連續充氣 的英文怎麼說

中文拼音 [liánxùchōngqì]
連續充氣 英文
continuous carbonation
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 充 : Ⅰ形容詞（滿; 充足） sufficient; full; ample Ⅱ動詞1 （裝滿; 塞住） fill; charge; stuff 2 （擔任; ...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  1. Boundary element method analysis of discontinuities in a dielectric - filled rectangular waveguide with air posts

    矩形波導填充帶有空氣柱介質不連續性的邊界元法分析
  2. Abstract : based on the analysis of influence of tubular rib construction on heat transfer area on steel blank and heat transfer space in furnace, a t - shape support system for tubular rib is presented, by which the construction of wholly overhead furnace hearth can be realized for large and medium scale continuous reheating furnaces, making furnace gases to come into full contact with steel blank, raising space utilization ratio of furnace chamber and improving heat exchange

    文摘:分析了爐筋管結構形式對傳熱空間、坯料受熱面積的影響；提出採用t形支撐技術優化爐筋管，可實現大、中型連續加熱爐的全架空爐底，使爐氣與坯料表面充分接觸，提高爐膛空間利用率，可較大幅度提高爐膛熱交換。
  3. Firstly, the process of fold and deployment was divided into several steps. secondly, the relative geometry results of the last simulation step was picked up as the initial geometry configuration of current step, using the restarting technology provided by fem programs, then the models of a inflatable structure with an paraboloid shape were established

    然後，基於ls - dyna970中的airbag模型，建立了捲曲折疊空間充氣展開管的有限元模型，運用控制體積法將充氣管離散為若干連續的腔，成功模擬了其充氣展開過程，並研究了不同充氣速率對充氣管展開過程的影響規律。
  4. During operation the pump must continuously be supplied with service liquid, normally water, in order to eliminate the heat resulting from the gas compression and to replenish the liquid ring, because part of the liquid is leaving the pump together with the gas

    泵運轉期間需連續不斷地補充工作液（通常為水） ，以帶走氣體壓縮而產生的熱量和補充部分隨氣體排出的工作液。
  5. Dynamic control of the limit water level belongs to non - structural measures of reservoir operation. with the analysis of the cause and rule of flood in the catchments and taking advantage of hydrology and metrology information, the operable method can be obtained which not only satisfies the flood prevention but also takes full advantage of flood resources, and the upper and lower limits of the limit water level are determined with serial hydrology calculation. then, the rule of using the upper and lower limits is put forward to reach a beneficial flood operation with small risk

    汛限水位動態控制方法屬於水庫風險調度的非工程措施范疇，通過分析流域洪水的成因和庫區降雨及致洪規律，結合水庫的蓄泄能力，積極慎重的利用水文氣象預報信息，研究既能滿足防洪要求，又可充分利用洪水資源的可操作性的調度方法，利用水文系列的連續演算方式推求汛限水位的變化范圍，提出使用汛限水位上下限的原則，達到風險較小、效益較大的目的。
  6. The primary measures for control precept are : sufficiently and effectively utilizing the the air compressors " interior data, realizing online surveillance and alarming for failure of the the air compressors " running interior parts ; letting the air compressors running by master and slave manner, by reasonable arranging the alignment of the air compressors, making the masters yielding pressed air and the slaves adjusting the pressure of the air. this decreases the times of loading and unloading greatly and the decreased failure of air compressors and low maintain ; at the same time we adopt abundant value of the set pressure for stabling the compressure. the air compressors become loaded or unloaded ahead by the abundant value ; caning unloading control for saving power, when the air compressors get along with unloading for a while, the system will stop them ; consummating the purposes for control, enhancing offline control for over - press and low - press, continual loading control and unloading control

    經過分析研究，針對原來存在的問題，在控制方案上主要的改進措施有：充分、有效地利用了空壓機的內部參數數據，對空壓機的內部部件的運行情況實現了在線監視及故障報警；對空壓機採用了主、輔結合的運行方式，通過對空壓機加、卸載隊列的合理排序，使空壓機自動實現主機產氣、輔機進行氣壓調節，減少了空壓機的加載和卸載次數；在壓縮空氣壓力的穩定上進行了裕量控制，在壓縮空氣壓力不到供能品質所規定的上、下根就根據一定的裕量提前進行卸載和加載操作；在節約電能方面對空壓機進行了卸載停機控制，當空壓機在一定時間內一直處于卸載狀態，系統就認為該空壓機沒有運行的必要，自動將其停機；完善了控制效果，增加了超壓低壓脫網控制、連續加載控制、連續卸載控制等功能。
  7. The technology process : the waste, through operation stand, to be rationed into the standing majorcombustion room, being ignited by the ignition - burningmachine, upon the principal of burningthree t, fully burned in the major combustion room （ 800 - 1000 ). the remaining waste gas afterburning via flue goes into secondary combustion room for further high temperature oxidizingcombustion. the gas flow after the secondary combustion goes into the highly effective cyclonedust remover, removing the bigger granule of dust, flowing into rapid - cooling spay and washing equipment to absorb acid gas

    廢棄物經操作臺連續定量投入立式爐本全燃燒室，由點火文空燃燒機自動點火，根據三t原則在爐本體燃燒室（ 800 - 1000 ）以充分燃燒，焚燒后產生的殘余廢氣經煙道進入二次燃燒室再經高溫（ 1100 - 1200 ）氧化焚燒，經二次焚燒后的氣體進入高效旋風除塵器，除去顆粒較大的粉塵后，進入急冷塔噴淋洗滌裝置吸收酸性氣體。
  8. Based on the requirement and target of the projects, firstly, pcf bragg grating are investigated theoretically and experimentally. moreover, the effects of filling high refractive index material ( nematic liquid crystal, nlc ) in pcfs on the transmission mechanism and propagation properties are studied by using plane - wave method and finite - element method ( fem ), farther, several novel pcfs are proposed and designed. lastly, we propose and demonstrate a clad - pumped er3 + / yb3 + - codoped fiber laser, which integrate all performances of broad - band tunable wavelength, uniform output power spectrum, high repeat frequency and high average power to together

    本論文選題于國家973 、 863以及國家自然科學基金等項目，結合課題的要求和主要目標，在對光子晶體光纖（ pcfs ）傳輸特性研究的基礎上，首先對光子晶體光纖光柵進行了理論和實驗研究;然後，採用平面波展開法和有限單元法分析了在光纖的空氣孔中填充高折射率液晶對光纖傳導機制和傳輸特性的影響，提出並設計了幾種新型光子晶體光纖;最後，提出並研製成功連續可調諧、輸出功率譜均衡的全光纖化、高功率包層泵浦鉺鐿共摻光纖激光器實驗樣機。
  9. Single exponent smoothness model fully embodies the characters of trend and cycle of the continuous varying power load, but it can not think about the effect of the weather elements carefully

    一次指數平滑模型充分體現了負荷連續變化的趨勢性和周期性，但是沒有詳細考慮天氣因素對負荷的影響。
  10. According to simplifying activated sludge process no. 1 model ( asm1 ), n - removal dynamic models in continuously mixed, continuously fed activated sludge process ( asp ) are established by employing expert experience about activated sludge process. then predictive control approach is applied to optimal control of this process. the simulation results show that it can cover the relative expert experiences more widely by applying mld to modeling and control of activated sludge process

    5 .應用mld法，對asmi模型進行簡化，建立了連續進水間歇曝氣活性污泥法除氮動態模型，通過模擬結果，可知:採用mld方法，可以充分利用有關連續進水間歇曝氣活性污泥法的專家經驗知識，加入到模型中，使模型更加精確，控制和優化的效果更好。
  11. Feluwa hose diaphragm piston pumps offer the possibility of continuously feeding discharge and / or suction pulsation dampeners by means of the unique in - built pump piston compressor

    Feluwa軟管隔膜活塞泵藉助于獨一無二的內置活塞壓縮機，提供了向進口和/或出口緩沖器連續補充氣體的可能性。
  12. Company possesses advanced production equipments and perfect quality standard system, hx302 multi - functional air pump made in company is a current elaborated works which have characteristics such as small dimension, folding feet, big power, elegant appearance, inflation and illumination in one, long working time etc

    公司擁有先進的生產設備和一整套完善的質量標準體系。公司新開發的hx - 302多功能充氣泵，體積小腳可折疊功率大造型別致充氣照明二合一連續充氣時間長，是目前車用充氣泵的精品。
分享友人
分享到 Line

分享到臉書