鈦酸酯 的英文怎麼說

中文拼音 [tàisuānzhǐ]
鈦酸酯 英文
titanate
  • : 名詞[化學] (金屬元素) titanium (ti)
  • : 酸構詞成分。
  • : 名詞[化學] (有機化合物的一類) ester
  1. The preparation method of methyl 1 - naphthylacetate catalyzed by sulphuric acid, hydrochloric acid, chlorosulfonic acid, p - toluene sulfonic acid, amino sulfonic acid, strongly acidic cationic exchange resin, ferric chloride hexahydrate, stannic chloride pentahydrate, aluminium chloride, ferric sulfate, aluminium sulfate, titanium sulfate, sodium bisulfate monohydrate, solid super acid, heterpoly acid, support heterpoly acid, composite titanate and p - toluene sulfo - chloride etc. catalyst were reviewed

    摘要評述了硫、鹽、氯磺、對甲苯磺、氨基磺、強性陽離子交換樹脂、六水三氯化鐵、五水四氯化錫、三氯化鋁、硫鐵、硫鋁、硫、一水硫氫鈉、固體超強、雜多、固載雜多、復合鈦酸酯和對甲苯磺酰氯等催化劑催化合成1 -萘乙的方法。
  2. Surface roughness of coatings affects the bioacitivity of materials, in order to change the roughness of coatings, the granularity of coating powders was changed firstly. nanometeral anatase titanium dioxide powders were prepared by hydrolysis of titanium - tetrabutoxide with ethanol in this paper. the main particle size is between 5nm and 10nm, while the size of ordinary titanium dioxide powders is about 100nm

    為了改變塗層表面的粗糙度,實驗中從改變塗層粉末的粒度入手,以為原料,通過醇鹽水解法制備了納米級銳礦型tio _ 2超細粉,粒徑約為5 10nm ,而普通二氧化粉體的粒徑多在100nm左右。
  3. The droplet size was found though the experience formulae and experience methods

    根據經驗公式及實驗方法計算了溶液的霧化粒徑。
  4. The hydrolysis reaction of tetrabutyl titanate in adsorption was special because the reactor was nanophase, the mechanics of hydrolysis reaction had three characteristics : ( 1 ) the hydrolysis reaction rate of tetrabutyl titanate was small ; ( 2 ) the hydrolysis reaction in adsorption layer had three process, the influence of temperature on the last two process was small and different ; ( 3 ) the diffusion rate was the most insensitive to temperature

    吸附相反應技術中使用的反應器是納米級的吸附層,因而吸附層中的水解反應也與傳統的液相法有著不同的機理:水解反應的速率較小;吸附層的水解反應分成三個階段,后兩個反應對溫度都不敏感且敏感性也不同;擴散速率對溫度的敏感性最小。
  5. The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size

    本文以為前驅體,利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料,通過正交實驗研究了醇鹽的濃度、溶劑的種類、水含量、水解溫度、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。
  6. This paper proposed a convenient way for producing disulfides, along which disulfides can be readily prepared in moderate to good yields via the reduction of alkylthiocyanates by the low - valent titanium reagent in thf at 0

    在四氫呋喃、 0反應條件下,低價試劑能容易地還原硫氰生成相應的二硫化物,得到中等至良好的產率
  7. Titanic acid ester coupling agent series

    鈦酸酯偶聯劑系列
  8. The silver doped tio2 or sio2 sols are prepared through sol - gel method, ti ( oc4h9 ) 4 and si ( oc2hs ) 4 are chosen as precursors respectively, and hnos is catalyzer, agno3 is the second component for inducting silver ion

    實驗分別以和正硅為先驅劑,硝為催化劑,硝銀引入銀離子,以溶膠?凝膠法配製摻銀tio _ 2 、 sio _ 2溶膠。
  9. The fixing performance of teos / tbb blend sol and the effect of fixing conditions were discussed

    討論了正矽溶膠和溶膠混合溶膠的固色效果及固色工藝對固色效果的影響。
  10. Furthermore, we compared the mechanical properties between the modified nano - cac03 / pp and unmodified nano - cac03 / pp. we have investigated the composites by means of mechanical testing, dsc, xrd, ft - ir, tem, sem, etc. the relation between the structure and property of the composites has been discussed in this thesis. we studied the nano - particles by means of ls particles size analysis, we also studied the modified nano - cac03 by means of ft - ir

    論文中對caco _ 3粒子進行了粒度與比表面測試分析,對經鈦酸酯偶聯劑表面改性的納米caco _ 3粒子進行了紅外吸收光譜分析,對改性后的復合材料進行了力學性能測試、差熱掃描量熱分析、 x射線衍射譜、紅外吸收光譜、透射電鏡、掃描電鏡等分析,討論了樣品中結構和性能之間的關系。
  11. Two phases atomizing nozzle and parallel board electrostatic precipitator were designed. ti02 powders were synthesized by plasma spraying with ethanol solution of butyl titanate as liquid feedstock on the optimized parameters

    對等離子噴塗工藝進行了優化,使用噴霧裂解法,以的乙醇溶液作為噴塗原料,成功的合成了納米tio _ 2顆粒。
  12. Titanate coupling agent

    鈦酸酯偶聯劑
  13. Improvement of conductivity is more distinct, for example, titanate coupling agent and stearic acid decrease its composite ' s room temperature resistivity 10l - - 102 times, as cb content is 15 % ( w / w )

    在導電性能上表現更為明顯,如鈦酸酯偶聯劑和的硬脂在炭黑含量為15時,可使材料的電阻率降低1 2個數量級。
  14. The results show that the dispersibility of nono - particles become excellent after treated with 3wt % coupling agent of titanic ester, the average dimension of treated nono - particles in uhmwpe fibers is about 50nm, and no big agglomerated particles occur in it

    實驗表明經過3wt鈦酸酯偶聯劑處理的納米粒子的分散性最佳,處理后納米粒子在uhmwpe纖維基體中的平均尺寸為50nm左右,基本沒有大的團聚體存在。
  15. In this thesis two kinds of coupling agents and maleic anhydride ( mah ) grafted polypropylene ( pp - g - mah ) were employed to act as interface compatibilizers for pp / nano - sio2. master batches from pp ( 90 ), nano - sio2 ( 10 ) and coupling agent ( 1 ) were prepared by twin - screw extruder firstly

    本課題選用硅烷偶聯劑、鈦酸酯偶聯劑以及自製的馬來酐接枝聚丙烯作為pp sio _ 2復合體系的界面增容劑,採用母粒法擠出工藝制備了改性pp 。
  16. In this thesis, the stearic acid and titanate - coupling agent were used to modify the surface of aragonite whisker. the ir - spectrograph analysis and the suspending - experiment showed that the two ingredients were effective to modify the aragonite whisker, and the titanate - coupling agent was better than stearic acid

    紅外光譜儀分析和懸浮實驗表明二者均能有效地對文石相碳鈣晶須實行改性,且達到完全改性時鈦酸酯用量少於硬
  17. In this thesis we have studied the toughening and strengthing modifications of polypropylene ( pp ) by nano - particle such as cac03 ) si02 and ti02. the performance of modified polypropylene and the modifying mechanism have been introduced. we have also explored the furthest dosage of titanate coupling agent in cac03 / pp and the influence of coupling agent to the composites by the determination of the mechanical properties

    本課題主要研究納米caco _ 3 、 sio _ 2和tio _ 2粉體改性聚丙烯( pp )后材料的力學性能及其增強機理,同時還對鈦酸酯偶聯劑改性納米caco _ 3粒子的最佳含量以及偶聯劑的加入對復合材料的力學性能的影響進行了研究,並對納米caco _ 3粒子和微米caco _ 3粒子分別填充pp的力學性能進行了比較分析。
  18. After surface modification of zno nanoparticles by titance coupling agent, the product were more dispersed because their surface were associated with organics anion. the effects of the dosage of titance coupling agent on surface modification of zno nanoparticles were studied, the optimal dosage of titance coupling agent ( 9 % ) have been investigated

    本文對制備出的納米氧化鋅用鈦酸酯偶聯劑進行表面改性處理,在納米氧化鋅表面形成有機結構,得到更為分散的粉體。實驗中考察了不同用量對改性效果的影響,得到了本實驗條件下的較佳用量9 。
  19. Particle size distributing and the composing of crystal phase were discussed by the orthogonalizing design. the experiments showed that the most suitable process conditions should controlled as follows : process temperature was about 30c ; the ratio of tnb " water and solvent was l : 4 : l 0 : the calcined temperature was about 600 " c. such transition metal ions as fe3 +

    實驗表明,合適的反應條件是:以醋為負催化劑,水解溫度應控制在30左右,與水量、溶劑量的配比應為1 : 4 : 10 。另外得到比較單一的銳型tio _ 2煅燒溫度應控制在600左右。
  20. Chapter 3 degradation of crystal violet using nanometer tio2 under the synergistic action of h2o2 and ultrasonic wave tio2 nanoparticles with different phases are prepared by hydrolysis of titanium tetrabutoxide in the presence of hc1

    第三章超聲波與h _ 2o _ 2協同納米tio _ 2光催化降解結晶紫本文採用稀鹽為水解抑制劑,將水解制備出具有混合相的tio _ 2納米粒子。
分享友人