鉆井位置 的英文怎麼說

中文拼音 [zhēnjǐngwèizhì]
鉆井位置 英文
drilling position
  • 鉆 : 鉆Ⅰ名詞1. （打眼用的工具） drill; auger 2. （指鉆石） diamond; jewel Ⅱ動詞（用尖物在另一物體上轉動） drill; bore
  • 井 : Ⅰ名詞1 （從地面往下鑿成的能取水的深洞） well 2 （形狀像井的東西） sth in the shape of a well 3 （...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  1. When it has been decided where we are going to drill, we put up at the surface an oil derrick.

    決定了鉆孔位置后，我們就在地面上豎起井架。
  2. Kongxi buried hill shows following features in the seismic profiles : the structures are asymmetric. there is flexural syncline on the east side and a monocline on the west side. asymmetric repetition of stratigraphic units is present in the drill wells and the dips of beds and faults are gentle. the permo - carboniferous system of both sides almost lie in the same slope and the events of cambrian or upper proterozoic are continuous from east to west. the phenomenas suggest that kongxi buried hill could be a thrust belt been traced which consists of reverse faults. the imbricate faults mainly effect pre - jurassic strata. there are obvious angular unconformity between jurassic - cretaceous system and paleozoic involved deformation of thrust. the thrust front in some place has cut off the beds of jurassic - cretaceous system. the structural style of the thrust structure changes along the strike of the kongxi buried hill

    地震和鉆井資料揭露的孔西構造帶前第三系潛山的地質特徵可以歸納為：構造帶總體上不對稱構造帶內部有地層重復現象石炭二疊系地層的位置明顯高於兩側的同一地層的高度。用由34條向東傾斜的逆沖斷層組成的疊瓦扇構造模式能夠比較合理地解釋上述地質特徵。該帶向東傾斜的逆沖疊瓦狀斷層組主要影響前侏羅系地層，侏羅白堊系與捲入逆沖構造變形的古生界地層之間有明顯的角度不整合。
  3. In order to geosteering, log - geology model of target formation should be built according to logging data and the interpreting result of wells nearby. geosteering parameters model is created to build simulative curves. compared these curves with logging curves, the position and drilling direction of the bit can be found combined with the concrete geological situation

    要實現地質導向，首先要根據鄰井的測井資料及其解釋結果建立目標層測井地質模式，然後通過建立地質導向參數的預測模型構造相應的模擬曲線，將模擬曲線與實測曲線進行對比，結合具體地質情況，確定鉆頭在目標層中的位置及其鉆進方向，及時調整井眼軌跡，使其始終保持在目標層中物性最好的部位。
  4. This study made a conclusion ? amely in order to realize following the geological target while drilling, on the basis of making a better geological and drilling design for horizontal well, we must make full use of mwd, lwd and integrate logging to carry out lithfacy identifying in real time, the lwd interpretation and formation evaluation, to set up geological model of target formation, to select geosteering marked formation and compare simulative curves with lwd curves f to fix on the drilling direction of bit upper and declination, the position in target oil - gas layer, to revise borehole track in real time, to make it extend in reservoir better interval as possible

    研究認為，在做好水平井地質設計和鉆井設計的基礎上，要實現隨鉆跟蹤地質目標鉆井，必須充分利用隨鉆測量、隨鉆測井和錄井等資料，從實時巖性識別、隨鉆測井解釋和地層評價、目標層地質模型建立、導向標志層的選取及模擬曲線對比等方面入手，確定鉆頭上下傾鉆進方向及在目標層中的位置，以實時調整井眼軌跡，使其盡可能在儲層物性較好的部位延伸。
  5. This paper, based on normalizing well logging data while drilling and correcting depth into true vertical depth and calculating reservoir parameters and etc, combining the practical ease of mobei oilfield, extracted logging and geological pattern characteristic of target oil - gas formation and geosteering mark formation, and used bp neural network and regressive analysis to create predicting mode of geosteering parameter to build relevant contrast curve ; adopted geometry geosteering method to fix on die drilling direction of bit upper and declination, the position in reservoir, to judge the real drilling case. all finely solved the problem to follow the geological target while drilling for three horizontal well these methods improve the drilling horizontal well ability by using the techniques to follow the geological target while drilling, and then it is convenient and practicable

    本文在開展隨鉆測井資料的標準化和斜井校正及儲層參數解釋與含流體性質判釋等工作的基礎上，結合研究工區莫北油田的實際情況，提取了目標油（氣）層和導向標志層的測井地質模式特徵，並採用bp神經網路法和回歸分析法建立了地質導向參數的預測模型、構造了相應的對比曲線；採用幾何導向法確定鉆頭上下傾鉆進方向及其在目標層的位置，以判斷實際鉆進地層情況，很好地解決了研究工區三口水平井的隨鉆跟蹤地質目標的問題。
  6. Comparing the artesian well waste material that to autonomous prefecture churchyard unit of 3 oil field develops integratedly harmless change deal with the technology is pilot after the job develops a case, form following conclusion : what artesian well solid abandons is harmless change deal with the technology accords with the state council " watch the decision that reinforces environmental protection about fulfilling scientific progress " in " industry of positive development environmental protection, apply market mechanism to advance pollution to administer " wait for multinomial spirit, but resource conservation, reduce pollution, raise business economic benefits, the effect with environmental distinct benefit, in me the city already had the requirement that uses at real work, the proposal takes the lead by environmental protection branch, participate in next progressively promotion application what the unit of aptitude offers unit of technology, oil field directly

    在綜合比對自治州境內三家油田單位開展的鉆井廢物無害化處置技術試點工作開展情況之後，形成如下結論：鉆井固廢的無害化處置技術符合國務院「關于落實科學發展觀加強環境保護的決定」中「積極發展環保產業、運用市場機制推進污染治理」等多項精神，可節約資源、減少污染，提高企業經濟效益，環境效益顯著的作用，在我州已具備應用於實際工作的條件，建議由環保部門牽頭、有資質的單位提供技術、油田單位的直接參與下逐步推廣應用。
  7. Optimization analysis for the location of the compressive joint for the drilling shaft lining

    鉆井井壁可縮性接頭位置的優化分析
分享友人
分享到 Line

分享到臉書