過熱橡膠 的英文怎麼說

中文拼音 [guòxiàngjiāo]
過熱橡膠 英文
heated rubber
  • : 過Ⅰ動詞[口語] (超越) go beyond the limit; undue; excessiveⅡ名詞(姓氏) a surname
  • : 名詞1. (橡樹) oak2. (橡膠樹) rubber tree
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • 橡膠 : rubber; vulcanizate
  1. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    試驗研究認為:玻璃纖維瀝青碎石的技術性能不如瀝青碎石好,但路用彈性性能較好,如能解決拌和工藝問題,調整纖維絲的品種,增大其直徑,其路用性能仍值得探討,瀝青碎石結構層具有變形性能和抗裂性能良好,空隙率小,防水性能好,穩定性較好,施工工藝簡單的特點,因此,瀝青碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料,也是防止半剛性基層收縮裂縫反射的良好結構措施,在瀝青類路面面層和半剛性基層之間夾鋪瀝青碎石薄層,雖然造價比夾鋪土工布高,但其施工工藝,抗裂性能和防水性能均優于土工布,不僅可以大大減少半剛性基層材料的反射裂縫,延長路面使用壽命,而且可能適當減薄瀝青混合料面層的厚度,雖然初期造價有所增加,從長遠來看,具有十分重要的技術和經濟意義。
  2. By physical and chemical testing and comprehensive analysis, it is suggest that deposited sands and rubber relics lead to local clogging of the pipe, so vortex around the clog lead to erosion abrasion

    理化試驗和綜合分析后認為,海水中沉積的泥砂和管內殘片集結成一體,對傳管形成局部阻塞,水流在阻塞物周圍產生渦流,發生沖蝕磨損,造成鈦管泄漏失效。
  3. Analysis on the causes of damage, this paper modified the meijia bitumen materials in order to enhance the low temperature capacity of bitumen and bituminous mixture through the polymer. emphasis on the study of low temperature capacity of modified asphalt and bituminous mixture, we utilize reasonable construction craft to avoid the cracks problem between bituminous mixture and bridge and give a advance way of small or moderate span bridge expansion joint in low temperature areas

    針對這一缺陷,本文通添加塑性類改性劑和類改性劑,對美佳改性瀝青結合料進行二次改性,重點研究了改性后瀝青結合料和混合料的低溫性能,並採用合理的施工工藝解決填縫料與梁端間存在的界面裂縫問題。
  4. This myth has encouraged people to work out in extreme heat or wear layers of clothes or rubber or plastic weight - loss suits in the hope of sweating fat off

    這個錯誤的觀點鼓勵人們在極的環境下運動,或者穿好幾層衣服或者穿或塑料減肥服,希望通流汗將脂肪排出。
  5. The more you sweat, the more fat you burn this myth has encouraged people to work out in extreme heat or wear layers of clothes or rubber or plastic weight - loss suits in the hope of sweating fat off

    流汗越多,消耗的脂肪越多這個錯誤的觀點鼓勵人們在極的環境下運動,或者穿好幾層衣服或者穿或塑料減肥服,希望通流汗將脂肪排出。
  6. Ethylene / octene copolymer sythesized by metallocene catalyst was a new kind of thermoplastic elastomer, which was molded as elastomer material by plastic common molding process such as injection, extrusion and blowing and also by rubber process such as chemical crosslinking by peroxide

    採用茂金屬催化劑合成的乙烯辛烯共聚物是一種新型塑性彈性體,可用注射、擠出、吹塑等常用加工方法成型,又可用氧化物進行化學交聯,用加工方法製成彈性體材料。
  7. Abstract : focusing the key problem of liquid with high viscosity in heat transfer, experiments on mixing and reaction rate of hot liquid were carried out. a new polymerization process of methylvinyl silicone rubber was designed

    文摘:通對現有甲基乙烯基硅生產工藝、程和設備的分析研究,針對高粘度流體傳難度大的問題,進行了流體混合速度及反應速度的試驗,設計了一種生產甲基乙烯基硅的新工藝。
  8. Screw the two sections together making sure the filter and rubber gasket are in place. this is important to ensure a perfect seal

    懸緊這兩部份螺旋?確保濾網和圈放到位。這對密封的完好性非常重要。
分享友人