速沉質點 的英文怎麼說

中文拼音 [sùchénzhídiǎn]
速沉質點 英文
quick-setting particles
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 沉 : Ⅰ動詞1 （沉沒; 墜落） sink 2 （沉下 多指抽象事物） keep down; lower 3 [方言] （停止） rest Ⅱ形容...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  1. Compared with the mud on wall form hole technology, clash stake technology or vibration sink pipe technology used in complex foundation stake forming, it has advantages of no vibration, no pollution, and no noise. in addition, since the concrete pressed into the drill stem sent vibration free concrete to the pump, so it is eas y to ensure the quality of the stake body. compared with the mud on wall and dry work form hole technology, the side obstruction and end obstruction of screw drill press concrete stake have all been accordingly improved, the weight bearing is better, and the transmutation of the complex foundation is less

    其中，螺旋鉆孔壓灌混凝土成樁技術自研製以來，已在多項復合地基工程中進行了應用，較好地解決了軟弱地層成孔困難的問題，適應地質條件范圍廣，成樁速度較快，工期短、工效高；與復合地基成樁時的泥漿護壁成孔工藝、振沖樁工藝或振動沉管工藝施工比較，具有無振動、無污染、無噪音的優點；另外，壓入鉆桿內的混凝土為泵送免振混凝土，因此樁體質量易於保證；與泥漿護壁和干作業成孔工藝相比，螺旋鉆孔壓灌混凝土成樁的側阻和端阻都有相應的提高，樁的承載性能較好，復合地基的變形較小。
  2. The basin - formed mechanism, evolution model and petroliferous geological features of compresso - shear basins in the world are analyzed, by which six aspects of the features are summarized as follows : 1 ) in the compresso - shear process, the sedimentary speed of basin is high, forming thicker coarse - grained clastic rocks which normally shape good petroleum reservoir ; 2 ) the source rocks of basin tend to coming from the organic matter - enriched rocks formed in pre - compresso - shear stages, except that in intense compresso - shear process, deep water - semi deep water source rocks are possibly developed in pre - compresso - shear stages, e4xcept that in intense compresso - shear process, deep water - semi deep water source rocks are possibly developed in frontal of deep depression ( fore deep ) of thrust belt ; 3 ) the en echelon folds ( including anticline and fault - nose structure ) are generally as good oil traps ; 4 ) the compresso - shear process is helpful to hydrocarbon accumulation ; 5 ) it may promote the maturity and hydrocarbon - generating process of organic matte, and 6 ) the thrust belts in the surrounding areas of compresso - shear basin are favorable are favorable domains for petroleum concentration

    摘要通過對世界上壓扭性盆地的成盆機制、演化模式和油氣地質特點分析，總結壓扭性盆地具有6個方面的石油地質特徵：壓扭作用期間盆地的沉積速率較高，一般形成較厚的粗碎屑沉積，它們常構成很好的油氣儲集層：盆地的烴源巖往住來自於前壓扭期砂成的富含有機質的巖石，但在強烈的壓扭作用期間，在沖斷帶的前緣深坳陷（前淵）中有可能發育深水半深水相的烴源巖；壓扭（張扭）作用期間形成的雁行式褶皺（包括背斜和斷鼻等）往住是很好的油氣圈閉；壓扭作用易於成藏；壓扭作用可以促進有機質的成熟生烴作用；壓扭性盆地的周邊沖斷帶是油氣賦存的有利部位。
  3. Variance index of the settlements of soft clay subgrade was inducted to analyze the asymmetry settlement rules under the influence of depth of fill, fill speed, geologic types of soft clay etc

    利用這些觀測數據，引入路堤斷面中點和兩側坡腳地基表面3點沉降的方差這一統計學指標，詳細分析了地質結構，填築速率、填築高度以及硬殼層等因素對軟基不均勻沉降的影響，得到了一些有意義的結論。
  4. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  5. In view of its virtue of high degree of electron and ion generations, the microwave electron cyclotron resonance ( mwecr ) cvd method is expected to deposit device quality a - si : h at high deposition rate

    鑒于微波電子迴旋共振化學氣相沉積（ mwecrcvd ）系統具有電子和離子產生率高等優點，人們期望它能在較高的沉積速率下獲得器件級質量的a - si ： h薄膜。
  6. With the development of thin film science and technology, various thin film preparation techniques developed rapidly, as a result, conventional so - called filming has developed from single vacuum evaporation to many new film preparation techniques, such as ion plating, sputtering, laser deposition, cvd, pecvd, mocvd, mbe, liquid growth, microwave and mtwecr, etc., of which vacuum evaporation is the common technology for thin film preparation, because it has the distinct advantage of high quality of film deposition, good control - ability of deposition rate and high versatility

    隨著薄膜科學與技術的發展，各種薄膜制備方法得到了迅速發展，傳統的所謂鍍膜，已從單一的真空蒸發發展到包括蒸鍍、離子鍍、濺射鍍膜、化學氣相沉積（ cvd ） 、 pecvd 、 mocvd 、分子束外延（ mbe ） 、液相生長、微波法及微波電子共旋（ mwecr ）等在內的成膜技術。其中電子束蒸發技術是一種常用的薄膜制備技術，它具有成膜質量高，速率可控性好，通用性強等優點。
分享友人
分享到 Line

分享到臉書