過放電 的英文怎麼說

中文拼音 [guòfàngdiàn]
過放電 英文
over discharge
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 放 : releaseset freelet go
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 放電 : [物理學] （electric） discharge; electro-discharge; discharging
  1. The discharging capacity of single aluminum / air battery was over 40ah with 4a, and the output power of aluminum / air battery pack was as high as 110w

    鋁空氣單電池，恆流4a放電，放電容量超過40ah ；鋁空氣電池組的最大輸出功率超過110瓦。
  2. When measuring the magneto performance parameter ， we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard ， and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ； because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable ， it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時，發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表，而觀測到的波形多為不規則的形狀，根據測量原理，顯然不能用其來做定量的分析；由於點火系統的放電過程比較復雜，伴隨著很強的電磁干擾，點火電流、點火電壓都是變量，使得點火能量的測量成為點火系統性能測試的一個難點。
  3. After verification and authentication of the corporate invoice, buyer will accept the mtn and within eight ( 8 ) banking hours, buyer ' s bank shall release the payment via swift wire transfer to seller ' s bank

    經核實和認證的公司發票，買方將接受mtn並在8 （ 8 ）銀行業小時內，買方銀行將釋放付款迅速透過swift電匯至賣方的銀行
  4. Techniques, and their physico - chemical parameters such as specific areas, particle size distributions and diffusion coefficients are measured by the bet method, laser scattering technique and galvanostatic intermittent titration technique ( gitt ), respectively. sem photographs show that these samples are made up of the irregular porous granules, which are conglobated by many small spherical crystals

    溫度助p 』 c賊品中有明顯的尖晶石相雜質，充放電曲線表現出3v和4vmglz臺，而焙燒溫度在sic 』 c以下的樣品充放電曲mn有一個3v平臺，充放電循環過程中沒出現明顯的3v平臺向4v平臺轉化的現象，表明該樣品在循環過程中結構是愧箍淀的。
  5. The dentate gyrus controls overactivity from reaching seizure - prone brain cells further along the circuit

    齒狀核負責抑制易放電腦細胞的過度活動。
  6. In the work, it was systemically studied that the effects of two suggested modifying ways on electrochemical characteristics of lithium metal electrode and its behaviors in lithium cell. finally, the action mechanisms of these two modifying ways were analyzed. through the study on pretreatment effects of different cyclic ether on lithium electrode, it was found that 1, 4 - dioxane ( doa ) and 1, 3 - dioxolane ( dol ), both could form a favorable passivating sei film on lithium electrode surface through

    研究不同環醚對鋰電極的預處理作用發現， 1 ， 4 -二氧六環（ doa ）和1 ， 3 -二氧五環（ dol ）對金屬鋰電極的表面預處理均可以在金屬鋰表面形成一層良好的sei鈍化膜，對鋰金屬電極起到了保護性作用，使鋰電極具有較小的界面阻抗，有效地提高了金屬鋰電極的充放電循環效率，改善了鋰金屬電極在循環過程中的表面形貌;而doa和dol對金屬鋰電極的表面預處理，不會明顯的影響鋰電極的動力學性能。
  7. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  8. Each electrode is a filament for providing electrons to maintain an electric discharge through an inert gas.

    每一電極是一燈絲，它發射電子，以通過惰性氣體來維持放電。
  9. After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic

    即在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆定壓充電，確保電池充滿;在恆流充電階段，當晶元溫度上升到一定程度時，晶元過熱保護電路開始工作，該電路以提供充電補償電流的形式使充電進入恆溫充電模式，對晶元進行保護。
  10. It not only uses this power to kill its prey but to locate it as well - though it is born with eyes it is blind as an adult and employs its electricity to find food in much the same way as man uses radar

    他不僅用這一電力殺死獵獲物，還用它尋找獵物。電鰻雖然出生時有眼睛，長大后會變成瞎子，它像人使用雷達那樣通過放電尋找食物。
  11. Abstract : the rechargeble batteries are used for backup power internal electrically equipments and instruments. but batteries lifetime usually is shorten by overwork and then malfunctions of equipment are induced. to avoid the complexion described above, the protection circuit against overwork is designed. it is based upon the voltage comparator and regulator. it will light up a red led when the volume of the batteries discharged close upon 50 % ; it will switch off the load automatically when it discharged closing to 80 % of their energy capacity, thus overwork of batteries can be avoided and lifetime may be extended

    文摘:用蓄電池做后備電源的系統（或設備） ，常因過放電導致電池提前報廢而造成設備故障.根據電池電壓隨容量變化的規律，利用電壓比較器和電壓基準源設計製作了電池放電保護電路，當電池放電量接近容量的50 %時，啟動預警信號；當電池放電量達到容量的80 %時，電路自動切斷負載，防止電池過度放電，延長電池壽命，保證系統（或設備）在供電恢復正常后能正常運行
  12. Studies on overdischarge mechanism of d - sized ni mh batteries

    電池過放電機理的研究
  13. How long can a cell be stored

    什麼是過放電，對電池性能有何影響？
  14. Do not mix new batteries in use with semi - used batteries, overdischarge may occur

    19不要將新舊電池混用，可能會導致過放電
  15. Avoid overcharging, repeated overcharging can lead to deterioration in battery performance

    避免電池的過放電，否則將對電池造成破壞
  16. Ni - cd cylindrical cell has the properties of small internal resistance, long service life, resistant to over charge and discharge, low self discharge, wide operation temperature range ( - 20 + 40 ) and high reliability. they are suitable for high rate discharge and widely used in the fields of electrical tools, railway trains, lighting, fire prevention and military

    鎘鎳圓柱密封堿性蓄電池具有內阻小，使用壽命長，耐過充過放電，自放電小，使用溫度范圍寬（ - 20 + 40 ） 、可靠性高等特點，適用高倍率（大功率）放電使用，廣泛應用於電動工具、列尾電源、照明、消防、儀器儀表以及軍事領域。
  17. The trickle charging uses small current at the initial of charging cycle to fix and protect the over - discharged battery ; after which, the battery will be charged by large constant current to allow the fast charging ; finally, the constant voltage charging is adopted to guarantee that the battery is charged to its full capacity

    在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆壓充電，確保電池充滿。
  18. If one cell fails, the whole battery fails. with use the normal battery management system, the difference between cells enlarge. it " s recommend that a cell management system which embedded a powerful microchip to manage the charge and discharge of cell will solve this problem well

    本文分析不一致性對蓄電池使用過程中的影響，試驗驗證不一致性隨著使用次數的增加而增大，造成在充電過程中，充電不均衡，容量未充足的電池在放電中過放電，造成了惡性循環，縮短蓄電池的壽命。
  19. The valve has electro - continuity across the discharge path with a resistance of not more than 10 ohms

    這種閥門具有穿過放電電路的電鍍連續性，具有不超過10歐姆的電阻。
  20. Abstract : the article introduces an activating and charging method for trouble lead - acid accumulator due to over discharging or self - discharging in a long period. this paper also analyzes the cause of trouble accumulator, principle of activating and main circuit of instrument

    文摘:本文介紹了對過放電或長期放置自放電嚴重的鉛酸型故障蓄電池進行激活充電的一種方法.文中分析了蓄電池的故障產生原因和故障蓄電池的激活機理，敘述了儀器設計原理框圖及主要電路
分享友人
分享到 Line

分享到臉書