過程間耦合器 的英文怎麼說

中文拼音 [guòchéngjiānǒugěqì]
過程間耦合器 英文
interprocess coupler
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 過程 : process; procedure; transversion; plication; course
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  3. The etching reactor is developed to obtain reproducible tapers of desired diameter and length. an approach for on - line monitoring of etching using the power meter is demonstrated. based on the experimental data, the relationship between the leak - out optical power and change of time and also that between the leak - out power and width of the remaining width of cladding, and the fiber length exposed to hf acid are summarized

    本文對氫氟酸腐蝕法製作光纖耦合器的反應裝置和實驗系統進行了設計，介紹了具體的實驗過程及其注意事項，通過對實驗結果進行分析總結，得出泄漏光功率隨腐蝕時間的變化關系以及泄漏光功率與包層剩餘厚度和腐蝕長度的關系。
  4. In chapter two, using the hydrodynamical equations for electrons and maxwell equation and through complicated calculation, we finally obtain a set of equations which describe the non - steady and nonlinear interactions between plasma and field in the wake region of a moving body in space

    第二章是從描述電子的磁流體方程和麥克斯韋方程出發，通過計算，最後得到了一組在考慮非靜態極限下描述空間飛行器遠尾區內等離子體與場之間的非穩態非線性相互作用耦合方程。
  5. The aims are to implement 1 : 1 pixel - matching of high resolution data pages ( 1024 768 ) between slm and ccd, and to design a compact holographic disc storage system with optimized optical and mechanical structure, thus, to help with putting the holographic data storage technology into practice. we reviewed first the fundamental theory on volume holography ( mainly the coupling - wave theory ), and the mechanism of holographic storage materials ( mainly photorefractive crystals and photopolymers ). based on the above fundamentals, the importance of fourier transform holograms for holographic storage is described

    本論文從盤式體全息存儲的基本理論和相關技術出發，首先描述了光學體全息記錄的基本物理過程和耦合波理論;然後根據全息圖的類型特點，闡述了傅立葉變換全息光路作為體全息存儲器的光路系統的優點;同時對光學體全息存儲材料的存儲特性做了一些簡單的介紹;接下來討論了光學體全息體積復用存儲技術，最後對本論文工作應用到的空間-角度復用與盤式體全息存儲技術以及有關體全息存儲器光學設計的像差理論進行了詳細敘述。
  6. The dynamic distributed principia on the simulation module are given, as well as the dynamic analyses arithmetic on the load of the servers. the arithmetic which to test the data pertinence of the simulation module which driven by the data source is put forward. the dissertation also designs an efficient distributed arithmetic on the simulation module the concept of xml template is put forward to realize the save format and the backward - compatibility of visualize edit interface system

    研究過程中，作者確立了鬆散耦合分散式的系統架構；給出了模擬模塊動態分散式的原則和服務器負載狀況動態分析演算法，提出了數據源驅動的模擬模塊數據相關性檢測的演算法，設計了簡單而有效的模擬模塊動態分散式演算法；提出了xml模版的概念，實現了存儲格式和可視化編輯界面系統的向後兼容的問題；使用soap實現異構模擬組件的遠程調用與數據交換；提出模擬容器的模型來簡化異構組件間通信對二次開發造成的負擔；建立了模擬模塊自適應檢測的機制，達到模擬演算法系統的通用性。
  7. By way of analysis of heat transfer process of the field - test model, the author formulated a 3 - dimensions heat transfer model which is correspondent to actual performance of buried pipe - in - pipe heat exchanger. coupled with field testing data, the short and long term operation features has been thoroughly analyzed by finite element solution and forward finite - difference analysis of the heat transfer differential equations of buried pipe - in - pipe heat exchanger. by interpreting regularity of continuous and intermittent operations of buried pipe - in - pipe heat exchanger, its heat transfer mechanism has been further explained in this thesis

    本文通過對試驗模型熱過程的深入分析，建立了與實際地下埋管換熱器結構參數相吻合的三維傳熱數學模型，通過有限單元法和向前差分法求解相應微分方程並對分析結果進行關聯耦合，詳細分析了埋管換熱器的短期和長期運行特性，對地源熱泵套管式埋管換熱器連續運行、間斷運行規律進行了解析，進一步弄清了埋管換熱器的傳熱規律。
分享友人
分享到 Line

分享到臉書