選擇折射 的英文怎麼說

中文拼音 [xuǎnzháizhéshè]
選擇折射 英文
selective refraction
  • 選 : Ⅰ動詞1. （挑選） select; choose; pick 2. （選舉） elect Ⅱ名詞（挑選出來編在一起的作品） selections; anthology
  • 擇 : 擇動詞（挑選） select; pick; choose
  • 折 : 折動詞[口語]1. （翻轉） roll over; turn over 2. （倒過來倒過去） pour back and forth between two containers
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 選擇 : select; choose; opt; election; choice; culling; alternative
  1. The recording characteristics of the material are discussed in detail in terms of sensitivity, diffraction efficiency, bragg angle, refractive index modulation ( an ) and so on

    通過在材料中記錄無傾斜光柵，研究了該材料的全息存儲特性（包括衍射效率，靈敏度，動態范圍，折射率調制度，角度選擇性等） 。
  2. Ultraviolet absorption detector, photodiode array detector ( dad ), fluorescence detector, and electrochemical detector are optional detectors, response value of which is relative to not only quality of the object under test, but also structure of the compound ; refractive index detector and evaporative light - scattering detector are universal detector, responding to structure of all compounds ; evaporative light - scattering detector is quality - type detector, whose responding value only relates to quality of the object under test for compounds with similiar structures ; photodiode array detector ( dad ) can, at the same time, record absorption spectra of the object under test in a prescribed wave scope, consequently, it can be used in spectrum control and inspection of purity of chromatographic peaks of the object under test

    紫外、二極體陣列、熒光、電化學檢測器為選擇性檢測器，其響應值不僅與待測物的質量有關，還與化合物的結構有關；示差折光檢測器和蒸發光散射檢測器為通用型檢測器，對所有的化合物結構均有響應；蒸發光散射檢測器屬質量型檢測器，對結構類似的化合物，其響應值幾乎僅與待測物的質量有關；二極體陣列檢測器可以同時記錄待測物在規定波長范圍內的吸收光譜，故可用於待測物的光譜管制和色譜峰純度的檢查。
  3. The other is to combine with different material, in this way the key of design is to elect material with matching birefringent dispersion and similar physico - chemical nature

    另一種方法是採用不同的材料組合，設計的關鍵在於選擇雙折射色散相匹配、物化性能相近的晶體材料進行組合。
  4. Under our task experimental condition, we calculated the sensitivity of our planning to develop dial system with direct detection, besides, we studied the relationship between the sensitivity of measurement and atmospheric refractive - index structure constant and applied matlab program simulated the system parameters such as beam diameter, laser divergence angle, detection distance and gained relevant relationship curves

    在課題實驗條件下，模擬計算了直接檢測dial系統的測量靈敏度。在考慮大氣折射率結構常數對系統測量靈敏度影響的基礎上，並對各種系統參數如光束半徑、束散角和探測距離對測量靈敏度的影響運用matlab程序做了模擬計算，為合理選擇系統設計參數提供了依據。
  5. In this paper we have predicted two kinds of new quantum coherence effects. one is the strong - field index enhancement via selective population trapping of dressed states and the other is the preservation of the coherent population trapping ( cpt ) is by quantum interference of incoherent pump processes

    本文提出了兩類新的原子相干效應，一是利用選擇性修飾態捕獲產生強場折射率增強，二是非相干泵浦誘導的量子干涉保護相干捕獲。
  6. We have demonstrated a novel voa based on high birefringence fiber loop mirror, which has many advantageous characteristics such as a simple structure, high flexibility, polarization independence, low insertion loss and low price, etc. experimental proof shows that it is convenient to realize the control of optical power by using this voa

    2 .利用雙折射光纖環鏡設計並製作了一個結構簡單的可調諧光纖衰減器，具有靈敏度高，偏振無關，低插入損耗和低成本等特性。實驗證明它可以很方便的控制光功率。 3 .提出了一種由布拉格光纖光柵和高雙折射光纖環鏡共同構成波長選擇器件的摻鉺光纖激光器。
  7. Realizing the excellency of nd : yv04 crystal, we use nd : yv04 / ktp firstly in our experimentation. the loss of light with different polarized orientation is different, when it through nd : yv04 crystal. utilizing the case and changing the thickness of ktp crystal by controlling temperature, we get a narrow light filter, so the cavity operates with single longitudinal mode

    文中提出一種新的方案，採用nd ： yvo _ 4 ktp組合，利用nd ： yvo _ 4晶體對偏振態的選擇作用以及溫度控制ktp晶體長度，實現雙折射窄帶濾波，強制激光器工作在單縱模的模式下。
  8. For example, we studied the influence of angle to the propagation efficiency of y - type embranchment and influence of calculation window size, selection of reference refractive index, the interval between dots, the difference of refractive index to the calculation of bpm

    例如： y分支的夾角對y型分支波導光傳輸效率的影響，參考折射率的選擇、計算窗口的大小、格點間距值、折射率差的變化對bpm計算精度的影響。
  9. Operating modes of ln one - dimension anisotropic aeo device and kdp two - dimension isotropic and anisotropic aeo device are determined. the principle to determine electro - optic operating mode is that the difference of two intrinsic diffractive index doesn ’ t contain nature birefringence and the acousto - optic operating mode should achieve a higher acousto - optic merit value to improve the efficiency

    選擇電光工作模式時，以所選取的電光工作模式的兩個本徵模之差不含有自然雙折射量為最佳模式;選擇聲光工作模式時，以聲光優值盡可能大為原則，以便提高器件的衍射效率。
  10. The equivalent cavity model is used to deduce the threshold condition of the ecld, and the expression of the threshold carrier density n ( v ) when ecld is tuned to oscillate at different frequencies has been obtained. using the expression of n ( v ) and the carrier dependent refractive index, the simple basic equation describing the bistable characteristics has been derived after choosing an appropriate reference frequency nf

    通過建立等效腔模型來推導外腔半導體激光器的閾值條件，得到ecld在不同頻率v振蕩所需的閾值載流子密度n （ v ）表達式，利用該表達式及相關的折射率表達式，在選擇合適的參考載流子密度n _ f后，導出了一個描述雙穩所需的基本方程。
  11. Mechanical folding test was applied to analyze the crack behavior of dlc films. the results show that the crack appears due to the mechanical stress and the initiation and propagations of the cracks may be suppressed with higher rf power, bias voltage and gas pressure

    機械彎折試驗結果表明，沉積成膜過程中，應選擇較高的氣壓、基板負偏壓、射頻功率以及適量的n摻雜來制備抗往復彎折的、耐失效性能優越的膜層。
  12. Through the analysis, it is shown that : 1, while fabricating the grating, the principle of selecting the parameters is : the period should be as large as possible, the etching depth should be small and filling factor should approach to 0. 25. 2, if selecting the parameter combine the selecting principle and the requirement of concrete application, the space of selecting the parameter should be larger than before. 3, while the period to. 4a, the surface profile has no effect on the reflectivity

    通過分析發現： 1 、在製作有一定特性的光柵時，光柵參數的選擇原則為：周期的取值應盡量的大，刻蝕深度的取值應盡量的小，占空比的取值應盡量靠近f = 0 . 25 ； 2 、以參數的選擇原則結合製作的具體應用要求宋選擇光柵的參數，則各個參數的優化空間更大； 3 、當光柵的周期t 0 . 4時，表面面形對反射率沒有影響； 4 、運用臨界周期點隨折射率的變化規律，可以避免由於選擇光柵周期過大而出現一級衍射，從而導致製作失敗。
  13. We have completed the earlier stage research on theory analysis, fabricated the grin sphere lenses using two kind of monomer selected by suspension diffusion copolymerization method, measured their refractive index distribution curve and other optical parameters of them, and evaluated imaging quality on the basis of their distribution curve

    本工作對此種透鏡的光學性能進行理論分析，選擇兩種適當聚合物單體利用懸浮擴散共聚的方法加工制備此類微球透鏡，測量所得透鏡的折射率分佈曲線和其它光學參數，並對此種梯度折射率微球透鏡的成像特性進行了評價。
  14. Analysis indicates that circular shift block selected mapping algorithm may have well foreground of application with the number of bits required to represent side information much less with little loss of performance

    分析表明，循環移位分組選擇映射演算法可以取得性能和系統代價這二者的折衷，具有較好的實際使用價值。
  15. Firstly, based on the basic theory of grin optics the optical effects of the spherical symmetry grin micro - sphere lens were analyzed systematically. then two suitable monomers were selected to fabricate grin micro - sphere lens by suspension - diffusion - copolymerization method. finally, the refractive index distribution curve and other optic parameters of the micro - lens were measured

    本工作從梯度折射率介質光學的基本理論出發對球對稱grin微球透鏡的光學性能進行了系統分析；選擇兩種適當單體，採用懸浮擴散共聚法制備出聚合物梯度折射率微球透鏡；測量所得透鏡的折射率分佈曲線和其他光學參數。
  16. Ffars can be used effectively in any quantity required, from a few rockets fired at a single target to an entire barrage being placed on an area target

    機載折翼火箭可任意選擇投射量，既可向單個目標發射數枚，又可向集群目標進行密集彈幕攻擊。
  17. Furthermore two suitable monomers were chosen to produce such kind of grin polymer micro - spheres by suspension diffusion co - polymerization method. next, the refractive index distribution curve and other optic parameters of the micro - lens were measured

    進而選擇兩種適當的聚合物單體，利用懸浮擴散共聚的方法加工制備獲得此類微球透鏡，並測量了所得透鏡的折射率分佈曲線和其它光學參數。
  18. With former people ' s work, an appropriate method is applied to our analysis and design : a reasonable relation between refractive index profile in model and parameters in the fabrication technology is proposed, and on this basis single mode performance and half wave voltage are analyzed by vectorial fem

    結合前人的結果，本文提出了在針對本項研究課題的解決方法：根據一定的折射率分佈模型，結合實際的工藝條件，選擇合理的參數作為分佈模型中的參數，然後做矢量有限元分析。
  19. But, is also commonly used for controlling the concentration of various industrial fluids cutting lubricants and flux rinsing compounds

    這一系列的手持折射儀因不同的需要有各種測量范圍可選擇。
分享友人
分享到 Line

分享到臉書