量綱分析 的英文怎麼說

中文拼音 [liánggāngfēnxī]
量綱分析 英文
demensional amalysis
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 綱 : Ⅰ名詞1 （提網的總繩 多用於比喻） the headrope of a fishing net 2 （比喻事物最主要的部分） key lin...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. By the result of these experiments, acoustic emission ( ae ) was chosen to use in the research. at the same time, we analyse the phenomenon of acoustic emission at the base of theory, the characteristic signal of acoustic emission which comes from the faulty bearing at the angle of application, and the expression of the characteristic signal. contrast was also made on the data achieved separately from vibrational signal and ae signal, and it is proved that ae is feasible and available to the diagnosis to the fault of the rolling bearing

    主要工作有如下幾方面：對本段前期實驗室階段採用的振動法幅值域無量綱處理進行了分析，並研製了現場所使用的滾動軸承故障檢測裝置，將無量綱參數診斷法應用於段修現場，且做了大量試驗；對于現場試驗中所出現的問題進行了分析，提出將聲發射的方法用於軸承的在線故障診斷；從理論上分析了聲發射現象，從應用的角度分析故障軸承的聲發射信號的特徵以及聲發射信號特徵的表示方法，並在實驗室中，採用振動法和聲發射法實時檢測的實驗數據進行了對比和分析，證明了使用聲發射法對軸承故障檢測的可行性和有效性。
  2. According to the theory of dimension analysis, the basic thoughts and methods of dimension analysis modeling in the direction of practical engineering prblems are explored

    摘要在量綱分析理論的基礎上，結合工程實際問題研究了量綱分析建模的基本思路和方法。
  3. The tank model with scale of 1 : 5 is built and model test is carried out. by dimension analysis, resemblance between archetype and model is confirmed. 2

    設計製作了比例系數為1 ： 5的罐體結構模型；通過對影響平臺罐體受力狀態的各主要物理量的量綱分析，確定了模型與原型結構的相似性；並進行了模型試驗。
  4. Abstract : this paper introduces the buckingham ' s theorem on dimension analysis and proves it by using method of linear algebra. the application of the buckingham ' s theorem is demonstrated by two examples

    文摘:介紹了量綱分析中的白金漢定理，並且線性代數的方法予以了證明，通過兩則例子說明了該定理的應用。
  5. Simulation model of laser bending process has been established by dimension analysis with the control model of laser bending achieved based on regression of laboratory simulate data

    通過量綱分析建立了板料激光彎曲過程中彎曲角度的模擬模型，根據試驗數據對模型的相應參數進行回歸求解，獲得了該過程的控制模型。
  6. At the same time, according to the similarity theory and dimension analysis, this research has accomplished the heat convection experiment, and has gotten the calculation method of heat convection coefficient of drum brake

    並在相似理論和量綱分析理論的指導下，進行鼓式制動器對流換熱實驗，得出鼓式制動器對流換熱系數的求解公式。
  7. It was shown that the dimension analysis was an effective method in simulating the complex laser bending process, and the control model that came from non - dimensional group data of simulations, was a high - accuracy model in predictive analysis

    研究結果表明，利用量綱分析法模擬復雜的激光彎曲過程是簡便有效的，基於模擬模型無因交次群組合的設計相應的參數可使控制模型達到較高的預測精度。
  8. Dimensional analysis of the collection coefficient wire covered by ice

    導線覆冰時收集系數的量綱分析
  9. The existed material fatigue performance test curves are dealt with and analyzed, and the non - dimensional stress - strain curve, tangent modulus factor curve and fatigue life curve are drawn based on the experiment data, and these three non - dimensional parameter curves are used to find the inherent rules that the test curves can be replaced each other to some extent. it can be concluded that if the common character and system error of these materials are found, the test curve of a certain material can be used for reference by another material. this is a simple approach about fatigue life estimate and is engineering practical

    對已有的材料力學疲勞性能試驗曲線進行分析整理，利用試驗數據繪制了相對應力應變曲線、切線模量因子曲線和疲勞壽命曲線，利用這三種無量綱參數曲線發現了其中存在的規律性，即在某種程度上實驗曲線可以互相取代，並用試驗數據對此進行了討論，並由此推斷，如果找出材料彼此的共性或彼此之間的系統誤差就可以將一種材料的試驗曲線供其它材料參考使用，這是一種估算材料的疲勞壽命的簡便方法，對工程而言具有實用性。
  10. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  11. Analysis and application of dimension

    量綱分析及其應用
  12. The analogical ratio between scale models with less ballast and their prototypes are provided by the dimensional analysis

    摘要採用量綱分析法，推導在配重不足條件下模型和原型的相似關系。
  13. In this paper, the method of dimensional analysis is used to analyze the interaction between ocean current, pipeline and seabed, and the similarity laws that should be followed in the small - scale laboratory experiments are established

    文章應用量綱分析方法對海流、管道與海床之間的動力耦合作用進行了分析，確定了在實驗模擬中應遵循的相似準則。
  14. The method of correcting pulse width, which is in accord with the traditional correcting pressure method, is discussed. the polynomial correcting formula and the pressure correcting formula by means of dimensional analysis and similarity theory are obtained

    探討了符合我國傳統壓力修正方法的脈寬修正方法，並建立了相應的多項式修正公式和由量綱分析及相似理論獲得的壓力修正公式。
  15. Based on the data on scour around large diameter cylinders exposed to waves and currents, effects of every kind of sea enviromental parameters on maximum scour depth are analyzed and guided by dimensional analysis and multidimensional linear regression, an equation is given to compute maximum scour depth around large diameter cylinders in combined waves and currents. compared with some other equations, this equation is more accrete, simpler and clearer and the compute d results are in good agreement with experimental ones

    本論文主要是在總結國內外研究成果基礎上，從波浪與水流共同作用下海床上直立大直徑圓柱建築物周圍的局部沖刷機理出發，研究和探討了圓柱周圍的沖淤形態；分析各種海洋環境參數對最大沖刷深度的影響，並利用已取得的實驗資料，採用量綱分析原理和多元線性回歸分析方法，建立一個波流共同作用下海床上直立大直徑圓柱建築物周圍的最大沖刷深度計算公式。
  16. In this paper, charge calculating formulas and their relations of cutting chamber loose blasting are firstly analyzed with the theories of dimension, fluid dynamics. explosive dynamics, etc and the significance of the explosive factor in it is pointed out. calculating methods of the explosive factor are researched by law of conservation of energy, and then a new one is brought forward which proves to be rational and reliable by a sample

    本文首先採用量綱分析、流體動力學、功能平衡理論、爆炸動力學等理論，分析了路塹硐室松動爆破裝藥量計算公式及其內在聯系，並指出k值在現有藥量計算公式中的重要性；在分析現有k缺陷的基礎上，利用能量守恆原理，研究了路塹硐室松動爆破單位炸藥消耗量計算方法，並提出一種新的k值計算方法，實例驗證本方法合理、可靠，優于其它k值計算方法。
  17. In addition, the thesis has gained a little innovative achievements which are differ from other scholars, such as classifying the carrying objects of environmental carrying capacity, establishing the index system of environmental carrying capacity, unifying dimentions, modifying the initial coefficients and making use of hierarchy and vector analytical method to analyze environmental carrying capacity quantificationally

    本文在環境承載力承載對象的分類、環境承載力指標體系的構建、統一量綱的方法、初始權重的修正以及採用層次矢量分析法量化研究環境承載力等方面進行了不同於其他學者的新嘗試。
  18. To have a further study of the new type soft subgrade reinforcing system of geocell reinforced gravel mattress and gravel pile composite foundation of its mechanism of load capacity and settlement development, three comparative model tests were designed and carried out under the direction of similarity theory and similarity criterions deduced through dimension analysis method

    摘要為深入研究土工格室碎石墊層碎石樁復合地基這一新型多元復合地基加固體系的承載力和沉降變形機理，應用量綱分析法推導了土工格室碎石墊層碎石樁復合地基模型試驗的相似準則，根據相似理論設計和完成了3組具有可比性的模型試驗，獲得大量荷載沉降、樁土應力比和應力分佈數據。
  19. Through discuss the dimension notion and the the basic theories of dimensional analysis, use the example explained the dimensional analysis in the electromagne theory, and point out the dimensional theory analyse concrete problem to needs the problem of the consideration

    摘要通過對量綱概念及量綱分析基本理論的分析討論，用實例解釋了量綱分析在電磁理論中的應用，並指出應用量綱理論分析具體問題時需考慮的因素。
  20. Use the similitude theory the author calculated uncompress fluid flowing in the stationary diameter pipeline, carrying on dimensional analysis and similitude theory counts, designed long - huge highway tunnel ventilationg model, constructing build the highway tunnel ventilation simulated test terrace

    利用相似理論對不可壓縮流體在水平等直徑管道中的定常流動進行量綱分析和相似理論計算，設計長大公路隧道通風模型，構建了長大公路隧道通風模擬試驗平臺。
分享友人
分享到 Line

分享到臉書