速率調整節器 的英文怎麼說

中文拼音 [sùlǜdiàozhěngjiéqì]
速率調整節器 英文
rate regulator
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 速率 : speed; rate; tempo
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  2. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  3. In this dissertation, two kinds of optimization, methods are proposed. firstly, only these linking weights corresponding to the control rules that affect the control performance significantly are updated in order to reduce the compute works and speed up the training progress. secondly, the updating step is adjusted adaptively in accordance with the error and the change of error of the system based on the t - s model to get better performance

    針對模糊神經網路控制器一般存在著在線權值調整計算量大、訓練時間長、過度修正權值可能導致系統劇烈振蕩等缺點，提出了兩種模糊神經網路控制器的優化方法：在線自學習過程中僅對控制性能影響大的控制規則相關的權值進行修正，以減小計算量，加快訓練速度；基於t - s模糊模型，根據偏差及偏差變化率大小動態自適應調節權值修正步長，抑制控制器輸出的劇烈變化，避免系統發生劇烈振蕩。
  4. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  5. Secondly, to achieve the independent regulation of active and reactive power output from the generator side which is designed for the purpose of tracing the maximum wind - energy capturing. the paper has analyzed the mathematic model of the ac excited doubly - fed machine and the stator field orientation control strategy of the motor as vscf wind power generator. thirdly, it has put forward and designed the dual pwm converter with the capacity of energy flowing bidirectional aimed at the demand of rotor energy bidirectional flow. the author constructed reliable and integrated experimental system and did a series of experimental study including no - load, cutting - in network and power generation at, below and above the synchronous speed

    論文首先分析了風機運行特性及其最佳風能利用原理，通過模擬及實驗驗證了採用直流電機的輸出特性模擬風力機的最大輸出功率曲線的可行性，並給出了模擬系統的硬體結構；然後為了實現交流勵磁發電機有功、無功功率獨立調節機理，分析了交流勵磁雙饋發電機的數學模型和在追蹤最大風能捕獲變速恆頻風力發電時必需的定子磁鏈定向矢量控制策略；針對雙饋發電機轉子能量雙向流動的要求，提出並設計了具有能量雙向流動能力的雙pwm交流勵磁用變頻器；最後為實現從理論到實踐的全面研究，研製出了一套小功率完整的雙pwm變頻器交流勵磁的雙饋風力發電機實驗系統，進行了空載、並網、同步速及上、下的發電運行等一系列的運行實驗；所完成的模擬和實驗研究均驗證了理論、模型和控制策略的正確性、可行性。
  6. A new method, which uses shaping circuit and programmable computer controller with appropriate software to measure frequency, is initially applied which overcomes the problems of low reliability and slow responding process of traditional frequency measurement unit, improves the reliability and dynamic quality of frequency measurement and expedites the responding speed effectively

    首次提出了一種由整形電路和可編程計算機控制器配以適當軟體完成頻率測量的方法，有效地解決了plc調速器測頻環節存在的可靠性差及響應速度慢的問題，提高了頻率測量的可靠性及動態品質。
  7. With the conduction property of the triggered thyristor and the intellective numerical controlled frequency reduction of the triggering pulse by mpu, we can divide alternating current into several complete sinusoidal waves to supply some loads. it can be made as a controller or a pcb ware, which is suitable for the air conditioning, machine tool and various instruments that require electric power or rotate speed adjustment

    利用晶閘管的觸發導通特性，用單片機對觸發信號進行智能數字降頻，可在交流電中切分出部分完整的正弦波形供負載使用，可以單獨做成一臺控制儀器或者作為一個控制電路板用於需要電功率和轉速調節的空調、機床以及各類儀器設備中。
  8. According to the present problems and developing tendency of hydraulic turbine governor, four main issues of this field are studied in this paper. the content include hydraulic control system, frequency measurement unit, stability of the discrete control system, optimization of control parameters and self - adjusting pid control strategy based on fuzzy logic. several main achievement and results are obtained and shown as follows : the electric - hydraulic pilot valve driven by step - motor is firstly proposed, which solves the problem that the electric - hydraulic converter of hydraulic turbine governor hydraulic servo is prone to be stuck and blocked and improves the systemic stability greatly

    本文根據水輪機調節領域存在的問題和發展趨勢，對水輪機調速器的液壓控制系統、頻率測量環節、離散調節系統穩定性與調節參數最優整定以及適應式參數自調整pid控制策略進行了研究，得到以下主要成果和結論：首次提出了採用步進電機驅動的步進式電液引導閥，從根本上解決了水輪機調速器電液隨動系統中存在的電液轉換元件發卡、堵塞問題，使電液隨動系統的可靠性大大提高。
  9. It can improve the utilize of power by fed back the power generated by motor machine to power - net, has the benefit of improving power factor, reducing the harmonious feeding back to the power - net and can enhance the performance of converters for the constant voltage of dc - link

    該裝置能夠提高電能的利用率，把由電動機產生的再生能源回饋到交流電網，並且能提高裝置的功率因數，減少對電網的諧波污染。由於pwm整流，變頻器中間直流環節的電壓能保持穩定，提高了逆變器的調速性能。
  10. Three - phase full bridge controlled rectifier, filter circuit and the common loads " mathematics models are built and analyzed. according to the rate of the transition process, the controlled rectification power supply can be classified into fast response and slow response. based on identification of the transition processes using the slope method, the different fuzzy control strategy is adopted. the control method can meet the requirements of real time control and non - error regulation. the simulation results verify its practibility. after that. the design scheme based on dsp is introduced including the design of hardware and software flow chart. emc is an important aspect which can not neglected, so the designs of emc are summarized including hardware and software

    根據過渡過程的快慢將可控整流電源系統分為快響應過程和慢響應過程，本文在利用響應曲線斜率法辨以過渡過程的基礎上，分別針對快響應過程和慢響應過程採取了相應的模糊控制策略，以滿足快響應過程要求實時控制，快速跟蹤誤差變化，慢響應過程要求精確定位，無差調節的要求，模擬結果驗證了該方法的有效性，進而分析了用dsp實現該調節器的硬體電路和軟體流程的設計思路。
  11. But it has main key problems such as long response time, low speed stiffness, imperfect control performance and efficiency because " of. it includes inverter and electromotor. the main research contents are as follows

    但是，由於大功率大慣性變頻泵控馬達調速系統包括了變頻器和電機環節，使得整個調速系統存在響應慢、速度剛性低、控制特性差及效率等主要難點問題。
分享友人
分享到 Line

分享到臉書