進空氣閥 的英文怎麼說

中文拼音 [jìnkōngqìfá]
進空氣閥 英文
air admission valve
  • 進 : 進構詞成分。
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  1. During the adjustment. it decided the amount and the rate of humidification. the system can test the states of water level by water lever sensor, thereby the main control module can control the entrance and drain of water and give warnings ; as its good man - machine interaction, the system can expediently set the humidity and the amount of humidification and control water - in valve and leading winds through control panel. the system can communicate with computer thereby the net supervise is enabled

    本系統主要能夠完成以下功能：採集空氣中的濕度狀態，並送入主控模塊，主控模塊根據現有的濕度判斷是保持原來狀態還是進行加濕以及加濕量的大小和加濕速度等；能夠通過水位傳感器測試水位的狀態，從而通過主控模塊控制進水、排水、預報警、報警等；具有良好的人機交互性，能夠通過控制面板比較方便地進行濕度設定、加濕量設定、進水閥的控制、導風的控制等；能夠和上位機進行通信，從而實現網路監控。
  2. Acoustics. pure tone air conduction threshold audiometry for hearing conservation purposes

    聲學.為保護聽力而進行的純音空氣傳導閥值聽力測定法
  3. Constructed in 1985, was one of specialized production stainless steel pressure gauge home famous factories, had the advanced production equipment, complete quality guarantee system and product examination method

    建於1985年，主要生產壓力表、減壓表、空氣調節閥等，擁有先進的生產設備，完整的質量保證體系和產品檢測手段。
  4. Particle - carrying air enters the bag filter via the inlet, passing through a stopper ; at this point, heavier powders settle first, while lighter powders attach to the filter evenly ; the plc then controls the electromagnetic valve to trigger the membrane valve for input of pressurized air, which passes the venturi tube to flush the filter by shaking off powders into the collection chute, whereas the clean air passes through the filter to be released by the fan

    控制電磁閥導引膜片閥輸入壓縮空氣，使其通過文氏管對濾袋進行噴洗，使得附著于濾袋四周之粉塵震落於集灰槽內，而乾凈空氣則穿透濾袋藉由送風機排出。
  5. The vacuum-relief valve opens to allow enough air to enter the tank to replace the gasoline pumped from the tank by the fuel pump.

    真空閥通向大氣，使足夠的空氣進入油箱，以補充由輸油泵從油箱中吸出的燃油所佔的面積。
  6. However if it does, the waterproof taped and reinforced seams and the incorporated silicon valve design behind the air intakes along the kite ' s leading edge trap the air inside the kite, and make it very hard for water to get in

    但是如果它，防水錄音的和被加強的縫和被合併的硅閥門設計在進氣孔之後沿風箏的前沿陷井空氣在風箏裏面，並且使它非常堅硬使水進貨。
  7. Devices to prevent pollution by backlow of potable water - pressurized air inlet valves dn 15 to dn 50 - family l, type a and type b

    防飲用水迴流污染的裝置.壓縮空氣進氣閥dn15至dn 50 . a型和b型l系列
  8. This means that the air vessels are always charged to an optimum degree and that pulsations are reduced to a negligible level ( even with single - acting pumping systems ), which plays an important role in preventing the delivery valves and the gearbox from shocks and prolonging their service life

    這表明空氣槽總是被充氣至最佳程度，而脈沖被減少到可以忽略的地步（單作用泵系統亦然） ，這對于保護進出口閥和齒輪箱免受沖擊，延長它們的使用壽命起著重要的作用。
  9. When the system finishes water supply, this valve can automatically supplement air into the sealed water pipe, which can be evacuated just to open the valve at the outlet, suitable for the evacuation and freeze - proof system of water supply etc. facilities

    自動充氣排空管系統供水完成後，該閥可自動補充空氣進入密封水管，將下水端閥門打開即可實現水管的排空，適用於供水等設備的排防凍系統
  10. After absorbing heat, the temperature rises to rated value and is let out at hot - blast mouth. when the hot - blast temperature reaches to the rated upper limit, the burner will stop to work automatically or turn to small fire. when the hot wind temperature reaches to the rated lower limit, the burner will kindle again or turn to big fire

    需加熱的空氣通過選配的鼓風機強行送入熱風爐、吸熱后溫度升至額定值從熱風出口送出、當熱風溫度達到額定的上限溫度時，燃燒器會自動停止燃燒或自動轉為小火陷燃燒，當熱風溫度降低到額定的下限溫度時，燃燒器又會重新點燃運行或轉為大火燃燒，升溫的速度可調進風閥來實現。
  11. In the second, in allusion to non - stationary the characteristic of the signal, the author introduces to the method that using empirical mode decomposition to analysis the vibration signal so that the signal are made up of some intrinsic mode function, after this process, we can use stochastic subspace identification to identification the mode parameter of the structure and find the same work frequency

    其次，針對氣閥振動信號的非平穩特點，本文採用了經驗模式分解法（ empiricalmodedecomposition ）對振動信號進行分析處理，使之成為若干個基本模式函數imf （ intrinsicmodefunction ）和一個殘余量的線性組合。接著採用隨機子空間參數識別法對各個基本模式函數其進行結構參數識別，同時找出各種狀態的共同工作頻帶。
  12. When the relief valve opens, as in the accompanying air - in / water - out diagram, the right - hand channel admits air to the top of the reduced pressure zone, relieving the zone vacuum

    當安全閥開啟時，伴隨著氣進/水出隔膜，右側渠道使得空氣進入減壓區頂部，消除減壓區的真空。
  13. Grit, dirt or any foreign matter accumulated in the pipe can hinder efficient valve operation and seriously damage vital valve parts. thoroughly clean pipe internally with air or steam

    硬渣、污物或任何外部物質在管道內積累都可能妨礙閥門的工作效率並嚴重損壞閥門的關鍵部件。必須用空氣或蒸氣對管道內部進行徹底清洗。
  14. This series of control box can control the quickly closing valves which in the different situations remotely through the compress air which stored in the air bottle, the air source may divide into several ways according to need

    本系列控制箱通過空氣瓶儲存的壓縮空氣對不同場合的速關閥進行遙控，氣源可根據所需控制的閥門數量分為多路。
  15. Using wl15 type circuit breaker as a representative of air circuit breaker, the problems existing in its routine operation and maintenance, such as untight seal of dewatering valve, were analysed, their solution method were proposed and the better effect were gained in its implementation

    摘要對wl15型開關為代表的空氣斷路器在日常運行維護中存在的放水閥密封不嚴等問題進行分析，提出了解決的方法，在實施中收到了較好的效果。
  16. The valve shall be constructed with a molded diaphragm separating the air inlet from the potable water supply to prevent spillage

    這種閥門結構應該是採用隔膜將空氣進口與飲用水供應分離開來以防止泄漏或溢出。
  17. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  18. Note : valves that are assembled and tested without silicone lubricants have a potential exposure to air - borne silicone as well as during shipping after they leave the plant

    注意：盡管閥門的組裝和測試都是在無硅酮潤滑劑環境下進行，但是出廠后，在運輸期間，仍然可能有暴露在空氣中的硅酮下的可能。
  19. Open the inlet water valve and press the top discharge valve to discharge the air in the filter at the same time

    打開進水閥門，同時按下頂上排氣閥，使濾器內空氣排出即可。
  20. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
分享友人
分享到 Line

分享到臉書