遙控閥控制 的英文怎麼說

中文拼音 [yáokòngkòngzhì]
遙控閥控制 英文
remote valve control
  • : 形容詞(遙遠) distant; remote; far
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • 遙控 : remote control; telecontrol; distant control; teleoperation; telecontrolling; [訊] telearchics
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Diesel engine, main turbine, generator turbine, main boiler, diesel generators, deck crane, deck machineries, propeller, controllable pitch propeller, switchboard, engine control console, fire extinguishing system, inert gas system, aux. boiler, oil purifier, navigation equipment, life boat, anti rolling system, hatch cover, compressor, fin stabilizers, valves, anchor, chain and scaffolding, control system for lng carrier and various machinery for lng carrier

    主機柴油機,液化氣船主機透平鍋爐貨油泵,機艙泵,發電機,甲板吊機,甲板機械,螺施槳, cpp ,配電盤,主機,消防沒備, igs ,輔鍋爐,分油機,航海儀器,救身艇,減搖裝置,艙口蓋,空壓機,減搖鰭,門,錨,錨鏈,船舶腳手架,液化氣船系統,液化氣船用各種沒備
  2. This series of control box can control the quickly closing valves which in the different situations remotely through the compress air which stored in the air bottle, the air source may divide into several ways according to need

    本系列箱通過空氣瓶儲存的壓縮空氣對不同場合的速關進行,氣源可根據所需門數量分為多路。
  3. Electro - hydraulic control principle applied in construction machinery is analyzed in this paper ; working principle and application characteristic of electro - hydraulic proportional is lucubrated ; technique and static characteristic of electro - hydraulic proportional decompression value and electro - hydraulic proportional direction value is emphatically analyzed and studied ; electro - hydraulic proportional control mode is setup. the hydraulic circuit which can be not only suit for handle operation but also for remote operation in the same construction machinery, and the hydraulic system design methods is also introduced that the proportion control use d for the steering devices and the working devices of the machine

    本文對工程機械上應用的電液原理進行了分析;對電液比例的工作原理和應用特點進行了深入研究;重點對電液比例減壓和電液比例方向技術特徵和靜態特性進行分析研究;建立電液比例模型;提出了在同一臺工程機械上,既能滿足又能滿足手的液壓迴路,以及採用比例量行駛和工作裝置的液壓系統設計方法。
  4. The robot controller adopts a kind of two - level structure. the top level was the host controller and motor driver, the main program and motor servo arithmetic program running in it, and also receive command from the remote computer. the lowest level was two sensing system, fixing on foot of the robot, gathering and processing information from multi - kind sensors, and also controlled the pump and valve

    機器人嵌入式器採用兩層結構,上層為機器人主及驅動電路,負責運行機器人主程序及多電機伺服演算法,以及接收上位計算機的遠程命令;下層為兩個足部傳感系統模塊,分別安裝在機器人的兩個足上,負責多種傳感器信息的採集、處理及泵和的驅動
分享友人