連續性試驗 的英文怎麼說

中文拼音 [liánxùxìngshìyàn]
連續性試驗 英文
continuity test
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 連續性 : continuity; solidity; sequence; continuance
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  • 試驗 : trial; experiment; test
  1. Connectors for electronic equipment - tests and measurements - electrical continuity and contact resistance tests - test 2a - contact resistance - millivolt level method

    電子設備用連接器.試驗和測量.電氣連續性和接觸電阻試驗.試驗2a .接觸電阻.毫伏電壓級方法
  2. Connectors for electronic equipment - tests and measurements - part 2 - 1 : electrical continuity and contact resistance tests ; test 2a : contact resistance - millivolt level method

    電子設備連接器.試驗和測量.第2 - 1部分:電連續性和接觸電阻試驗.試驗2a :接觸電阻.毫伏法
  3. It ' s able to use for determining the appropriate conditions of those experiments containing the noncontinuous factors who can not be expressed with function and the continuous factors who can be expressed with function

    該法可用於確定包含非連續性因素（不能用函數式表達）以及連續性因素（可以用函數式表達）的試驗的適宜條件。
  4. The proposed method contains two main parts : one part is determination of the noncontinuous factors by the orthogonal design method and the other is determination of the continuous factors by the uniform design method

    聯合試驗設計法主要分為：用正交試驗設計法確定非連續性因素及其在備選水平中的適宜水平，以及用均勻試驗設計確定連續性因素及其備選水平中適宜的水平范圍兩部分。
  5. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  6. Furthermore, referring to the literature and considering the specific experimental conditions given by the research, expression of the change of feed rate with time is presented, to obtain the linear growth of the diameter of pre - sintered glass beads, thus the distribution of beads size is relatively well controlled and raw material is spared in some extent. eventually, during the experiment discrete change of feed rate is implemented, and the practical changes of average diameter are plotted, then the results are compared with the theoretical calculated data

    另外，本文通過對造粒技術、燒結過程的大員文獻調研，結合本研究的具體情況，通過控制進料速率呈連續性變化，基本實現了燒結前球坯直徑的線性生長變化，從而更有利於實際生產中的產品粒度控制以及做到節約用料，並在試驗操作中以離散型進料速率變化來加以比較驗證。
  7. Test method for continuity of anodic oxide coatings on aluminium and aluminium alloys - copper sulphate test

    鋁和鋁合金的陽極氧化膜連續性的試驗方法.硫酸銅試驗
  8. Anodizing of aluminium and aluminium alloys - check of continuity of thin anodic oxide coatings - copper sulphate test

    鋁及鋁合金陽極氧化-薄陽極氧化膜連續性的檢驗-硫酸銅試驗
  9. The objective of the test process was to examine how the signal - path loss varied after exposure to different levels of vibration, and if discontinuities could be forced through long - term fretting wear or by unbiasing the spring contact with excessive shock

    測試的目標是檢驗在施加不同程度的振動之後，信號路徑損失是如何變化的，以及是否會通過長期接觸磨損或通過用過度沖擊使彈簧不偏置而形成不連續性。
  10. Under the appropriate conditions of sampling equipment of gas chromatographic headspace analysis, determine a suitable salt and a suitable extracting solvent by the orthogonal design method, then determine the fitting feed composition of ethanol - water mixture, the fitting distribution between extracting solvent and mixture, and the fitting salt concentration by the uniform design method

    在對建立的頂空氣相色譜采樣裝置的操作條件進行優化之後，先用正交試驗設計法確定非連續性因素鹽和萃取劑及其在備選水平中的適宜水平，再用均勻試驗設計確定連續性因素乙醇的進料濃度、萃取劑配比和加鹽量及其備選水平中適宜的水平范圍。
  11. Test for correct orientation of the active and neutral wires and the pins of the mains by continuity testing with an ohmmeter

    利用歐姆表，通過連續性試驗來測定有效導線、中性線和干線的插腳引線的定位是否正確。
  12. Test methods for bare wires - test for continuity of coating - sodium polysufide solution method

    裸電線試驗方法鍍層連續性試驗多硫化鈉法
  13. Measurement and control ; continuity tester

    測量和控制.連續性試驗器
  14. Test methods for bare wires - test for continuity of coating - ammonium persulphate solution method

    裸電線試驗方法鍍層連續性試驗過硫酸銨法
  15. Check the connection of control circuit shall be in accordance with drawings, the continuity of each circuit, and the insulation resistance against earth

    按電路圖檢查控制迴路接線正確，各迴路連續性試驗正確，對地絕緣電阻符合要求。
  16. Repeating ; with some degree of correspondence in successive trials or observations ; ( " a pattern of message traffic " ; " a pattern of hardware failures " )

    在連續的試驗或觀測中，有重復性且有某種程度相似性的信息。例如報文流量模式、硬體故障模式。
  17. Comprehensively discuss the issues in application, adaptive condition and performance, propose a fast arithmetic of forward modeling and depth migration in common shot gathers with one - way acoustic wave equation based on vrselrf, and verify the arithmetic by numerical simulation. concisely discuss the cause of the creation of evanescence and the problem of lateral amplitude discontinuity result from it. fourthly, use the reflectivity model, computed to describe the fracture model, with the formula of computation reflectivity based on elastic - acoustic approximation, and the wavelet model computed by the method, wavelet creation with fourier transform, we proposed, in conjunction with vrselrf wavefield extrapolation operator

    第三，將頻率波數域穩定的變參考慢度rytov近似廣義屏波場延拓運算元（ vrselrf ）應用於疊前與疊后正演模擬、疊前與疊后深度偏移，對演算法應用中應注意的問題、適用范圍、性能等作了較為全面的論述；提出了基於vrselrf的單程聲波方程共炮記錄正演模擬和深度偏移快速演算法，並通過數值模擬試驗對演算法進行了驗證；簡要地討論了倏逝波的產生原因及其帶來的橫向振幅不連續性問題。
  18. Standard test method for continuity of coatings in glassed steel equipment by electrical testing

    鋼制設備玻璃塗層的連續性電測試的標準試驗方法
  19. Connectors for electronic equipment - tests and measurements - part 2 - 5 : electrical continuity and contact resistance tests ; test 2e : contact disturbance

    電子設備連接器.試驗和測量.第2 - 5部分:電連續性和接觸電阻試驗.試驗2e :接觸干擾
  20. Connectors for electronic equipment - tests and measurements - part 2 - 5 : electrical continuity and contact resistance tests - test 2e : contact disturbance

    電子設備連接器.試驗和測量.第2 - 5部分:電連續性和接觸電阻試驗.試驗2e :接觸干擾
分享友人
分享到 Line

分享到臉書