鉆井循環 的英文怎麼說

中文拼音 [zhēnjǐngxúnhuán]
鉆井循環 英文
drilling cycle
  • : 鉆Ⅰ名詞1. (打眼用的工具) drill; auger 2. (指鉆石) diamond; jewel Ⅱ動詞(用尖物在另一物體上轉動) drill; bore
  • : Ⅰ名詞1 (從地面往下鑿成的能取水的深洞) well 2 (形狀像井的東西) sth in the shape of a well 3 (...
  • : 循動詞(遵守; 依照; 沿襲) follow; abide by
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • 循環 : circulate; circle; round; repeat; loop; period; recurrence; cycling; circulating; mixing; circula...
  1. The drill and petroleum extraction tools test - well is made up of the multifunction test - machine system ( hydraulic system ), the calefaction system the circulation system, the testing system and the assistant system

    采工具試驗共由多功能試驗機系統(液壓系統) 、加熱系統、系統、測試系統和輔助系統組成。
  2. In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore

    利用由作者提出的內流動和傳熱的三維數值模型計算所得的大量數據,文章對影響內溫度的諸多因素進行了較系統的敏感性分析,研究表明:液和地層等的熱物理參數以及液的入口溫度、排量等對內溫度有較大影響,因此,準確掌握所地區地層和液的熱物理參數值,考慮溫度壓力對熱物理參數的影響,準確測量液的入口溫度、排量等參數值,對于內溫度的準確模擬至關重要。
  3. Add 1 pound per barrel check - loss to the active system and drill ahead

    按每桶液加1磅切克勞斯的比例,加一個周,然後進。
  4. Model lb fishing cup is a practical and effective tool. during drilling operation, it can be used to recover the heavier drilling cuttings or metal chips which are difficult to be lifted out of the borehole by normal drillig fluid circulation

    它是用來撈取過程中正常的泥漿無法帶出眼的較重屑或金屬碎屑的一種實用有效的隨工具。
  5. Application of air - lift counter circulation boring procedure in geothermal heat shaft construction

    氣舉反工藝在地熱施工中的應用
  6. The machine can adopt positive and negative circulation and other deep drilling technique, adapts to various stratum, is the first selected equipment for foundation construction of river ' s bridge and dock, and also adapts to large diameter borehole construction such as tall building, coal mine vertical well and sewage well, it exerts great action many changjiang river large scale bridges foundation construction

    該機可採用正反進工藝施工,適合於各種地層,是江河橋梁、碼頭基礎施工的首選設備,也適用於高層建築、煤礦豎和污水等大口徑孔施工,在多座長江大型橋梁基礎施工中發揮了巨大作用。
  7. Series of mud solid control circulating system is a kind of new product which combines the advantage of the same type equipment and actual drilling requirements for various drilling rigs

    系列泥漿固控系統,是綜合了國內外同類產品的優點,結合各類型機的工藝的實際需要而設計製造的新產品。
  8. The optimization of underbalance pressure drilling cycle medium and casing program and the complicated circumstances ( formation water out, sidewall stabilization and so on ) being able to occur in underbalance pressure drilling job were analyzed and investigated

    在欠平衡鉆井循環介質的優選、身結構以及欠平衡作業中有可能出現的地層出水、壁穩定性等方面進行了分析和研究。
  9. Use active mud and add xcd polymer to 100 + viscosity. incorporate sweeps into the mud system

    把現有液的粘度加生物聚合物提到100秒以上,作為清掃液匯入系統。
  10. This drill adopts the deep drilling technique of positive and negative circulation, the efficiency of deep drilling is high, and applies to various stratum, is the first selected equipment for the basic construction of river bridge and dock, and also applies to drilling project of high building and heavy caliber shallow well

    該機採用正反進工藝,進效率高,適用於各種地層,是江河橋梁、碼頭基礎施工的首選設備,也適用於高層建築及大口徑淺水孔工程。
  11. In chapter three, in order to simulate the actual drilling fluid column pressure and to supply the extreme high pressure drilling circulating fluid for the device, the high pressure circulating fluid simulating system has been designed based on the experience of drilling fluid circulating system in the wellside. to purify the drilling fluid, the high pressure desander has been designed

    第三章為模擬實際的液柱壓力,並為整個模擬裝置提供超高壓液,在借鑒了現場的系統經驗的基礎上分析研究了液高壓系統,並配套設計了高壓除砂器,以達到凈化該系統中液的要求。
  12. Allow the pill to soak on bottom for 4 ~ 6 hours. add and maintain 2 pounds per barrel of check - loss to the active circulating system

    要讓這種堵漏劑在底滲透4 ~ 6小時,然後在系統中,再按每桶液加兩磅切克勞斯的比例加完,以便維護堵漏性能。
  13. 11 it is loss circulation, stop drilling, circulation

    發生漏,停止進,觀察。
分享友人