量程 的英文怎麼說

中文拼音 [liángchéng]
量程 英文
measurement range; measuring range; span
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  1. The dc ammeter will normally be calibrated at full range in each range

    直流電流表一般每程均作全量程校正。
  2. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導，對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計，對主噴嘴和測量噴嘴的不同組合，將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計，並通過實驗驗證了理論推導，從而使氣動測量系統量程的示值范圍達到40 m ，靈敏度達到100mv m ，解析度達到0 . 05 m ，測量不確定度小於0 . 2 m ，滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  3. For single - range voltmeters, calibration will be made at cardinal points ( maximum 5 points )

    單量程電壓表將就其基點進行校正（最多不超過五點） 。
  4. For single - range voltmeters, calibration will be made at cardinal points ( normally not exceeding 5 points )

    單量程電壓表將按主要基點進行校正（一般最多不超過五點） 。
  5. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  6. See the standard range table for wide plus ct series

    見wideplus - ct系列標準量程表
  7. Flatness sinewave relative to 1 khz, autorange

    平坦度相對於1khz正弦波，自動量程
  8. The range is usually limited to the full-scale deflection of the indicator.

    量程通常以指針的全分度偏轉為限。
  9. The extension of the mechanical high pressure measuring instrument in the chemical system of units to a top measuring value of 10 kbar is the result of consistent further development of the successful high pressure instrument programme

    憑借著我們在高壓儀器項目中斷深入研發，我們可向客戶提供更廣量程適用於單元化學系統機械式高壓測量儀器，最高可達千巴
  10. The 1mhz fixed frequency switching allows for tiny external components and the regulation scheme is optimized to ensure low emi and low input ripple. an external resistor sets the full - scale led current, while two digital inputs control on / off and select amongst three levels of brightness. the circuit operates in 1x mode until just above dropout

    工作在1mhz固定頻率，採用線性調制模式使輸入紋波大大減小;利用一個外部電阻可以設置滿量程led電流;外接兩個數字信號控制晶元開關並選擇led三級亮度中的一級;具有過溫、過壓/欠壓等保護功能，工作溫度范圍為- 40 + 85 。
  11. Vibration influence except minim scale

    振動影響微量程除外
  12. Fibre optic interconnecting devices and passive components. basic test and measurement procedures. part 2 - 16 : tests. moult growth

    光纖互連裝置和無源元件.基本試驗和測量程序.第2 - 16部分:試驗.脫皮增大
  13. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - cable nutation

    光纖互聯裝置和無源部件.基本試驗和測量程序.第2部分第35節:試驗.電纜下垂
  14. Fibres optic interconnecting devices and passive components. basic test and measurements procedures. part 2 - 35 : tests. cable nutation

    光纖互連裝置和無源元件.基本試驗和測量程序.第2 - 35部分:試驗.電纜章動
  15. This paper discuss the accelerometer base on mutual inductance variety for filling up the blank in silicon accelerometer of home, boosting up the onrush of weapon, improving the precision of navigation system is very importance, at one time, for taping the big measure rang accelerometer provide a new technology approach

    本文論述的基於互感變化的硅加速度計對于填補國內硅加速度計空白，增強武器的突防能力，提高慣導系統的精確性是非常重要的，同時為開發大量程加速度計提供了新的技術途徑。
  16. Measuring procedure of photovoltaic system performance

    光電系統性能的測量程序
  17. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - examinations and measurements - attenuation of random mated connectors

    光纖互連設備和無源元件.基本試驗和測量程序.檢驗和測量.隨機配合連接器的衰變
  18. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 3 - 34 : examinations and measurements - attenuation of random mated connectors

    纖維光學互連器件和無源器件基本試驗和測量程序第3 - 34部分：檢查和測量隨機配接連接器的衰減
  19. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 3 - 34 : examinations and measurements ; attenuation of random mated connectors

    纖維光學互連器件和無源元件.基本試驗和測量程序.第3 - 34部分:檢查和測量.隨機插合連接器的衰減
  20. The calibration is usually made at full range setting for each range

    一般每量程均作全量程定位校正。
分享友人
分享到 Line

分享到臉書