連續水冷卻的 的英文怎麼說

中文拼音 [liánxùshuǐlěngquède]
連續水冷卻的 英文
hopper-cooled
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  1. The problem is often overcome by the use of chilled water or the fitting of a reflux condenser which, via the continued refluxing of vinyl chloride monomer, utilizes its laten heat of evaporation for cooling purposes

    解決問題的辦法是採用冷凍水或安裝迴流冷凝器，迴流冷凝器連續迴流氯乙烯單體，利用單體的蒸發潛熱冷卻反應物料。
  2. Intermediate frequency furnace ? continuous casting billets ? heated by heating furnace ? rough rolling ? head and tail end cutting ? intermediate rolling ? head and tail cutting ? finish rolling ? water cooling treatment ? multiple - length cutting and dividing ? cooling on the cooling bed ? cutting - to - length by cold shear ? collecting and bundling ? to warehouse

    中頻熔爐連續的鑄件鋼坯重復加熱的熔爐粗軋頂端和尾端切斷中間壓軋頂端和尾端切斷完成壓軋水冷處理多功能的長度切割和分段在冷床上冷卻冷卻后冷剪長度聚集捆包運到倉庫。
  3. To research the energy transformation and utilization orderliness of the new proposed system is the main objective and content of this dissertation, as follows : about two thirds of the work output of the turbine is consumed by the compressor. traditionally, every way of inter - cooling adopted in gas turbine decreases the work consumption of compressor in some degree. through the spraying of water at the entrace of compressor, the air can be continuously cooled in compression so that the work consumption can be reduced greatly

    本論文從以下幾個方面進行了研究：由於燃氣輪機循環中壓氣機消耗近2 3的透平出功，傳統上採用的各種間冷方式都一定程度地降低了壓氣機耗功；而壓氣機入口採用注水方式，可以對壓縮空氣進行連續冷卻，以達到大幅度降低壓氣機耗功的目的。
  4. Choice of the water temperatures entering and leaving the supercooler in the dynamicice - making by supercooling system

    過冷水連續製冰系統中過冷卻器進出口水溫的選擇
  5. In this complicated process, the air is cooled by the sensible and latent heat of water ; at the same time, the water is vaporized, and the water vapor is also compressed

    但該過程是復雜過程，既有水的潛熱、顯熱對連續被壓縮空氣的冷卻，還有水的不斷蒸發以及水蒸氣的壓縮過程。
  6. The results show that, when the compressor continuously runs, the stability of the test bed after using manual valve is better than that of using thermal valve, and it is little affected by the kinds of valves for adjusting cooling water ; and that, when the compressor intermittently runs, the operation stability would be obtained if pneumatic valve is used to adjust cooling water, especially at low speed

    結果表明，壓縮機連續運行時，製冷劑採用手動閥調節后工況的穩定性明顯好於採用熱力膨脹閥時的情況，此時調節冷卻水量用的電動調節閥和氣動調節閥對工況穩定性影響相差無幾；間歇運行時，無論是熱力膨脹閥還是手動閥，即便壓縮機通電時間最長，仍達不到設定工況，特別是低速的斷續尤為明顯，而使用氣動閥就能很好地解決這一問題。
  7. By the research on the raw materials, the mix proportion, the concrete temperature control in outlet, in transport and in placement, the cure and the post - cooling water, the synthetic measures for rcc dam construction in high temperature and the enforcement methods on basis of the computation and experience of jinghong hydropower station are presented in this paper

    本文通過對原材料及配合比、混凝土出機口溫度控制、運輸過程溫度控制、澆築過程的溫度控制以及混凝土澆筑後的養護和冷卻通水等一系列研究，提出景洪電站高氣溫條件下大壩碾壓混凝土連續施工的綜合措施，並在計算和已有經驗的基礎上給出具體實施方法。
  8. Based on the established three - dimensional physical model, simplified terms, specified material parameters in thermal and physical properties, boundary conditions, and the calculation method of heat convection of cooling water, the numerical simulation and analysis on steady - state temperature field for continuous unidirectional solidification of niti shape memory alloy wire billets were proceeded under the condition of different combined parameters using ansys finite - element software

    在建立三維物理模型以及確定材料熱物性參數、邊界條件與冷卻水對流換熱系數計算方法的基礎上，採用ansys有限元軟體對不同參數組合條件下鎳鈦形狀記憶合金線坯連續定向凝固的穩態溫度場進行了數值模擬。
  9. For the experiment equipment, three experiments are carried out : intermittent cycle that adsorption bed is cooled by nature convection, intermittent cycle that adsorption bed is cooled by water and continuous cycle that adsorption bed is cooled by water. the temperature, the pressure, and performance coefficience ( cop ) are measured and analysed under different conditions

    對以真空集熱管?水冷型為吸附床的製冷系統，本文進行了三方面的實驗研究:一是，吸附床自然冷卻下的間歇式製冷;二是，吸附床通水冷卻下的間歇式製冷;三是，吸附床通水冷卻下的連續循環製冷。
分享友人
分享到 Line

分享到臉書