釋放試驗 的英文怎麼說

中文拼音 [shìfàngshìyàn]
釋放試驗 英文
atp-lt
  • 釋 : Ⅰ動詞1 （解釋） explain; elucidate 2 （消除） clear up; dispel 3 （放開; 放下） let go; be reliev...
  • 放 : releaseset freelet go
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 釋放 : 1 （恢復被拘押者的人身自由） release; deliver; clearing; set free 2 [物理學] relief; rid; detachm...
  • 試驗 : trial; experiment; test
  1. Hard coal - froth flotation testing - release evaluation

    硬煤.泡沫浮選試驗.釋放評價
  2. Aerospace series. elements of electrical and optical connection. test methods. part 414 : unmating of lanyard release connectors

    航空航天系列.電氣及光學連接元件.試驗方法.第414部分:牽索釋放連接器的非配合
  3. Plastics - simple heat release test using a conical radiant heater and a thermopile detector

    塑料.用錐形輻射加熱器和熱電堆探測器進行簡單熱釋放試驗
  4. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發的過程進行干濕對比數值模擬試驗，得出：潛熱釋放使對流層項和等溫面抬高，氣流在高層的上升冷卻形成擾動槽，其適應過程使高層出現慣性不穩定。
  5. Methods of test for paints - determination of release rate of biocides from antifouling paints - general method for extraction of biocides

    塗料的試驗方法.用殺菌劑的一般萃取法測定防污塗料中殺菌劑的釋放率
  6. Methods for the coal flotation test by progressive release in coal separation lab

    選煤實驗室分步釋放浮選試驗方法
  7. The enzyme - linked immunosorbent assay ( elisa ) and high performance liquid chro - matography ( hplc ) analysis for detection of mc were optimized. the removal rates of mc by conventional water treatment processes were investigated through the laboratory study and the detection of mc in every process in meiyuan drinking water treatment plant. results showed that the prechlorination of eutrophic water led to the release of intracellular toxins to water phase

    本文完善了mc的elisa和hplc分析方法，通過模擬試驗及水廠實測調查了富營養化太湖水中mc在常規凈水工藝中的去除特性，結果表明預氯化使藻細胞內的mc釋放出來，混凝沉澱對細胞外mc無去除作用，砂濾可去除17 . 2 40 . 4的細胞外mc和19 . 0 36 . 6的總mc ，加氯消毒對細胞外mc和總mc的去除率分別為30 45 . 3和30 51 . 7 。
  8. Ical. reaction to fire tests - determination of fire parameters of materials, products and assemblies using an intermediate scale heat release calorimeter

    燃燒試驗的反應.使用中間刻度的熱釋放卡路里儀
  9. Finally, an energy approach is combined with the fem in the simulation of the crack propagation along the fiber / matrix interface in a pull out process. the simulated results are in nice conformity with experimental results. the second part of the research deals with the characterization of the failure process in the fragmentation tests, which is one of the most frequently used test methods in studying thermal mechanical properties of fiber / matrix interfaces

    在這一部分工作的最後，採用能量法與有限元法結合起來，模擬纖維抽拔試驗中裂紋的擴展:針對以往研究工作中的不足之處，在模擬中使用能量釋放率，在表徵界面破壞時，所使用的應力強度因子考慮了纖維和基體兩種材料的不同屬性，並考慮裂紋尖端的單元奇異性，來研究裂紋長度和溫度對裂紋擴展的影響。
  10. Test showed that under level loads the damage process of multi - ribber slab was according to the order of silice bric ^ concrete frame ^ outer gimbal, released energy classificately, had perfect energy consume and anti - collapse capacity

    試驗表明密肋復合墻板在水平荷載作用下破壞過程按「砌塊，框格，外框」的順序進行，能夠分級釋放能量，表現出了良好的耗能能力及抗倒塌能力。
  11. Standard test method for heat and visible smoke release rates for materials and products using an oxygen consumption calorimeter

    利用氧消耗熱量儀測定材料和產品的熱和可見煙霧釋放速率的標準試驗方法
  12. Standard test method for accelerated leach test for diffusive releases from solidified waste and a computer program to model diffusive, fractional leaching from cylindrical waste forms

    固化廢料中擴散釋放物加速浸出試驗，模型擴散的計算機程序和從圓柱形廢料狀態中分離淋濾的標準試驗方法
  13. Standard test method for size - differentiated counting of particles and fibers released from clean room wipers using optical and scanning electron microscopy

    利用光電子顯微鏡和掃描電子顯微鏡對清潔室擦刷工具釋放粒子和纖維的尺寸差異計數的標準試驗方法
  14. The research suggests that the failure process of the multi - ribbed composite walls under horizontal seismic loads is : the cracks of the infilled silicate bricks and the cracks of the inner rib beams and rib columns - the cracks of the outer frames ; and that the walls can release energy by stages, showing perfect capacities of energy dissipation and collapse resistance

    研究表明：復合墻板在水平地震力作用下，其破壞過程按「填充砌塊?肋梁肋柱?外框架」的順序進行，分級釋放能量；試驗中墻板大部分發生剪切滑移破壞；墻板的平均抗剪承載力、延性指標、耗能及抗倒塌能力明顯優于組合磚墻。
  15. Building products. determination of the emission of volatile organic compounds. emission test cell method

    建築產品.揮發性有機化合物釋放量的測定.釋放試驗槽法
  16. Towing hook electric release test and load test also shall be carried out

    進行拖鉤電動釋放試驗和拖鉤的負荷試驗。
  17. Building products. determination of the emission of volatile organic compounds. emission test chamber method

    建築產品.揮發性有機化合物釋放量的測定.釋放試驗室法
  18. Standard practice for stress relaxation testing of raw rubber, unvulcanized rubber compounds, and thermoplastic elastomers

    生橡膠非硫化橡膠和熱塑彈性物的應力釋放試驗用標準實施規程
  19. Water quality - evaluation of ultimate aerobic biodegradability of arganic compounds in aqueous medium - caebon dioxide evolution test

    水質.水介質中有機化合物的極限需氧生物降解能力的評價.二氧化碳釋放試驗
  20. By the test system of the landing ladder on the earth which releases by an elastical structure, measure the acceleration of the ladder in the chosen directions in the process of releasing

    最後，加工著陸梯和實驗平臺，搭建合理的測試系統。對彈出式著陸梯在地面環境進行釋放試驗，觀察著陸梯釋放的情況，測量著陸梯彈出過程中選定方向的加速度。
分享友人
分享到 Line

分享到臉書