邊寬邊距 的英文怎麼說

中文拼音 [biānkuānbiānjù]
邊寬邊距 英文
edge spacing
  • 邊 : 邊Ⅰ名詞1 （幾何圖形上夾成角的直線或圍成多邊形的線段） side; section 2 （邊緣） edge; margin; oute...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  1. Leaves 2, arising from the scale axils, membranous, elliptic to ovate, 1 - 4 cm long and 0. 5 - 2 cm wide, apex rounded or slightly acute, base rounded or cuneate, margin entire and wavy ; veins 3, middle veins conspicuous, margin veins ca. 0. 5 mm from the edge ; petiole 1 - 4. 5 cm long

    葉2片自鱗片腋部生出，薄膜質，長橢圓形或卵形，長1 - 4厘米，寬0 . 5 - 2厘米，先端圓或略尖，基部圓形或楔形，邊緣全緣呈波狀；葉脈3條，中脈明顯，緣脈距葉緣約0 . 5毫米；葉柄長1 - 4 . 5厘米。
  2. The beyond is the simple notation of serial number of pricker, totaled 7 digits of codes, in which the first digit represents the diameter of needle - bar of pricker, the second digit represents the siding of triangle side on functional section of pricker, the third digit represent the length of functional section of pricker, whereas in standard notation, it represents the distance from needlepoint to gradual deflating small port ( lower port ), the fourth digit represents the total length of pricker, which is the distance from the inside of bending helve to the needlepoint, the fifth digit represents the total quantity of dents on the cording of functional section, and the sixth digit represents the model of barb on functional section, while the seventh digit represents the distance between barbs on functional section

    以上為刺針編號的簡單寫法，共7位代碼，第一位是刺針針桿的直徑；第二位是刺針工作段三角面的邊寬；第三位是刺針工作段的長度，同標準寫法所不一樣的是針尖到漸縮錐小口（下口）的距離；第四位是刺針的總長度，按彎柄內側至針尖的距離；第五位是工作段棱上的總齒數；第六位是工作段上鉤刺的型號；第七位是工作段上鉤刺與鉤刺之間的距離。
  3. On that side it was a good many miles wide, but on the missouri side it was the same old distance across - a half a mile - because the missouri shore was just a wall of high bluffs

    在這一邊，河面有好幾英里路寬。不過在伊利諾斯州那一邊，還是原來那樣的距離半英里路寬因為在伊利諾斯州那一邊，沿岸盡是一堵堵高墻似的峭壁。
  4. In the second chapter, the fluid mechanics principle of vortex flowmeter at first was introduced. the classical theory about vortex flowmeter and the method of computational fluid dynamics about flow around body were expanded on, and the model of the single bluff body and the dual bluff body vortex flowmeter were constructed. and then, fvm - finite volume method - analysis software fluent was applied to analyze the flow phenomenon of flow over single bluff body or dual bluff body

    然後通過大量實驗和理論分析給出雙鈍體渦街流量計的設計準則：當管徑為d ，鈍體形狀為三角形，則鈍體設計參數為：銳邊寬度= 0 . 26d ，高度= 0 . 34d ，鈍體之間的距離= 1 . 2d （即當兩鈍體寬度相等且鈍體距離等於單鈍體兩列旋渦之間的距離） 。
  5. When the width of the foundation is smaller, the friction force is firstly increased from zero at the central area of the foundation, then decreased to zero at the edges of the foundation, hence there is a peak ; when the width of the foundation and the thickness of the soft ground is larger, the frication force is almost zero from the central area of the foundation to a certain distance, then increased, at last decreased to zero at the edges of the foundation, therefore there is a peak ; and when the width of the foundation is larger and the thickness of the soft ground is smaller, the friction force is firstly increased from zero at the central area of the foundation in the negative direction, then decreased to zero, so there is a negative peak, then increases in the positive direction, eventually decreased to zero at the edges of the foundation, hence there is a positive peak

    當基礎寬度較小時，從中心線為零處開始增加，達到峰值后，開始減小，直至基底邊緣處為零；當基礎寬度和軟土地基厚度較大時，從中心線處開始，向外側延伸一定距離，幾乎為零，然後開始增加，達到峰值后，開始減小，直至基底邊緣處為零；當基礎寬度較大，並且軟土地基厚度較小時，從中心線為零處開始反向增加，達到反向峰值后，然後反向減小，減小到零后，逐漸正向增加，達到峰值后，再逐漸減小，直至基底邊緣處為零。
  6. Her appearance belongs to the fire type, has sharp type of face, there are more black than white in the pupils of her eyes, both eyes are wide apart, the ears are lower than the eyebrows, her earlobes are thick and broad, protruding internal earbone, short nose, wing of the nose is frail and a little protruding, her mouth forms a line when it is closed, the sides of her mouth is slightly turn downwards, the thickness of the upper and lower lips is even, her cheekbones are not high, and the law grain is profound

    面相屬火，尖形臉，額頭高且突，下巴尖，眼珠黑多白少，兩眼間的距離開闊，眉陵骨凸，耳低於眉，耳珠厚和寬，內耳骨凸出，鼻短、鼻翼單薄和有點外仰，人中平滿欠缺凸下溝紋，嘴巴緊閉時成一線，嘴邊兩角微微向上彎，上下唇的厚度均勻，顴骨位置不高也不大但法令紋深長。
  7. The juridical continental shelf of a coastal or island nation consists of the seabed and subsoil of the submarine areas that extend beyond its territorial sea to the outer edge of the continental margin, or to a distance of 200 nautical miles from the baseline used to measure the territorial sea where the continental margin does not extend to that distance

    書上的翻譯：沿海國或者島國法律上的大陸架包括延伸到其領海以外直到大陸邊緣外部界限的海底區域的海床和底土;如果從測算領海寬度的基線起到大陸邊緣的距離不到200海里，則應擴展到200海里的距離。
  8. The approximate formula is : the initial bounding rectangle is inflated by pen width, and this result is multiplied by the miter limit, plus some additional margin to allow for end caps

    近似公式為：初始邊框按鋼筆寬度擴充，結果乘以斜接限制，再加上用以容納端帽的一些附加邊距。
  9. For the laminate which contains a crack, the suggested patch shape is rectangle, the patch thickness is equal to the parent laminate and the patch stacking sequence is the same as the parent laminate. because the length and the width of the patch have the fewer influence on the repair effect, the patch has the least weight on the basis of enough edge distance, end distance and space having been promised

    ?對于含裂紋復合材料層壓板，長方形補片的長度和寬度對修補效果沒有非常明顯的影響，因此在保證連接邊距、間距和端距的條件下，補片大小的選擇應該以節省重量為原則；而當補片的鋪排順序與母板相同、相對厚度為100時能夠獲得比較好的修補效果。
  10. Adjust pkt panel width to spec and raise pkt placement 1 / 4 " from btm edge

    調整袋寬以達到尺寸表要求尺寸，袋位升高至距底邊1 / 4 "
  11. Secondly we use canny arithmetic operators to get the edge of image, and remove the short link of edge then link the edge with small clearance. at last we can calculate the distance of conductor and the width of conductor according to the grade direction to detect of defect of the circuit boards

    然後選用canny運算元提取導線邊緣，並對邊緣進行短分支去除和邊緣連接處理，最後根據梯度方向來計算導線間距離和導體寬度，以此來判斷電路板缺陷。
  12. That represents the widths of all the cell margins

    ，它表示所有單元格的邊距寬度。
  13. Gets or sets the padding width for the top edge of a docked control

    獲取或設置停靠控制項的頂邊緣的邊距寬度。
  14. Gets or sets the top margin width, in hundredths of an inch

    獲取或設置上邊距寬度（以百分之一英寸為單位） 。
  15. Gets or sets the left margin width, in hundredths of an inch

    獲取或設置左邊距寬度（以百分之一英寸為單位） 。
  16. Gets or sets the right margin width, in hundredths of an inch

    獲取或設置右邊距寬度（以百分之一英寸為單位） 。
  17. The system resizing border width is used instead of visual style content margins

    使用系統可調邊框的寬度，而不使用視覺樣式的內容邊距。
  18. Gets or sets the padding width for the left edge of a docked control

    獲取或設置停靠控制項的左邊緣的邊距寬度。
  19. The thickness, in pixels, of the divider the column s right margin

    分隔符（該列的右邊距）的寬度（以像素為單位） 。
  20. The distribution of streak width along the lateral direction shows that the width attains its maximum value at the central line and becomes narrower toward the side wall, and its distribution is symmetrical about the central line of the flume

    低速帶寬度在水槽中心位置最大，往兩邊的邊壁逐漸減小，而且在橫向上相對於水槽中心線對稱分佈。低速帶間距與寬度的比值約為2 0 。
分享友人
分享到 Line

分享到臉書