遞增頻率 的英文怎麼說

中文拼音 [zēngbīn]
遞增頻率 英文
increasing frequency
  • : Ⅰ動詞(傳送;傳遞) hand over; pass; give Ⅱ副詞(順著次序) in the proper order; successively
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • 遞增 : increase progressively; increase by degrees
  • 頻率 : frequency; rate
  1. Based on the unified recursive formula, the four algorithms included in this study are the central difference method, the newrnark ' s method, z - transform method, and duhamel ' s step integral method. the accuracy, the phase and other existent problem are studied in this paper. it is proved in this paper that the recursive parameters b1and b2are relate to the poles of theoretical transfer function

    分析中可以發現,中心差分方法, newmark中點加速度方法、 z變換方法及duhamel逐步積分法在精度范圍內其計算相位是沒有畸變的,中國地震局工程力學研究所頃土學位論文一但是中心差分方法, newmark中點加速度方法隨著采樣間隔及系統自振大,系統的固有自振周期被改變,其傳函數的共振區域與理論傳函數的共振區域會發生分離。
  2. The results showed that : ? apsaicin could significantly increase the frequency of miniature excitatory postsynaptic currents ( mepscs ), in another word, capsaicin could enhance the excitatory neurotransmitter release from primary afferent terminals. this is coincidence with the results of our previous studies

    第四軍醫大學碩士學位論文結果表明: coys能顯著加所記錄的微小興奮性突觸后電流( miniatureexcitatorypostsympticcurrents , inepscs )的,即強了初級傳入終末釋放興奮性神經質,這與我們以往的研究結果一致。
  3. Imaging interferometric lithography ( iil ) transfers different components of spatial frequencies through the same limited aperture at different time to enhance the resolution power of lithography with increasing less cost of system

    摘要掩模投影成像干涉光刻技術以在很小或幾乎不加光刻系統成本的基礎上來提高光刻解析度為目的,充分利用系統的有限孔徑,將掩模圖形不同的空間分別進行傳,最終以高解析度對掩模成像。
  4. Nowadays, with the appearance of lots of numerical control equipments and development of information technology, there are many important changes in model of shipbuilding, a remarkable one is that exchange of data for shipbuilding becomes mor and more frequently and the amount of data for exchange also increases rapidly. at the same time, more and more digital information is required to be numbered, and then, it is digital information that is transmitted between numerical control equipment, this model bring about remarkable increasment of productivity

    隨著信息技術的廣泛運用和大量數控設備的出現,現在造船模式較之以往已經產生了重大的變化,集中表現在生產數據的交換量空前龐大和交換加,大量的生產加工信息都需要數據化處然後由數據信息在數控設備之間傳,這種模式帶來了生產效的大大提高。
  5. The method for checking if transition interference is that transmitting a pure carrier, and monitoring it at downlink

    減的原因為,地球站的上、下行差與衛星的上、下行差有著微小的差別。 )
分享友人