進給石料 的英文怎麼說

中文拼音 [jìngěidànliào]
進給石料 英文
incoming stone
  • 進 : 進構詞成分。
  • 給 : 給Ⅰ動詞1 （送對方某物; 使對方得到） give; grant 2 （用在動詞后 表示交與 付出） pass; pay 3 （叫; ...
  • 石 : 石量詞（容量單位, 十斗為一石） dan, a unit of dry measure for grain （= l00 sheng）
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 石料 : aggregaed rock; building stones; 修琢石料 dress building stones石料路面 stone pavement
  1. Abstract : incompatible element nh11 and hybrid stress element 18 were employed to analyze rock burst occurring in coal face 9108 of sanhejian coal mine. compared with the results from ansys, the two optimized fems can execute more accurate numerical simulation in the research of rock burst as well as other rock problems and lessen the errors from inaedquately meshing in huge calculations due to the limitation of labor and computer time. in addition, the criterion of averaged generalized stress rate was proposed and used to determine the site and moment of rock burst. the given conclusion is in accordance with the face of coal face 9108 very well

    文摘:利用優化非協調元和雜交元分析了三河尖礦沖擊礦壓，並與ansys程序的計算結果進行了比較.認為優化有限元在沖擊礦壓乃至巖石材料的數值模擬中能給出更為精確的結果，也可減小大型計算中由於人力、機時所限粗分網格產生的誤差.分析中，採用了廣義平均應力率準則來判斷沖擊點位置和沖擊時刻，所得結論與實際情況吻合
  2. Vibrates the feeding engine in the production process, may massive, the granulated material from store in the bunker even, fixed time, to give continuously is expected in the installment, may evenly feed the material continuously in the sand and crushed stone production line for the stave machinery, and carries on the coarse fraction to the material, vibrates the feeding engine widely to use in professions and so on metallurgy, coal mine, dressing, building materials, chemical industry, grinding compound stave, in the screening combination plant

    振動給料機在生產流程中，可把塊狀、顆粒狀物料從貯料倉中均勻、定時、連續地給到受料裝置中去，在砂石生產線中可為破碎機械連續均勻地喂料，並對物料進行粗篩分，振動給料機廣泛用於冶金、煤礦、選礦、建材、化工、磨料等行業的破碎、篩分聯合設備中
  3. And then the author established and verified an empirical equation for the ratio of the heights of collapsed part and running part for the avalanche soils, suggested the critical flow conditions of loose avalanche soils and block avalanche soils, discussed the causes of accelerated motion of consistent debris flows on mild slope, and studied the average velocity of intermittent debris flows

    給出了判別崩塌土相對運動距離，即流高比公式，並用現場實測資料進行了驗證。提出了鬆散崩塌土和塊狀崩塌土流動化的判別條件。探討了稠性泥石流在緩坡上加速運動的成因，並討論了陣性泥石流平均流速公式。
  4. The application of liquefied petroleum gas ( lpg ) in engine has been popularized and applied in recent years, but one distinctive disadvantage existing in both of them when applying the first or second lpg supplying system is that the driving performance drops to some degree. toimprove the driving performance and reduce the exhaust emission is the purpose of the author and liquid lpg injection, whis is based on the third lpg electronic control injection, is studied

    近年來液化石油氣（ lpg ）用作發動機燃料已經得到了一定的推廣和應用，但是採用第一、二代lpg燃料供給技術有一個明顯的缺點就是動力性都有不同程度的下降。本文以恢復發動機動力性和降低排放為目標，在綜合對比分析三代lpg燃料供給技術的優缺點后，在第三代lpg燃料供給技術的基礎上進行了lpg液態噴射研究。
  5. The properties of cn thin films such as their morphology, component, crystal structure and the bonding structure and the relation between those properties and the gas - phase reaction parameters were discussed, showing that the deposition of p - c3n4 thin film is the compete result of various reaction processes in the dynamics balance conditions ; the process of cn films depo sition is diagnosed in situ through the optical emission spectra technique, the effects of experimental parameters on the concentration of the precursors and the gas - phase reactions in the plasma have been obtained ; the main reaction precursors for film deposition identified ; the relation between the characteristics of cn thin films and the reaction process in the plasma is analyzed. the cn thin films deposition under different substrate temperatures in high pressure pe - pld shows that the si atom of the substrate has participated the cn films growth process, based on this the growth mode of cn thin films on the si substrate is proposed. the further experiment of cn thin films deposition on si substrate scratched by diamond as well as covered with fe catalyzer has been attempted, which indicates that changing the dynamics conditions of the surface reaction can alter the growth characteristic of the cn thin films and can enhance obviously the films growth rate

    採用pld技術進行了碳氮化合物薄膜沉積，得到了含氮量為21at的cn薄膜；研究了襯底溫度和反應氣體壓強對薄膜結構特性的影響，給出了cn薄膜中n含量較小、 sp ~ 3鍵合結構成分較少和薄膜中僅含有局域cn晶體的原因；引入脈沖輝光放電等離子體增強pld的氣相反應，給出了提高薄膜晶態sp ~ 3鍵合結構成分和薄膜的含n量可行性途徑；應用pe - cvd技術以ch _ 4 + n _ 2為反應氣體並引入輔助氣體h _ 2 ，得到了含n量為56at的晶態cn薄膜；探討了cn薄膜形貌、成分、晶體結構、價鍵狀態等特性及其與氣體壓強和放電電流的關系，證明了- c _ 3n _ 4薄膜沉積為滿足動力學平衡條件的各種反應過程的競爭結果；採用光學發射譜技術對cn薄膜生長過程進行了實時診斷，得到了實驗參量對等離子體中活性粒子相對濃度和氣相反應過程的影響規律，給出了cn薄膜沉積的主要反應前驅物，揭示了cn薄膜特性和等離子體內反應過程之間的聯系；採用高氣壓pe - pld技術研究了不同襯底溫度條件下cn化合物薄膜的結構特性，揭示了si原子對薄膜生長過程的影響，給出了si基表面碳氮薄膜的生長模式；在金剛石研磨和催化劑fe處理的si襯底上進行cn薄膜沉積，證明了通過控制材料表面動力學條件可以改變碳氮薄膜結構特性，並可顯著提高晶態碳氮材料的生長速率。
  6. By virtue of the design features of the mania dam, this paper studies the dynamic characteristics of the dam materials. by comparison with other similar projects, it presents a curve for dynamic characteristics of clay core materials and rockfill materials, makes analysis on the dam ' s plane dynamic response by finite element method, calculates the dam ' s seismic acceleration, the dynamic shear stress of the rockfill, and the dynamic stress of the cutoff wall in the overburden layer

    本文針對滿拉土心墻堆石壩的設計特點，進行了築壩材料動力特性試驗研究，通過與相關工程對比給出了心墻料和堆石料的動力特性曲線，採用有限元方法進行了大壩平面動力反應分析，計算了大壩的地震加速度、堆石體動剪應力及覆蓋層防滲墻的動應力。
  7. The main works have been done as follow : ( 1 ) after a great deal of literatures are read, the paper introduces the main ways of the flue gas desulfurization, and the development status of dcs ; ( 2 ) through the analysis of the former dcs system in the plant, the desire about the rebuilding of dcs is put ; the characteristic of the planning dcs system is introduced ; ( 3 ) according to the characteristic of the wet limestone - gypsum flue gas desulfurization, the main factor about influencing the efficiency of desulfurization is analyzed ; ( 4 ) some tests are done, which are the reduction and enhancement of the flue gas quantity, and the disturbing test of the starting and stoping the circulation of the serum in the absorbing tower. the paper lists some actual run curves

    本文完成了以下主要工作：在閱讀了大量文獻資料的基礎上，介紹了火電廠煙氣脫硫的主要方法，以及dcs的發展狀況；通過對本廠脫硫裝置原有dcs系統的分析，提出了對dcs改造的要求；介紹了擬選擇dcs的特點；根據濕式石灰石石膏法煙氣脫硫的特點，分析了影響系統脫硫效率的主要因素；進行了吸收塔煙氣量減少、增加，啟停吸收塔漿液循環泵擾動試驗，並給出了部分實際運行曲線。
  8. According to plentiful of experimentation, some new build techniques are created, for example the technique of no watering fill in winter, the technique of prevent frostbite and crack of faceplate etc. these techniques were proved by the project of lianhua cfrd. at last this paper gives some conclusion

    而且根據地區特點，進行了大量的實驗，給出了以往一般面板壩所未遇到過的施工工藝，如冬季堆石體不灑水填築、面板的防凍抗裂、壩體渡汛措施等以及採用新的爆破方法開採石料等新的施工工藝。
  9. The theme of paper is study on the application of liquefied petroleum gas to motorcycle engine. through analyze the combustion and exhaust characteristics of lpg and petrol, the experiment system adopts electronic control system of liquefied petroleum gas injection to provide fuel for motorcycle engine. through researching the characteristic and adjustment factor of air fuel ratio, the paper can offer exactitude theories and viable plan for more effective using lpg, optimum matching electronic control system of liquefied petroleum gas injection with motorcycle engine and intelligent control

    本文分析了代用燃料液化石油氣與汽油的燃燒特性和排放特性，就液化石油氣在摩托車發動機上的應用進行了初步的研究，利用液化石油氣電控噴射系統控制燃料供給系統，進行對空燃比控制特性及其影響因素的研究，達到為進一步合理利用液化石油氣，進行液化石油氣電控噴射系統與發動機的有效配匹，實現智能管理的目的，並為控制系統提供理論依據。
  10. A homogenization - based method for predicting the viscoelastic property of multi - layered composite material is presented. by laplace transforming the governing equation of the viscoellastic problem of jointed rock, the dependent relation of the laplace transformation of the effective relaxation modulus of jointed rock on the joint distribution was derived by applying the homogenization method in laplace transformed domain. then, the effective relaxation modulus was obtained from the inverse transformation

    首先對層狀復合材料粘彈性問題的控制方程進行laplace變換，在像空間中利用均勻化理論建立宏觀鬆弛模量的laplace變化與各層形式的依賴關系解析表達式，通過laplace逆變換可獲得等效鬆弛模量預測的解析表達式，並給出了體積變形為彈性、剪切變形符合三元件模型的單向節理巖石的粘彈性鬆弛模量預測的數值算例。
分享友人
分享到 Line

分享到臉書