配製件 的英文怎麼說

中文拼音 [pèizhìjiàn]
配製件 英文
fitting piece
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  1. Containers and accessories for pharmaceutical preparations - part 5 : dropper assemblies iso 11418 - 5 : 1997

    藥品配製用容器及附件.第5部分:滴管組件
  2. Studies showed that process and condition control had critical effect on the preparation of yig phase, and the proper conditions specialized as follows : using ammonia - ammonium nitrate ( nh3 - nh4no3 ) as precipitant, ph scope from 10 to 10. 5, using dissolving salt as law materials, dropping their mixed solution into precipitant, precipitation rate at 0. 8ml / min

    研究表明，共沉澱的過程和條件控制對yig的合成具有重要影響。實驗得出共沉澱的合適條件為：以nh _ 3 - nh _ 4no _ 3為緩沖溶液，控制ph范圍為10 . 0 ? 10 . 5 ，採用可溶性鹽為原料配製溶液，滴加到沉澱劑中的共沉澱方式，共沉澱速度為0 . 8ml min左右。
  3. Abstract : in this paper the gasification characteristics of two - phase anaerobic membrane biosystem ( mbs ) were studied by experiment using starch wastewater. effects and phenomenon of system ？ s energy recovery was analyzed

    文摘:在實驗室條件下，以澱粉配製廢水為原水對兩相厭氧膜生物系統（ mbs系統）產氣特性及其規律進行了試驗研究，討論並解釋了該系統在能源回收過程中的現象和影響因素。
  4. Used to component joint water - proof, building distortion seam, construction seam and metal, concrete etc seam water - proof, for example, tunnel, substructure etc underground seam water - proof construction

    適用於裝配式結構構件砌接縫防水，建築物變形縫、施工縫用和金屬、混凝土等各類預製件的接縫防水，例如：隧道、人防、基礎工程等地下工程的接縫防水。
  5. Based on gb2374 - 80 are the specification and density of the chemicals, the compounding of the dyestuff, the specification of the fibres and the general conditions of dyeing

    （ 1 ）染色對所用藥劑的規格和濃度，染液的配製，纖維規格以及染色對一般條件規定，按gb2374 - 80中規定進行。
  6. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  7. Our factory is a specialized producer engaging in lighting fitting so fhahdware pressing, drawing, die - casting and spinning

    本廠是從事開發製造五金沖壓、拉伸、壓鑄、旋壓燈飾配件的專業廠家，也是與多家大型燈飾廠生產配套件的廠家。
  8. Conclusion is drawn that 150 # mortar can be manufactured, adopting industrial waste slag, yellow sand and cement after which are ground, and with the proportion design of cementitious component : sand of 1 : 4, cement : phosphor slag : flying - ash : gypsum of 30 : 45 : 23 : 2 in cementitious materials, and cement : mortar of 6 percents. it leads economical, social, and environmental benefit

    試驗結果表明，採用昆明本地的工業廢渣、黃砂和水泥，通過適當的細磨、復配技術，在膠：砂= 1 ： 4 ；膠凝材料中水泥：磷渣：粉煤灰：石膏= 30 ： 45 ： 23 ： 2 ，干拌砂漿中水泥的質量只佔6的條件下，可以配製出150 #砂武漢理工大學工程碩士學位論文漿。
  9. In the paper the effects of the made parameters, the main materials and environmental conditions on plastic shrinkage cracking were investigated. it can be concluded as following : 1 ) there was a critical w / c ratio of maximum plastic shrinkage cracking between lower and higher w / c ratio of concrete mixtures made with the same cement content per cubic meter, concretes with lower or higher w / c ratio being less prone to plastic shrinkage cracking and the w / c critical ratio critical of maximum plastic shrinkage cracking being about 0. 5

    本文研究了配製參數、主要原材料以及環境條件對新拌混凝土塑性收縮裂縫的影響，結果表明： 1 ）單方混凝土水泥用量一定時，較低水灰比和較高水灰比對應的混凝土拌合物不易開裂，而中間某一臨界水灰比對應的混凝土拌合物開裂較嚴重，這一臨界水灰比為0 . 5 ；單方混凝土水用量或水泥漿量一定時，混凝土拌合物的塑性開裂趨勢與上述情況相似，但臨界水灰比分別為0 . 45 - 0 . 4和0 . 4 。
  10. Another possibility is to use simple on - site fabrication facilities to aid quality assurance and to reduce construction time

    另一種可能性是使用簡單的現場裝配組件製造設備，保證質量並且降低施工時間。
  11. In this paper, on the foundation of synthesizing engineering practice and study result of planted bar technique by chemistry glue on the domestic and international, embedded experiment study and theories analysis are done about bonded anchor behavior of chemistry planted bar anchorage behavior in this paper, the experimental results of 32 pulling resistance test ( meiya z3530 ) are given, considering some factors to affect bonded anchor behavior of chemistry planted bar such as the strength of concrete anchorage lengths diameter of steel bar and holes thickness of the protecting layer confecting circumstance of the hoop bar and quantity of construction especially which is very easy to be neglected and so on, and bonded anchor mechanism failure mode load carrying capacity and slide behavior are analyzed in - depth

    本文在綜合國內外化學膠植筋技術的工程實踐和研究成果的基礎上，對化學植筋的粘結錨固性能作了較深入的試驗研究和理論分析。文中通過32個化學膠（美亞z3530 ）植筋試件的拉拔試驗研究，考慮混凝土強度、錨固長度、鋼筋植筋、鉆孔孔徑、保護層厚度、箍筋配製情況及施工質量等因素對植筋粘結性能的影響，特別是植筋的施工質量對粘結性能的影響是比較容易被忽視的因素，對化學植筋的粘結錨固機理、破壞形態、承載力及滑移性能作了比較深入的剖析。
  12. In the second part, the concrete test cubes are made and their basic physics and mechanics properties are determined

    第二部分主要是配製混凝土試件並測定其基本的物理力學性能。
  13. The grouting liquid with this stability agent has many advantages such as the good volume stability, low dialysis ratio, high strength of cement rock less dry - shrink and convenient construction etc. when the water - cement ratio is 0. 6 or 0. 8, the 28d strength of cement - rock is 210 % and 179 % of the bentonite cement - rock under standard maintain

    該穩定劑配製的水泥漿具有體積穩定性好、不析水、結石強度高、不幹縮、施工方便等優點。如水灰比0 . 6 、 0 . 8時，標準養護條件下28d強度分別較膨潤土水泥漿結石提高100和80以上， 20水中養護28d強度則提高30左右。
  14. Specification for steel butt - welding pipe fittings for the petroleum industry - wrought carbon and ferritic alloy steel fittings - metric units

    石油工業用鋼質對接焊管配件規范.鍛制碳鋼與鐵素體合金鋼配件:米製件
  15. It has the performance of self cross - linking at mormal temperature, and the cross - linking density will be higher at 50c

    在50攝氏度條件成膜，交聯度會更高，配製的水性漆漆膜具有極好的硬度、光澤、豐滿度、耐水性及耐磨性。
  16. Structural use of steelwork in building - specification for materials, fabrication and erection - rolled and welded sections

    建築物中結構用的鋼製件.材料製造和裝配規范.軋制及焊接型材
  17. Used to configure, customize, and assemble the components

    ，用於配置、定製和裝配組件。
  18. “ [ the latter ] will allow staff to work under cover, uninterrupted by the weather, and will also accommodate additional cranes to build pre - outfitting units to a higher degree of completion than all previous carriers, ” says shawcross

    「 [稍後]工作人員將在屋頂下工作，不會受天氣影響，我們還要提供更多的起重機來製造與所有以前的航母相比完成度更高的預裝配部件， 」肖克羅斯說。
  19. Gossler fluidtec gmbh deals among other things in rubber seals, moulded rubber parts as well as in hose fittings, turned seals and also in fittings for industrial application

    Gossler fluidtec gmbh是一家高效的工業型企業，企業生產橡膠密封，橡膠模製件、橡膠成型件，軟管配件，工業用附件范圍內高水平的產品。
  20. The coordination and decision center is composed of four components : supply chain planning, suppliers matching and selection, manufacturers matching and selection, customers matching and selection component

    供應鏈協調決策中心由供應鏈規劃組件、供應商選擇與匹配、製造商選擇與匹配、客戶選擇與匹配等組件構成。
分享友人
分享到 Line

分享到臉書