過磨鐵粉 的英文怎麼說

中文拼音 [guòmótiěfěn]
過磨鐵粉 英文
heavily milled iron powder
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  1. The crystalline structure changes of pp induced by pan - milling were characterized by x - ray diffraction and raman spectroscopy. xrd analyses show that when pp was co - milled with uhmwpe, crystal transformation of pp occurred, its crystallinity and crystallite size decreased, whereas, only slight reduction of crystallinity and crystallite size were observed and no crystal transformation was found when pp was co - milled with wtr chips, and amorphization of pp was strongly enhanced by co - milling pp with iron

    採用x -射線衍射研究了聚丙烯碾磨粉碎過程微觀結構變化， uhmwpe存在下pp發生晶型轉變、結晶度降低和晶粒尺寸減小；彈性材料wtr抑制pp塑性變形，碾磨導致分子堆積有序區域膨脹，晶面間距增大，結晶度下降；剛性材料金屬鐵與pp產生強烈摩擦，加快晶粒細化，晶格破裂導致非晶化。
  2. Diamond micro powder ( abrasive grain = 0. 5 u m ) is added to the plating liquor, after many experiments, we discover every parameter of composite electro - brush plating, includes voltage of brush plating, relative velocity of between brush plating pen and workpiece, adding quantity of diamond micro powder etc. finally steel balls millstone covering with ni - fe - diamond composite electro - brush plating film is produced successfully

    試驗中加入粒度為w0 . 5的金剛石微粉，通過反復多次的試驗，確定出了鎳-鐵-金剛石復合電刷鍍中的各項工藝參數，包括電壓、鍍筆和工件的相對速度、金剛石微粉的加入量、溫度等等工藝參數；成功的試製成了覆蓋有鎳-鐵-金剛石復合電刷鍍層的鋼球研磨板。
  3. Amorphous can be obtained at certain composition range using ball milling. the size of the amorphous particles decreases with the lengthening of milling time, and reaches several nanometers. experiment also shows that the mixture powder is well ferromagnetic

    實驗發現，在一定成分范圍內通過球磨可以獲得非晶，非晶粉末顆粒大小隨球磨時間的延長而減小，最終達到幾個納米；同時發現，該混合粉末具有良好的鐵磁性。
  4. A vacuum carbonized furnace which manufactured to carbonize straw pole, a set of equipment which globe - grinded the carbonized straw pole were designed and prepared in this work. the furnaces were used to carbonize the smashed straw pole in the vacuum furnace first, and to grinded it in the globe - grinding machine. with the powder, woodceramics target and compound target were made to manufacture external metal - carbon wave - guide compound film series on columned ferrite surfaces

    在本論文工作中，自行設計與製造了制備碳化秸稈的真空碳化爐及粉碎球磨設備，用此設備把粉碎的秸稈先在真空碳化爐中進行碳化，碳化的秸稈粉再經過球磨設備球磨成細粉，用此細粉做成木質陶瓷靶和復合靶材在圓柱鋰鐵氧體表面鍍覆符合要求的表面金屬-碳系復合波導膜，並制備了木質陶瓷塗層導電膜。
  5. In this paper, the microstructure changes of polypropylene induced by a complex combination of shearing, compression, stretching and friction actions during single pan - milling or co - milling with iron, uhmwpe and waste tire rubber chips ( wtr ) were studied and the stress induced effects were revealed. the structure and morphological development of iron particulates and wtr during pan - milling and co - milling with polypropylene were also characterized. the properties of pp / fe, pp / wtr and pp / wtr / fe composites prepared through pan - milling techniques were investigated

    本文利用磨盤型力化學反應器對被碾磨材料施加強大的剪切、環向應力、擠壓、拉伸和摩擦作用，研究聚丙烯碾磨和共碾磨粉碎過程微觀形態結構和性能的變化，以及聚合物在碾磨過程中呈現的力化學現象，並將其應用拓展至金屬、橡膠等體系，研究碾磨粉碎在聚丙烯鐵超微粉體的制備、高交聯密度彈性材料廢舊輪胎橡膠（ wtr ）的超微粉碎，以及pp fe ， pp wtr材料的性能與碾磨作用的關系。
  6. To comnter the problem of high grinding energy, rapid flow of material, low ratio of material to grinding media, and bad ball coating in common open circuit ferric oxide tube mill, ferric oxide superfine grinding technology markedly increase grinding efficiency and improve grinding status in the tube mill by setting high efficiency sifting equipment, material place regulating technology and subminiature cylpeb

    摘要針對普通開流氧化鐵管磨機在氧化鐵生產過程中存在電耗高，流速快，料球比低、嚴重糊磨等問題，通過在磨內設里高效篩分裝蘭，採用料位調節、微型鋼段等技術措施，極大地改善了磨內粉磨工況，提高了粉磨效率。
  7. In addition, under high sintering temperatures, iron powder can result in the graphitization of diamonds. these two reasons will affect the mechanical properties of the metal bond and its retention capacity. as a result, the wear resistance of metal bond is poor and diamond grits can be easily pulled out from the matrix, thereby shortening the life of the saw - blade

    而且在高溫下，鐵粉會對金剛石產生較嚴重的化學侵蝕，這兩方面的原因都會影響結合劑本身的力學性能及其對金剛石的有效把持，導致鋸切過程中結合劑耐磨性差，金剛石容易脫落，使鋸片壽命縮短。
  8. Through the mix humidifying grinding, the fine degree of iron ore concentrate was increased, the addition ratio of bentonite was decreased, the quality of pellets were improved, and good economical benefit was gained

    通過對混合料的潤磨，提高了鐵精礦粉的細度，降低了膨潤土添加量，提高了球團礦的質量指標，收到了良好的經濟效益。
分享友人
分享到 Line

分享到臉書