配置電路比較 的英文怎麼說

中文拼音 [pèizhìdiànlùbǐjiào]
配置電路比較 英文
layout-circuit comparison
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 較 : Ⅰ動詞1 （比較） compare 2 [書面語] （計較） dispute Ⅱ副詞（比較） comparatively; relatively; fair...
  • 配置 : dispose （troops, etc. ）; deploy; allocation; collocation; configuration; positioning; allotment
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  • 比較 : 1 （對比） compare; compare with; contrast; parallel （with）; comparison; by comparison; in comp...
  1. In this paper, we begin with actual products designs and then combine the real conditions. on condition that technique conditions requirements were satisfied, by adopting electromagnetic field numerical analysis and experimental research, the electric field distribution inter - phase and to ground of 12kv metalclad withdraw switchgear vacuum circuit breaker is described accurately. the electric field distribution and movement in different conditions are also confirmed

    本文從實際產品設計入手，結合現實情況，在滿足技術條件要求的基礎上，通過採用電磁場的數值模擬分析及實驗研究，準確地描述了12kv配電系統中置櫃真空斷路器相間及對地全場域電場分佈情況，確定了中置櫃在不同情況下的電場分佈、變化情況，通過理論的計算和分析，對產品的絕緣進行了校核與驗證，通過多種方法的比較，進而得到合理的布置結構和達到最佳的絕緣配合，為實際產品的開發和設計提供了理論依據。
  2. The device can measure reactive parameters in distribution power net which are generally considered to he difficultly measured the paper also introduces the calculating method of the reactive compensation capacity and its optimal location, the design method and realization principle of the series devices, such as the reactive power acquisition device, the reactive power optimized controller and the compensation capacitor operator, is seated in detail through economic and technical comparison, a realistic hardware scheme of reactive power compensation system is proposed

    文章利用電磁感應原理和數字通訊技術結合試驗設計出電源自給式高壓線路無線信號採集裝置，解決了配電網分支線路無功參數不易測量的問題。文章還介紹了系統無功補償容量及安裝位置的計算方法，較為具體的講述了無功功率採集器、無功優化控制器以及補償電容操作器等一系列裝置的設計方法和製作原理。通過經濟技術比較提出了一整套切實可行的無功補償系統硬體製作方案。
  3. Appling immune algorithm to optimum disposal of shunt capacitors on distribution network was studied according to reality. methodology of shunt, capacitors disposal on distribution network is presented and optimum capacitors disposal program was got through simulation arithmetic. this paper presented a practical capacitors grouping program also. these programs were validated practial and economical. by comparing the astringency of immume algorithm to genetic algorithm the conclution that immune algoritnm has faster caculation speed and better global convergence ability in optimum disposal of shunt capacitors on distribution network was got

    模擬計算得出電容器配置方案，並對電容器進行合理分組，經過分析得出該配置方案可行而且經濟。同時，本文對遺傳演算法和免疫演算法的收斂性進行比較，得出免疫演算法收斂性較好，收斂速度快。配電網路的復雜，以往的優化演算法在解決配電網電容器配置問題時由於演算法的缺陷，往往缺乏足夠的優化手段。
  4. Layout - circuit comparison

    配置電路比較
  5. Through the design the dc feed network, input matching network for the ne900175 gaas fet and analysis the stabilization, power gain, bandwidth of the power amplifier we get the power amplifier is stability, the power gain is 11. 967db and the bandwidth is 300mhz. microstrip antenna has a narrow bandwidth, in this design antenna ' s bandwidth is 100mhz. antenna is the not only the load of the power amplifier, but also as the filter connecting to the output of the power amplifier

    E類功放的pae相對a類、 b類、 ab類的功率放大器類型而言比較高，在50 ? 70 。分析了e類功放的工作過程后，以ne900175的gaas場效應管作為e類功放電路的開關，進行了外圍電路的設計，包括直流偏置電路、輸入匹配網路的設計，功放的穩定性、帶寬、增益的分析。該功放增益最大達到11 . 4db ，帶寬為320mhz 。
  6. And then, the different demands of position detecting on different light source and different distance are discussed. the different effects of position detecting on different circuit parameters and different center - filter frequencies are compared experimentally. after analyzing the factors that influence the speed and the precision of position detecting, the paper put forward the improving measures

    本文對不同環境光照和不同測試距離下的位置測量要求進行了探討，對不同的電路匹配參數和不同濾波中心頻率的位置測量結果進行了實驗比較，認真分析了影響位置測量響應速度和精度的因素，提出了提高psd器件的抗雜光干擾能力和位置測量精度的措施。
分享友人
分享到 Line

分享到臉書