連續拼接 的英文怎麼說

中文拼音 [liánxùpīnjiē]
連續拼接 英文
continuous assembly
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 拼 : 動詞1 （合在一起; 連合） put together; piece together 2 （不顧一切地干; 豁出去） be ready to risk...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  • 拼接 : [攝影學] montage; split joint拼接板 [土] splice plate; 拼接帶 [材料] splicing tape; 拼接梁 joggle beam
  1. Because parallax and registration error after geometric rectification and global registration result in local disconformities, discontinuity or morphing, a proper synthesis strategy must be selected to remove the parallax in the mosaic

    摘要為了消除視差圖像拼接后的局部不一致、不連續或變形，提出一種視差拼圖最優合成拼縫搜索策略。
  2. It is well known that there is limit view in the photos taken by a common camera, and a wider range view of image is needed to construct panorama in the vr system

    眾所周知，利用相機拍攝真實場景時，其視野總是有限的，當需要獲得一個更大范圍的場景圖象時，就需要連續拍攝若干幅照片，並進行拼接。
  3. 16 wu t r, lei n, cheng j s, wu wen - tsn. formulae for theblending of pipe surfaces. northeast

    2001年， hartmann提出了一種簡單的拼接方法，可以產生n階幾何連續的參數過渡曲線和曲面。
  4. Nurbs surfaces with single interior knots are simple and used widely. the thesis main aims at biuquartic, biquintic, k x fc - degree b - spline surfaces and bicubic nurbs with single interior knots. one of the contributions is to apply knot refinement and the geometric continuous conditions of bezier surfaces to deduce the geometric continuous constraints of nurbs patches and obtain the intrinsic equations of common boundary curves, where the intrinsic equations are the special phenomena of nurbs surfaces

    節點向量是內部單節點的nurbs曲面是最簡單也是最常用的，本文重點針對單節點的雙四次、雙五次和雙k次b樣條曲面及雙三次nurbs曲面，運用節點插入技術和b zier曲面的幾何連續理論成果，導出了它們之間的幾何光滑拼接條件，同時得到了公共邊界曲線所必須滿足的本徵方程，其中本徵方程是nurbs曲面所獨有的現象。
  5. 2 ) after combining surfaces, two surface curvature is continuous

    2 ）兩曲面之間的拼接可以達到c2連續，滿足曲面建模的要求。
  6. First, the human body surface is divided into seven parts, and each part is created by the way of using double cubic b - spline surfaces. to attain g1 continuity on the stitching line of two b - spline surfaces, one order tangent condition is applied to the bound of each b - spline surface

    首先，在人體建模過程中本文將人體表面分成七個部分，用雙三次b -樣條曲面模擬每一部分曲面，並在曲面的邊界處定義了一階切矢條件，使兩曲面片在拼接處達到了g ~ 1連續。
  7. When connected smoothly, t - bezier curve of three degrees can attain more superior continuity

    3次t - b zier曲線在光滑拼接時也可以達到更高的連續性。
  8. 3 ) when combining surfaces with vertex, surfaces c1 continuous at vertex, c2 continuous other. so, it approve the methods are effective

    3 ）多曲面有角點拼接時，角點處可以達到g1連續，其它地方達到c2連續。
  9. 2 ) it is difficult to put together two smooth surfaces, which are divided from a complex primary surface

    2 ）在曲面重構時由於對復雜曲面的分片造成曲面片之間的連續性拼接的困難。
  10. In this paper the g2 - continuous blending conditions of two algebraic curves implicitly defined based on the construction of algebraic curves that interpolate the geometric constraints are presented

    本文在對插值一類幾何約束的隱式代數曲線的構造基礎上，給出了這樣的隱式三次代數曲線二階幾何連續光滑拼接的條件，並給出了實驗結果。
  11. Blending pipe surface by ringed surface and its continuity

    環面構造管道拼接曲面的方法及其連續性
  12. Abstract : in this paper, a new kind of rational parametric transformationis studied which has the same form of it ' s inverse transformation

    文摘:研究了一類逆變換具有同樣表示形式的有理參數變換，並給出了在此參數變換下的曲面一階幾何連續拼接條件。
  13. Many aspects related to this problem are discussed and studied in this thesis. for curves, a c1 or c2 continuity join condition of curve segments is given after local multi - resolution edition

    文中還對b樣條曲線曲面局部多分辨編輯時的連續拼接問題進行了研究，並給出了不少算例。
分享友人
分享到 Line

分享到臉書