酰胺環氧樹脂 的英文怎麼說

中文拼音 [ànhuányǎngshùzhī]
酰胺環氧樹脂 英文
amide epoxy resin
  • 酰 : 名詞[化學] （酰基） acyl
  • 胺 : 名詞[化學] amine （氨 nh3 分子中部分或全部氫原子被烴基取代而成的有機化合物）
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 樹 : Ⅰ名詞1 （木本植物的通稱） tree 2 （姓氏） a surname Ⅱ動詞1 （種植; 栽培） plant; cultivate 2 （樹...
  • 脂 : 名詞1. （動植物所含的油質） fat; grease; tallow 2. （胭脂） rouge 3. （姓氏） a surname
  • 環氧 : epoxy
  • 樹脂 : resin; jaffaite; peucine
  1. The product is a chief material for high temperature insulant, used mainly for the producing of polyimid resin, thin film, and insulating paint. it is also a high temperature curing agent and plasticizer. some kinds of curing agents of powder coating are made from it

    主要用於制聚酰亞胺樹脂，聚酰亞胺在廣泛的溫度范圍內具有優良的電氣絕緣性能，亦可做耐高溫環氧樹脂固化劑聚氯乙烯增塑劑及皮革柔軟劑，還可用做某些粉末原料。
  2. Used for producing polyester resin, polyimide resin, water soluble, alkyd resin, water soluble polyurethane resin, plasticizer, water soluble amino - alkyd resin, curing agent for epoxy resin, aeroengine oil, electric capacitor maceration oil, binder, sizing agent, smoke suppressor, instant binder, etc.

    ：用於製造聚酯樹脂及聚酰亞胺樹脂水溶性聚脂樹脂水溶性聚氨酯樹脂增塑劑和水溶性氨基醇酸樹脂環氧樹脂固化劑以及高級航空潤滑油電力電溶器浸漬油粒料粘結劑施膠劑消煙劑瞬時粘結劑等
  3. In this paper, the vacuum thermo - cycling effects and vacuum ultraviolet effects on space inflatable structural materials were analyzed based on a thorough survey over the studies done through flight tests, ground simulation experiments and theoretical research. the main contents of this thesis are as follows : the performance damage effects of thermo - cycling on space inflatable structural fabric carbon fiber reinforced epoxy laminates ( cf / ep ), aluminized kapton ( al / kapton ) films which used as reflector of space inflatable antenna were investigated by a temperature range of - 120 120 with the vacuum degree 10 - 5 pa which conducted with space environment ground - based simulation facility

    本文在對國內外飛行試驗、地面模擬試驗以及理論研究等所取得的成果調研的基礎上，針對空間充氣結構材料進行地面模擬真空熱循環與真空紫外輻照的研究工作:利用真空熱循環地面模擬試驗機研究了真空環境（ 10 - 5pa ）中- 120 120的熱循環條件下空間充氣支撐結構織物碳纖維增強環氧樹脂（ cf / ep ）層合材料、空間充氣展開天線反射面鍍鋁聚酰亞胺（ al / kapton ）薄膜的空間環境效應。
  4. The results from basic properties, shear resistance, pressure strength and point film test show that different low molecular polyamide may affect extrodinary by the properties of cured expoxy resin the higher viscosity, the lower cured activity ( rate ) ; the higher amine number, the stronger cure construction. the cured expoxy resin will prossess unfavourable mechanics when it is cured by the polyamide with both too high viscosity and amine number

    用基本性能、剪切強度、抗壓強度、塗膜性能測定等方法研究了3種不同胺值及粘度的低分子量聚酰胺對環氧樹脂固化物性能的影響.結果表明，聚酰胺粘度大使固化交聯變難，胺值過高易造成固化收縮；同時粘度過大、游離胺含量過高的產品將對固化物各項力學性能不利
  5. Abstract : anticorrosive process for the drinkable water container of world is described, and wide - ranging applied epoxy is stressed. the different material, such as steel, cement and plastics container is explained. application of coating : paint designs, paint process, on - the - spot management, after paint handling are illustrated by the aminopolyimide epoxy. the conclusion is that the year of anticorrosive result can reach 5 years with perfect surface process and aminopolyimide epoxy painted

    文摘:簡介國內外生活飲用水容器應用塗料進行防腐處理的情況，就其中應用最廣泛的環氧樹脂塗料著重進行說明，根據生活飲用水容器的不同基材，就鋼質容器、混凝土水池和塑料容器的基材表面處理進行了論述，以聚酰胺環氧樹脂為例，從塗裝設計、塗裝過程、現場管理、塗裝后處理等方面對塗料的應用進行闡述；文章認為，只有基材表面處理恰當，採用聚酰胺環氧樹脂進行防腐處理，飲用水防腐效果可以滿足5年以上。
  6. When change the component of adhesive its shear strength increased from 39. 3 mpa to 53. 5 mpa at room temperature and it have long - term usage at 180 with 25 mpa and can be served at 230 in short period. the addition of liquid rubber resulted in a 300 % increase in the peeling strength. the addition of polymer ether imide led to a 260 % increase in the peeling strength, a 15 % increase in shear strength and a 10 increase in tg ( tg = 195. 54 )

    研究結果表明： bmi dds e ? 51 tde ? 85組成的膠粘劑體系的室溫剪切強度為39 . 3mpa ，當改變環氧樹脂的含量時，剪切強度提高到53 . 5mpa ；用無規羧基液體丁腈橡膠改性環氧樹脂膠粘劑時室溫剝離強度提高3 . 0倍；用聚醚酰亞胺改性環氧樹脂膠粘劑，室溫剪切強度最高可達45 . 2mpa ，剝離強度提高2 . 6倍，玻璃化轉變溫度tg = 195 . 54 ，比未增韌體系提高10以上；碳纖維耐磨材料與同步器圓錐環的粘接實驗結果表明，膠粘劑的使用工藝性能良好，滿足室溫剪切強度30mpa和180剪切強度12 . 5mpa的技術要求。
  7. Firstly, this paper dealt with the preparations of conducting electrostatic coating, which was used on large petroleum storage tanks, by using the modified epoxy and polyamide resin as the film forming resin and the carbon nano tubes and mica as conducting carrier, through an analysis of its composition and its mechanism of action

    通過分析塗料各組成成分的作用機理，制備了以改性環氧樹脂/聚酰胺為成膜樹脂，以碳納米管與復合導電雲母粉作為導電填料的大型儲備油罐用導電塗料。
  8. The followings are carried out for ballistic composite with resin matrix to realize its double function of loading and bulletproof and meet various tactics technology demands in the paper 1. the resin and reinforcement for arms ballistic system are selected and ballistic properties for composites with different resin matrixs ( improved phenolic, polyethylene, rubber, bi - phenol - a, and biamaleimide ) and different fibers ( kevlar, glass, carbon and uhmwpe fiber ) are investigated, with the aim of maxwell model to explain the matrix match principle for ballistic composites

    1 、本論文從材料選擇入手，進行了復合裝甲防彈體系用樹脂、增強材料進行了選擇和研究，考核了不同樹脂類型（改性酚醛、聚乙烯、橡膠、雙酚a環氧和雙馬來酰亞胺體系） 、不同纖維（ kevlar纖維、玻璃纖維、碳纖維、高強聚乙烯纖維）復合材料的防彈性能，並引入maxwell模型較好地解釋防彈復合材料的基體匹配原理。
  9. Diacetone acrylamide is an important kind of refined chemical industry product. it is widely used in coating, adhesive, epoxy resin curing agent, light - sensitive resin auxiliary agent, textile auxiliary agent, medical sanitation as well as many other fields

    雙丙酮丙烯酰胺是一種重要的精細化工產品，廣泛應用於塗料膠粘劑環氧樹脂固化劑感光樹脂助劑紡織助劑醫療衛生等領域。
  10. Method for analysis of hygienic standard of epoxy coating for inner wall of food container

    食品容器內壁聚酰胺環氧樹脂塗料衛生標準的分析方法
  11. The physicochemical characterization was made in depth using various techniques for some resin matrices of advanced composites, such as epoxy resin matrix, phenolic resin matrix and bismaleimide resin. these techniques include infrared spectroscopy ( ir ), nuclear magnetic resonance spectroscopy ( nmr ), mass spectroscopy ( ms ), liquid chromatography ( lc ), thermal analysis ( ta ) and other techniques. the composition, structure, molecular weight, reactivity, reaction temperature and other properties related to performance of resin matrix were studied

    本論文採用紅外光譜、核磁共振波譜、質譜、液相色譜、熱分析等分析技術對實際使用的環氧樹脂、酚醛樹脂以及改性雙馬來酰亞胺樹脂等先進復合材料樹脂基體進行了物理化學表徵，尤其是對與樹脂基體性能密切相關的化學組成與結構、分子量、活性與反應溫度、固化度等進行了表徵；提出了樹脂基體的固化反應機理，獲得了樹脂基體的固化反應動力學參數；對改性雙馬來酰亞胺樹脂的熱分解機理進行了分析，並得到了其熱分解動力學數據。
  12. Steel tubes. internal two layers coating with phenol resin or epoxy resin and polyamide based coating

    鋼管.帶有酚醛樹脂或環氧樹脂及聚酰胺基塗層的內部雙層覆層
分享友人
分享到 Line

分享到臉書