量塊 的英文怎麼說

中文拼音 [liángkuāi]
量塊 英文
block gage
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 塊 : 名詞（古時佩帶的玉器） penannular jade ring （worn as an ornament in ancient china）
  1. Specification for gauge blocks and accessories - accessories

    量塊和附件規范.第2部分:附件
  2. Specification for gauge blocks and accessories - gauge blocks in use

    量塊和附件規范.第3部分:使用中的量塊
  3. Verification regulation of gauge blocks

    量塊檢定規程
  4. Angle gauge block and accesories

    角度量塊及其附件
  5. The survey and developing trend on the gauge block measurement technology in china

    我國量塊計量技術概況與發展趨勢
  6. Gauge block interferometers

    量塊光波干涉儀
  7. Test method of gauge blocks

    量塊檢驗方法
  8. Accessories for gauge blocks

    量塊附件
  9. Helicopter is hard to hover precisely for its bad stability. ordinarily, it is improved by flight control system, such like rotorcraft unmanned aerial vehicles which use bell bar or bell - hiller stabilizer bar. bell stabilizer bar, fixed across with teetering main rotor, consists of a bar and masses at two ends

    貝爾穩定桿由一桿與兩質量塊組成，它與貝爾直升機的蹺蹺板旋翼垂直交叉放置，這種旋翼裝置有助於加大角速度阻尼，改善貝爾直升機的穩定性，但同時也降低了操作性。
  10. Synthesis of starlike low - aspect - ratio block molecules

    星形低分子量塊狀化合物的合成
  11. 4. a novel three spring - mass structure is designed to close off the cross - axis coupling, the simplified dynamics model of which is worked out

    4 .針對機械耦合誤差，提出了一種隔離耦合的三質量塊結構，建立了該結構的簡化動力學模型。
  12. This setting could increase the damping of angular rates and improve the stability. based on bell stabilizer bar, bell - hiller stabilizer bar adds small wing on the two ends of bar. compared with main blades the aerodynamic forces and moments generated by the bar could be neglected

    希勒伺服旋翼在貝爾穩定桿的基礎上，于兩個質量塊處添加了小翼，與貝爾穩定桿相比，希勒伺服旋翼自身的揮舞運動藉助機械耦合引起旋翼二次變距，起到改善操縱性的作用。
  13. In precision length measurement, the environmental factors will not only cause the length variation of the measured object, but also influence the characteristic of laser ’ s measurement system and other metrical tools. thereby the measurement result is considerably influenced and it makes the precise measurement no sense

    在精密長度測量中，測量環境溫度的變化不但會使被測件的長度發生變化，而且還會影響激光測量系統，量塊等測量工具的特性參數，給測量結果造成較大的影響，使精密測量失去意義。
  14. The accelerometer which has simple fabricated process and high sensitivity and small parasitic capacitance and residual stress is hybrid integrated with the interface circuit using ic nude chip. so the density of the package is increased, and the noise of the sensing system is decreased. these found the base of capacitive accelerometer module using the mcm method

    該傳感器製作工藝簡單，靈敏度高，支撐梁採用u型，減小了刻蝕后的殘余應力，用玻璃作為襯底，減小了襯底和硅可動質量塊間的寄生電容，且把傳感器晶元和用ic裸片製作的介面電路集成在一起，提高了封裝密度，減小了傳感器系統的噪聲，為採用mcm技術製作電容式加速度傳感器模塊打下了基礎。
  15. By means of the theoretical analysis of the micromachined vibratory rate gyroscope, we get following conclusions : the microgyroscope can be driven by tangent electrostatic force produced by fence structure electrodes, and the normal electrostatic force can be neglected for the influence of the device property ; the parasitical capacitance and fringing effect can ’ t be neglected for the calculating of the detection capacitance ; the coefficient of damping force is comparatively little when the air damping in the driving mode and the sensing mode of the device is the couette flow damping

    主要內容如下: 1 .分析了微機械陀螺的運動特性、靜電驅動特性和在大氣下的阻尼特性，分析結果表明，可以運用切向靜電力驅動質量塊振動，法向靜電力對器件特性的影響可以忽略;在計算微結構電容時，電容的邊緣效應和寄生電容不可忽略;在器件所受阻尼主要為庫埃特流阻尼的情況下，阻尼力系數較小。
  16. 20 50 calibration of gage blocks by contact comparison methods through 20 in. and 500 mm

    用接觸式比較方法核準量塊
  17. The optimeter is widely used to precisely measure external size of workpiece by comparison with a gauge block or standard part

    本儀器是一般是用標準器（如量塊）以比較法測量工件的尺寸。
  18. Speed of mass driven by random thrust and dryfraction dumping

    作用有干摩擦阻尼的質量塊受隨機推力時的速度分析
  19. To measure the straightness, erect the workpiece on the measuring block placed on the surface plate

    測量直線度時，將工件豎放在放置於平板上的測量塊上。
  20. The sky will fall down to block energy supplies and ammunition

    天上會掉下來能量塊和彈藥的補給。
分享友人
分享到 Line

分享到臉書