過流板 的英文怎麼說

中文拼音 [guòliúbǎn]
過流板 英文
transition plate
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  1. They may be citric acid, monosodium glutamate, borax, ammonium sulphate, compound fertilizer, piece of radish, bean, less, seed, mine reside and sugar, in chemical, pharmaceutical, foodstuff, grain, mine and so on industries

    物料自進料口進入機內，在激振力作用下，物料沿水平方向拋擲向前連續運動，熱風穿過流化床孔板向上穿過同物料換熱后，
  2. Numerical simulation of intermediate flow field of confined pipeline with duple orifice

    有壓管道雙孔板過流流場的數值模擬
  3. For obtaining the numeral solutions of round elastic plates in axisymmetrical deformation with varying - thickness in nonlinear deformation in the unsteady electromagnetic field and mechanical field, by establishing the equations of motion, the equations of distortion, the equations of lorentz force, the equations of electronic dynamic mechenical, and adopting iterative method, we gained the nonlinear magneto - elastic calculation method and outcome of current - carrying shell, and gained the influencing degree toward mechanical parameter of varying thickness round ferreous plates in the electromagnetic field and mechanical field

    摘要為了獲得內邊界固定的環形導電薄板在均布力與橫向磁場作用下的變形問題的數值解，通過建立運動方程、變形方程、電動力學方程和洛侖茲力方程，運用迭代法得出了載流板殼的非線性磁彈性的計算方法和結果，以及機械場、電磁場對鐵質變厚度圓板各力學參量的影響程度。
  4. High pressure air is brought through the strut and simulates the engine air flow.

    高壓空氣通過支板引入並模擬了發動機的氣流。
  5. Abstract : the distribution of cooling air which is in the grille - brick of the inner combustion hot air stove has been simulated with three dimension turbulent mathematical model so as to find a method which is used to improve the distribution of cooling air in hot air stove. the influence of differential horizontal plates on the distribution of cooling air is discussed. the results show that original big circle round field of flow in the pillar - cavity is changed into full one - way field of flow and edges gas flow, at the same time, is increased by horizontal plates. there is a different function with horizontal plates and vertical plates. to make the uniform distribution of cooling air in the hot air stove, it is necessary that horizontal plates and vertical plates are used in a combined way

    文摘:應用紊流三維數學模型模擬內燃式熱風爐內冷風在格子磚柱中的分佈，尋求改善其分佈的途徑.討論了加設不同布置的水平導流板對氣流分佈的影響.模擬結果表明，在支柱空腔內加設水平導流板改變了原有大迴旋流場，使迴旋流變成大面積的單向流.通過在支柱空腔內加設水平導流板可以發展邊緣氣流，這恰好與加設豎直導流板的作用相反，水平導流板和豎直導流板的結合使用有望實現冷風在格子磚柱中的均勻分佈
  6. The steam produced in vaporize pan reached the condense pipe through guide plate

    在蒸發鍋中發生的蒸汽經過導流板裝置到達冷凝管。
  7. It makes the hot air pass through the raw material to be dried evenly, the damp air is sucked from the inclined air channel under the drying tray

    通過過濾器使熱空氣凈化后，再由左側分流板分至各層，使熱風平均通過每層被乾燥的物料。
  8. Based on analysing all kinds of sediment silting basins and their suitable conditions, the traditional sedimentation basin has been improved in three aspects, i. e., setting an adjusting flow board in the fore of setting basin, adding a spillway trough along the flow direction, and redesigning the flush gallery by adding auxiliary flushing facilities

    摘要在對各種類型沉沙池及適用條件進行分析的基礎上，通過在沉沙池的首部加調流板、在溢流堰上沿水流方向設溢流槽、對沖沙廊道進行改進並設置輔助沖沙設施這3個方面對傳統沉沙池進行了改進。
  9. Therefore, the descend of so2 removal efficiency should be considered when we rebuild a marble scrubbing dust collector to a equipment of wet calcium fgd & dusting

    因此，在將麻石水膜除塵器改造成旋流板塔脫硫除塵系統的過程中，增大葉片仰角的同時一定要考慮脫硫率的下降問題。
  10. A transparent model is used to make the deflection jet board grounded on the inhere enlarged dimensions. the finished experiments are conducted to catch the flow rate directions and the situation of cavitation using a high - speed video cameras. in this paper, the finite element analysis and visualiation research of servo valve prestage jet flow field are carried out, which establish the theoretical foundation for mathematical model of servo valve prestage and the whole mathematical model of hydraulic servo valve

    在對射流前置級驅動的伺服閥射流流場數值模擬的基礎上，用有機玻璃在偏導射流板原始尺寸的基礎上進行了擴大，製作了透明的偏導射流板，運用高速攝像機、液壓泵站等組成了可視化實驗系統，對射流流場的流速方向、渦流、氣穴等現象進行了多方位的觀測，並通過對接收管接收壓力的測試，對流場分析結果進行了驗證。
  11. We walked across the bridge and looked through the cracks between the planks at the high - flowing river

    我們走過大橋，在嘩嘩流淌的河邊，透過木板的縫隙窺視。
  12. And, we also have had the relation between the size of the horizontal circulation regions and the fr number around the dike for the flow - deflection method. the results of this study show that, using the method of flow - deflection or " sucking - spouting " water, the flow pattern can be improved, the size of the horizontal circulation regions and the sedimentation volume caused by the horizontal circulation can both be reduced. so, they can be adopted to improve the navigation condition of upper approaching channel of three gorges project, which could guarantee the safety of navigation

    通過試驗，得到了以下創新的成果： 1 、不加吸、噴水時，丁壩后的迴流長度約為丁壩長度的8倍； 2 、加吸、噴水可以減小丁壩后的迴流尺度和強度，並得出了有理論根據的吸、噴流量與迴流尺度減小之間的定量關系以及吸、噴流量與丁壩周圍流速梯度之間的定量關系； 3 、加吸、噴水可以減小迴流淤積，並得出了吸、噴流量與淤積量減小之間的定量關系以及迴流尺度減小與淤積量減小之間的定量關系； 4 、加導流板可以減小丁壩后的迴流尺度，並得出了丁壩周圍的水流fr數與迴流尺度減小之間的定量關系。
  13. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  14. Through repairing the worn parts of four hydropower stations of xinzhuang, zaoqi, suide and qiemo, and taking some comprehensive anti - abrasion measures, such as checking and repairing the runner blade, cutting the head of blade into round shape, adding an apron to the outer edge of blade and increasing a guiding plate in the head of blade, a good effectiveness has been gained so that it increases the output of generating unit and enhances the abrasion resistant capacity

    通過對新莊、棗渠、綏德、且末4個水電站的磨蝕破壞部件的修復、轉輪葉片測型與修型、葉片頭部割圓角、葉片外緣加裙邊、頭部加導流板等抗磨蝕措施的綜合治理，取得較好效果，使機組出力增加、抗磨蝕能力提高。
  15. Technologies such as chemical constitution selecting, alloy melting, casting process designing and optimizing, mechanical machining and heat treatment process on pump body, impeller, front and rear board of cw. nb450 dredge pump abrasion resistance parts are concluded

    摘要總結了用於挖泥船的cw . nb450型泥泵過流耐磨部件泵殼、葉輪、前後襯板的化學成分選擇、合金熔煉、鑄造工藝設計及優化、機械加工、熱處理工藝等技術。
  16. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  17. The velocity profiles along the channel section are measured using the laser doppler anemometer. according to the velocity distribution, boundary shear and the coefficient of friction between the flow and rubber panel, is determined

    採用多普勒激光測速儀對過流斷面的流速分佈進行了測量，並根據流速分佈推求出壩面上橡膠板所受的水流剪應力，和水流對橡膠板的摩阻系數。
  18. Abstract : in the light of the problem of multiple variables restrain in the design of pipe heat exchanger, it is proposed taking three variables, the pipe length, ratio between the table flap space and the shell outer diameter, and ratio between the pipe space and the pipe outer diameter, as optimization criterion

    文摘:針對管式換熱器設計過程中幾何關系的多自變量約束難題，提出了以管長、折流板間距與殼外徑之比、管間距與管外徑之比三個設計變量作為優化判據。
  19. There are two categories about micro drive equipment in this paper. one of them is drove by the combination of ac servo electromotor and ball screws, which is connected with reflective mirror using column stagger flexible hinge. the other one is drove by ac servo electromotor and ordinarily precision screws, and the flexible hinge change to flat straight round flexible hinge

    微驅動組件採用兩種形式，一種是由交流伺服電機帶動精密滾珠絲杠通過圓柱形錯位式柔性鉸鏈驅動反射鏡架，另一種方案是由交流伺服電機帶動精密絲桿通過平板形直圓式柔性鉸鏈驅動鏡架。
  20. After the function of cutting, lashing and scraping produced by the strong force, and then becoming granule and being scatted, a part of the disposed liquid will spurt out from the spurting mouth at the upper of the container

    部分由具有高轉速的獨特的輪機與具有放射狀折流板之作用的定子的被處理液就任由高速回轉中的輪械與定子之間所產生的強力的剪斷、沖擊、刮流等過程，而被細粒化及分散，而由上方之噴出口往上噴出。
分享友人
分享到 Line

分享到臉書