速變振蕩器 的英文怎麼說

中文拼音 [biànzhèndàng]
速變振蕩器 英文
velocity-variation oscillator
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光的發展狀況、主要特性及其應用,從四能級率方程出發,推導了ld泵浦nd : yag激光的閾值、輸出功率和斜效率的表達式,並簡述了激光的工作原理、結構型式和倍頻方法;其次,以空間相關的率方程為基礎,提出了ld端面泵浦nd : yag激光的設計方法,給出了一定泵浦耦合方式下,光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據,以此為依據,設計了自聚焦透鏡耦合小功率ld泵浦nd : yag激光和透鏡組耦合高功率ld泵浦nd : yag激光,對激光的輸出功率和功率穩定性等特性進行了實驗研究;再次,在帶尾纖輸出的高功率ld泵浦nd : yag激光腔內插入一隻空液晶盒,觀察到了激光以單縱模運轉;最後,根據泵浦光焦斑端面位置對激光輸出功率的影響規律,提出了ld端面泵浦nd : yag激光位移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光晶體內泵浦光平均光斑半徑遠小於西安理工大學碩士學位論文光束腰半徑時,激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯化規律,測量范圍和靈敏度依賴于泵浦功率,隨著泵浦功率的增加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大輸出功率為1 . 926w )時,激光位移傳感的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. In this dissertation, two kinds of optimization, methods are proposed. firstly, only these linking weights corresponding to the control rules that affect the control performance significantly are updated in order to reduce the compute works and speed up the training progress. secondly, the updating step is adjusted adaptively in accordance with the error and the change of error of the system based on the t - s model to get better performance

    針對模糊神經網路控制一般存在著在線權值調整計算量大、訓練時間長、過度修正權值可能導致系統劇烈等缺點,提出了兩種模糊神經網路控制的優化方法:在線自學習過程中僅對控制性能影響大的控制規則相關的權值進行修正,以減小計算量,加快訓練度;基於t - s模糊模型,根據偏差及偏差化率大小動態自適應調節權值修正步長,抑制控制輸出的劇烈化,避免系統發生劇烈
  3. The detail study on the interaction between the electron beam and standing wave of complex cavity gyrotron with gradual transition and gyroklystron has been done in this dissertation, supported by the pre - study important items " the study on 8mm third harmonic gyrotron with a permanent magnet system " and " the study on 8mm high power gyroklystron ". the main works of this dissertation are listed as following : 1. the study on the rf distribution of the complex cavity with gradual transition is presented, in which the multi - modes coupling are taken into account

    本論文就是結合該課題組的「九?五」重點項目「 8mm三次諧波永磁包裝迴旋管技術的研究」及「十?五」重點項目「 8mm高功率迴旋調管技術的研究」 ,對以諧腔為互作用高頻系統的迴旋脈塞件中兩種典型的件? ?迴旋管及迴旋調管中電子注與駐波場的互作用進行了深入細致的探討和研究,其中迴旋管採用的是漸復合腔。
  4. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念,建立了正弦脈寬調制( spwm )逆供電異步電動機,考慮主磁路飽和時的頻調系統整體數學模型,模擬系統的低頻;其次從逆-異步電動機系統能量轉換角度出發,提出通過檢測逆輸入電流中負電流的間隔時間是否大於1 / f _ c ( f _ c為逆載波頻率)來判定系統是否出現低頻;最後的實驗結果驗證了系統低頻建模和判據的實用性和正確性。
  5. The frequency and mode of the generated microwave are very pure. these results can provide a possible method for constructing a compact high - power microwave device. in addition, a virtual cathode oscillator with an axially extracted te11 mode based on the spark05 accelerator in our laboratory has also been investigated using the pic simulation code

    基於spark05加電子束參數設計的軸向提取te11模虛陰極,利用類似的設計思想,通過改電壓的饋入方式和陰陽極結構,實現了中心陰極負脈沖電壓的激勵,同樣獲得了較好的粒子模擬優化結果。
  6. A x - band six - cavity tro is studied. with the voltage 760kv 6ka and the magnetic field 2. 6t in the simulation, output power is about 1. 5gw is obtained, and interaction efficiency is 31 %. a noveland high accurate numerical synthetic technique is presented for determining the high frequency characteristics of six - cavity with open boundary

    對粒子模擬的輸出微波功率的作出診斷,找到讀取微波功率快有效的方法:在電場和磁場同相的前提條件下,對時域波形進行傅立葉換,微波功率頻域的二倍頻所對應的幅度即為微波x波段渡越輻射的理論和實驗研究平均功率的大小。
  7. A square sensing area was formed upon each of the saw propagation paths using photoresist. when some kind of material deposits on this area, the saw propagation velocity will decrease due to the mass - loading effect, causing a shift in the device ' s oscillation frequency, which gives indication of the mass deposited. the dual - path architecture, one for sensing and one for reference, was used to compensate for the disturbance of temperature

    利用光刻工藝在每個聲傳播路徑上構造了一個方形質量沉積區,當有物質沉積到該區時,由於質量沉積效應,聲表面波的波發生化,使以延遲線作為反饋迴路的頻率發生化,並通過這一化反映出沉積物的質量。
  8. With the rapid advancement of process and technology, especially the realization of on - chip passive elements such as inductors and varactors, the on - chip implementation of voltage - controlled oscillators ( vcos ) which are necessary in wireless transceivers has become easy

    在工藝技術的飛進步下,尤其是電感和容管等無源件片上實現問題的解決,壓控已經可以實現單片集成,這對降低收發機的成本十分關鍵。
  9. A virtual cathode oscillator with an axially extracted te10 or te11 mode based on the tomachan accelerator in our laboratory is investigated using the pic simulation code. the tomachan accelerator can run with an electron beam of 400kev and 8. 9ka

    基於tomachan加電子束參數設計的軸向提取te10 / te11模虛陰極,不需要改束-波作用區結構,只需通過更換提取波導,即可實現te10 / te11模式微波的軸向提取。
分享友人