as follow : first, it must have the ability of recording a great quantity of data. second, it must have assistant channels to sample reference signal. third, it must have the function of data correlation in real - time

    可控震源利用可控的小能量、長時間激發波來實現沖擊震源瞬時產生的大能量激發波。在利用可控震源進行地震勘探時，要求地震儀長時間記錄地震信號，這對地震儀的采樣長度提出了很高的要求。受存儲量和數據傳輸速度的限制，絕大多數地震儀很難對如此大的數據量進行記錄，同時，可控震源要求地震儀有兩個輔助通道並且具有數據相關功能，目前國內還沒有出現滿足要求的地震儀產品。
  5. The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on

    主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。
  6. In this paper, the mechanism and practical effect of existing coordinated control schemes are analyzed in detail, the advantage and drawback of the different coordinated control methods in practice are indicated clearly. this paper describes a fact that it is difficult to obtain rapid load response and stable main parameters at the same time by using the recent methods, underlines that heat release is the vital parameter that should be carefully controlled

    本篇在吸取了目前各種協調控制系統的優點的基礎上，提出了改進后的協調控制方案，主旨為以控制鍋爐的熱量釋放信號為核心，採用具有內在穩定特性的控制方案，充分加快機組的負荷響應速度，在機組所帶負荷已經接近當時的極限，及時限制輸出功率的增長，達到穩定機組的目的。
  7. The air - fuel ratio closed loop control adjusts the air - fuel ratio near the theoretical value by controlling the supplementary air of supplementary valve based on the signals of oxygen sensor, running speed and water temperature and which is necessary condition for three - way catalyst converter to work more efficiently

    空燃比閉環控制是根據氧傳感器、轉速和水溫信號，控制化油器后補氣閥補氣將空燃比控制在理論值附近，為三元催化轉換器高效工作準備必要條件，使其最大限度降低尾氣排放。
  8. Because of the quick development of microprocessor and all kinds of field - buses, distributed control skills applied in microcomputer on - board are becoming possible in order to collect local signals and to drive local objects, at the same time lots of signal wires can be reduced in order to simplify the internal circuits

    由於微處理器技術和各種總線技術的迅速發展，使得在車載微機系統中應用分散式控制技術成為可能，以實現信號的本地採集、本地驅動，同時避免大量信號線的往返，可以最大限度的減少、簡化機車內部的連線。
  9. By studying the discrete fourier transform properties of the band - limited digital signal, the authors introduce alternating projection neural networks into the paper, expand apnn ' s application scope from real field to complex field, and present several important conclusions on apnn. analyzing and discussing network ' s tolerance to noise, convergence rate and the spectral leakage problem of the truncated signal expected to be extrapolated by using these conclusions, the paper presents an extrapolation algorithm for band - limited signals based on alternating projection neural networks. a lot of simulation experiments show that the algorithm is effective. in addition, the algorithm is also effective to spectrum extrapolation. owing to adopting network structure, the algorithm is prone to parallel computation and vlsi design, and consequently can satisfy real time military processing needs

    本文通過對頻帶受限數字信號的離散傅立葉變換特性的研究，引進了交替投影神經網路，並將其應用范圍從實數域拓廣到復數域，且給出了在復數域仍然成立的若干結論.運用這些結論，在對網路噪聲抑制、網路收斂速度及待外推信號因截斷而造成頻譜嚴重外泄問題的分析與討論的基礎上，提出了一種基於交替投影神經網路的外推演算法.模擬實驗表明該方法是行之有效的.另外，該演算法對頻譜外推同樣適用；由於它採用全互連神經網路結構，易於并行計算和vlsi實現，從而可滿足軍事上實時處理的需要
  10. By the advantage of high precision, strong anti - interference ability, long lifespan, etc, grating scale is the chief sensor in displacement measurement. however, as is restricted by the beam path structure, the scan frequency of the scaning circuit, etc, the maximum available measuring speed has a inverse proportion relationship to the measuring pace of a single grating scale

    光柵尺具有精度高、抗干擾能力強、壽命長等優點，成為微納米位移測量的主要工具，但由於受光路結構及信號檢測電路掃描頻率等因素的限制，單個光柵尺測量的最大允許移動速度與其測量步距成反比。
  11. Because of the artifactitious limit, this thesis only can choose a similar accelerometer to carry on the digital signal processing to the signal

    因為加工工藝的限制，本文只能選擇一款與其相似的加速度傳感器對其信號進行數字信號處理。
  12. The vertical delay stacked source obtains optimum matching with wall rock by controlling the charge mode and the excitation velocity, and maximum utilizes its energy. thus the seismic signal with the high frequency abundance and frequency bandwidth wide be obtained

    垂直延遲迭加震源通過控制裝藥方式和控制炸藥速度來達到與圍巖的最佳匹配，最大限度的利用其激發的能量，激發出高頻成份豐富、頻帶寬、高頻能量高的地震信號。
  13. The table is a important device in the hardware - in - the - loop simulation system, and it simulates the flight of unmanned aerial vehicle so as to achieve flying parameters from those sensors. the signals of sensors in the table are transmitted by many cables previously, thus it confines the movement range of the three - axis frameworks. as the perfomance of uav become complicated, the signals cables are replaced by wire rings in some tables, but it brings many difficulties and unreliable factors for the simulation table ’ s design also. bluetooth, as a new short - range wireless communication technology, is a reasonable and feasible scheme in this condition

    三軸模擬轉臺是無人機地面半實物模擬系統中的重要設備，用來模擬飛機在空中的姿態和角運動，以驅動傳感器產生飛行姿態、角速度及角加速度信號。早期轉臺上傳感器信號通過穿在框架中的電纜進行傳輸，這就限制了框架的運動范圍。隨著無人機任務的復雜程度不斷提高，出現了採用導電滑環傳遞信號的模擬轉臺，但這也給轉臺設計帶來了困難，且存在不可靠因素。
  14. As the system is regarded as being excited by a constant direct current at the data acquisition point, no complex ac circuit such as filter is required. it can improved the rate of data acquisition and simplify the circuitry of ert system

    由於系統採用了直流脈沖信號作為系統的激勵源，后續的信號處理電路就可以直接獲得測量結果，無需復雜、耗時的濾波電路，這就消除了濾波器這一限制數據採集速度提高的「瓶頸」問題。
分享友人
分享到 Line

分享到臉書