醛試驗 的英文怎麼說

中文拼音 [quánshìyàn]
醛試驗 英文
aldehyde test
  • 醛 : 名詞[化學] （有機化合物的一類） aldehyde
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Acetaldehyde for industrial use. methods of test

    工業用乙醛.試驗方法
  2. Standard test method for acidity in vinyl acetate and acetaldehyde

    乙酸基乙烯酯和乙醛酸度的標準試驗方法
  3. In the experiment of searching the agent for removal of phaeocystis globosa, six organic biocides were studied on their effect of removal of phaeocystis globosa. then isothiazolone biocide, glutaric dialdehyde and benzalkonium bromide were selected to apply to remove p. globosa red tide. their minimum use levels are 1. omg / l, 1. 4mg / l, 0. 6mg / l respectively, and the efficiencies of removal are above 80 %

    論文對有機除藻劑進行了篩選研究，對目前常用於工業循環冷卻水的6種有機殺生劑進行了試驗研究，發現異噻唑啉酮、戊二醛和新潔而滅對棕囊藻均具有良好的去除效果，它們使用的最低有效濃度分別是： 1 . 0mg l 、 1 . 4mg l 、 0 . 6mg l ，除藻率達80 。
  4. The factors influencing on the performance of ash - jd such as the moore ratio of monomers, the reaction temperature and time, concentration, the ph value of reaction solution and the drippy speed of formaldehyde were studied carefully. through experiments, the optimum level of those factors was gained

    論文詳細研究了反應單體的摩爾比、反應溫度、時間、濃度、反應溶液的酸堿度及甲醛的滴加速度等對產品ash - jd性能的影響，通過試驗，得到了這些因素的最佳水平。
  5. Furfural for industrial use. methods of test

    工業用糠醛.試驗方法
  6. Methods of testing plastics - other properties - determination of gelation time of phenolic resins

    塑料的試驗方法.其他特性.酚醛樹脂膠凝時間的測定
  7. Testing of plastics ; determination of the free phenol in phenolic moulding materials ; photometrical method

    塑料的試驗.酚醛模塑材料中游離酚醛含量的測定.光度
  8. Several kinds of fillers, i. e., phenol - formaldehyde, alkyd, polyester, polyurethane and poly - vinyl - acetate, were tried to coat surface of wheat straw board ( wsb ) in this paper

    摘要對麥?人造板表面分別試驗了酚醛樹脂、醇酸樹脂、聚酯樹脂、聚氨酯、聚醋酸乙烯酯膩子，塗刮膩子后再噴塗丙烯酸漆，並測定漆膜附著力。
  9. Hot - setting phenolic and aminoplastic wood adhesives - classification and test method

    熱固酚醛和氨基塑料木材膠粘劑.分類和試驗方法
  10. Standard test methods for chemical analysis of poly vinyl butyral

    聚乙烯醇縮丁醛的化學分析的標準試驗方法
  11. In this paper, polyvinyl - butyral ( pvb ) and methyl cellulose ( mc ) are chosen as chemical additives to amend the property of normal mortar, orthogonal tests of 96 pieces of shear specimens are carried out, then orthogonal analysis of test results is performed

    採用聚乙烯醇縮丁醛和甲基纖維素對普通砂漿做合理改性，進行了96個抗剪試件的正交試驗，並對試驗結果進行正交分析。
  12. Standard test method for measurement of evolved formaldehyde from water reducible air - dry coatings

    由可水減的空氣乾燥塗層離析的甲醛的測量的標準試驗方法
  13. Test method for qualitative determination of methylol group in phenolic resins

    酚醛樹脂中羥甲基組團定性測定的試驗方法
  14. A study on co2 - cured phenol - formaldehyde resin used in foundry

    2硬化堿性酚醛樹脂的試驗研究
  15. Technical furfural test methods

    工業糠醛試驗方法
  16. Standard test method for aldehydes in styrene monomer

    苯乙烯單體中醛含量的標準試驗方法
  17. Standard test method for determination of phenolic antioxidants and erucamide slip additives in polypropylene homopolymer formulations using liquid chromatography

    用液相色譜法對聚丙烯均聚物配方中酚醛抗氧化劑和酰胺纖維潤滑添加劑測定的標準試驗方法
  18. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    對漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試，選擇性能優良的糠醛?丙酮活性稀釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比， cw系漿液粘度、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固結強度高，具有優良的浸潤性能和工藝性能。
  19. Standard test method for determination of percent nonvolatile content of liquid phenolic resins used for wood laminating

    木材層壓板用液態酚醛樹脂中非揮發物含量百分比測定的標準試驗方法
  20. Paraformaldehye for industrial use. methods of test

    工業用多聚甲醛.試驗方法
分享友人
分享到 Line

分享到臉書