進口氣體壓力 的英文怎麼說

中文拼音 [jìnkǒuqìtǐyālì]
進口氣體壓力 英文
inlet gas pressure
  • 進 : 進構詞成分。
  • 口 : Ⅰ名詞1 （人或動物進飲食的器官; 嘴） mouth 2 （容器通外面的地方） mouth; rim 3 （出入通過的地方） ...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 進口 : 1 （船隻進港） enter port; sail into a port2 （外貿進口） import3 （入口） entrance; [機械工程] i...
  • 氣體 : gas; gaseous fluid
  1. After the ventilator is started, the dust catcher is under negative state and will absorb air with dust in the ductwork to the case on the dust catcher, then the air current will enter into the upper side of filter bag flowing from upper side to lower part ; most of the dust will come out from the filter bag under function of gravity and inertia and then fall into the lower case ( ash hopper ), then the clean air will enter into the air via ventilator

    當通風機啟動后，除塵器便處于負壓狀態，並將余風管中的含塵空氣吸入到除塵器上箱體內，然後氣流進入濾袋上口自上而下流動，多數粉塵顆粒在重力和慣性力的作用下穿出濾袋下口，沉降至下箱體內（灰斗） ，被濾的凈化氣體經通風機排入大氣中。
  2. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  3. The influence of operating parameters, such as pump rotation speed, suction pressure and gas content, on the performance of a multiphase rotordynamic pump is investigated

    用多相泵試驗臺架測試了泵轉速、氣體進口壓力和含氣率等操作參數對螺旋軸流式多相泵輸送性能的影響。
  4. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  5. Many data such as m / g, em and seismic have been arranged, processed and interpreted in shengli oilfield, in which, the interpreted data ( 2 - d ) are 64 lines with 1800km. the techniques such as integration of process and interpretation, joint interpretation of m / g, em and seismic, variable velocity mapping, pressure prediction, constraint inversion without well and special process have been applied. the comprehensive researches on geology and physical exploration have been carried out in the whole block

    該區油氣勘探始於50年代，勝利油田在該區塊先後部署、處理、解釋了重、磁、電、震等多種資料，其中解釋地震資料（ 2d ） 64條、 1800多公里，才用了處理解釋一體化、重、磁、電、震聯合解釋、變速成圖、壓力預測、無井約束反演、特殊處理等技術，對整個探區進行了地質、物探等綜合研究，發現兩個有利構造帶，落實了13個圈閉構造，提交了兩口探井井位。
  6. Elastomers for gas pressure regulators and associated safety devices for inlet pressures up to 100 bar

    進口壓力為100巴以下的燃氣壓力調節器和相關安全裝置用彈性體
  7. Requirement : air inlet must start to open when down stream pressure is 1. 0 psi or above

    要求：當下游流體壓力在1 . 0psi及以上時，空氣進口必須開始打開。
  8. The results indicate that the flow velocity is lower and the pressure is high in majority of the step cylinder, the distinct variations of the flow field occur in the threshold of the step cylinder at the bottom and the abrupt transition sections, the holes in the inner and outer tubes and the exhaust hole

    結果表明：步進缸內大部分區域流體流速較小，壓力較高，且變化不大，發生明顯變化的部位主要分佈在步進缸底部水管入口及截面突變處、內外套對孔處和排氣孔處。
  9. Safety devices for gas pressure regulating stations and installations - gas safety shut - off devices for inlet pressures up to 100 bar

    氣壓調節站和裝置用安全設備.進氣口壓力100巴及以下的氣體安全截止閥
分享友人
分享到 Line

分享到臉書