配光 的英文怎麼說

中文拼音 [pèiguāng]
配光 英文
candle power distribution
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  1. A lot of engineering applications are carried out using our proposed method in this paper, such as thermal deformation measurement of a car lamp, analysis of the super low frequency harmonic vibration of a piezoelectric ceramic, dynamic mechanical behavior analysis of the ballistite material and so on

    在前面所提出的理論基礎之上，本文對該方法在實際工程中的應用做出了大量的工作。本文利用時間序列法實現了汽車前燈配光鏡的熱變形檢測、壓電陶瓷片的超低頻振動分析以及火箭固體燃料的動態力學特性研究。
  2. Candle power distribution curve

    光度配光曲線
  3. Contour map of light

    配光曲線
  4. The low beam clear distinguishes the light and shadow parts with obvious dividing line, what is the legal excellent light shape and will be soft to vehicle and passerby

    近光燈影明暗分明，截止線清晰可見。具有符合法規的良好配光光形，對車輛及行人不會造成刺眼的亮光。
  5. Photometric characteristics of moped headlamps

    輕便摩托車前照燈配光性能
  6. Photometric characteristics of headlamps for motor vehicles

    汽車前照燈配光性能
  7. Chapter two describes the technology require of the dwdm system. comparing the definition and target of technology parameter which should be uesd during the projet. for example, the distribution of the wave length, the interface of the laser, the laser amplifier etc.

    第二章描述了目前dwdm系統的技術要求，對在工程應用中需要用到的技術參數（例如波長分配、光介面分類、光放大器等）的定義、要求做了剖析。
  8. Agricultural vehicles - photometric characteristics of turn signal lamps

    農用運輸車轉向信號燈配光性能
  9. Photometric characteristics of parking lamps for power - driven vehicles

    汽車駐車燈配光性能
  10. General : lsz serials double - rotator flowmeter also called bi - rotor flowmeter is a self - research nbs.

    並可配光電脈沖轉換器輸出電脈沖電流信號. .
  11. Provides industrial i o solutions for measurement and control applications. signal conditioning, pc data acquisition, vme boards, lonworks, and ip modules for analog and digital i o. instrumentation products include transmitters, isolators, and alarms

    -代理歐美光學儀器及光學材料：亮度計色度計配光性能光環境測試高吸收發黑塗料高反射材料積分球塗料等。
  12. The wave - front aberration ' s cumulating of optics elements in multi - pass amplifying system was researched more deeply. considering the correlation between optics elements " wave - front aberrations caused by the similar fabrication technique, the correlation coefficient was adopted to revise calculation rule of superimposition which used in estimating system ' s static wave - front aberration and allocating optical machining precision. 3

    進一步研究了多程放大系統中光學元件波前誤差的疊加規律，並考慮到釹玻璃片加工工藝的相似性所導致的波前相關性，將相關系數耦合到波前誤差疊加公式中，使修正後的公式能更準確地預估系統靜態波前和分配光學元件加工精度要求； 3
  13. The dome - top, plane - top ; large - reflective bowl, small - reflective bowl ; wild - degree bowl, narrow - degree bowl ; deep assembling, middle assembling and low assembling led tubes were simulated and experimentally measured for comparison. some conclusions can be drawn that the simulation results fit the experimentation results well in the light distribution. this testified that monte carlo method is one of the effective tools for led light ' s optical design

    根據驗證和分析比較不同led光學結構的需要，製作了有代表性的19種管型的樣管，分別對其模擬模擬輸出配光曲線圖和測試，在模擬光子數設定為10000000個， 1000次反射無出射視為光子被吸收等參數條件下，得到模擬和測試所得配光曲線在一定的誤差范圍內是相同的。
  14. Photometric characteristics of front and rear position lamps, end - outline marker lamps and stop lamps for motor vehicles and and their trailers

    汽車及掛車前位燈后位燈示廓燈和制動燈配光性能
  15. And then the theoretic technique of import the periodically wave of periodically poled crystals in the process of opo was studied, the theoretical method was realized by using period poled crystal in quasi - phase - matched optical parametric oscillation

    研究了將周期極化晶體的周期波矢引入光學參量振蕩過程，利用周期極化晶體實現準相位匹配光學參量振蕩的理論方法。
  16. Light distribusion curve

    配光曲線
  17. Lighting by means of luminaires with a light distribution such that not more than 10 per cent of the emitted luminous flux reaches the working plane direct, assuming that this plane is unbounded

    採用具有一定配光曲線的燈具進行照明，在不考慮工作面邊界時使得直接到達工作面的光通不超過總光通的10 %的照明方式。
  18. Photometric characteristics of front fog lamps for motor vehicles

    汽車前霧燈配光性能
  19. Photometric characteristics of rear fog lamp for motor vehicles and their trailers

    汽車及掛車后霧燈配光性能
  20. The development trend of the headlamp is distributing light with the reflector which is difficult to design, so its design must take advantage of the cad technique and is guided by the computational simulation software

    汽車前照燈發展趨勢是通過反射鏡配光，然而這種前照燈的設計的難度比傳統的前照燈大，因此它的設計必須採用cad技術，並使用模擬計算軟體作為設計的指導。
分享友人
分享到 Line

分享到臉書